Question about Ford Contour

1 Answer

The rear of my 1996 ford contour sways right to left while driving.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 414 Answers

Your vehicle is "dogtracking", your best bet would be to take it in for
a 4 wheel alignment. Most legitimate places will give an estimate in writing.
This could even be from previous accident repairs if this vehicle was
purchased used.

Posted on Mar 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do I fix to stop left and right sway on my 1996 deville


shock absorbers and anti sway bar rubbers and mounts
if it occurs at slow speeds and is most noticeable at the rear
( like a duck wobble) check the rear tires for belt separation

Apr 18, 2017 | Cars & Trucks

1 Answer

Ford contour problem


Starting from right rear, left rear, right front , left front, engine off, have someone pump brake pedal 3-5 times and hold, open bleeder until steady stream of fluid runs out, close bleeder, repeat if bubbles are seen. Check fluid level after each wheel is bled so as not to run low and induce air. Top up after last wheel is bled ,start and drive and recheck for pull.

Dec 27, 2013 | Cars & Trucks

1 Answer

BENT THE RIGHT REAR AXLE ON MY 1996 FORD CONTOUR AND NEED TO KNOW HOW TO REPAIR IT


you don't repair it, you replace it. jack it up, remove the brakes, and all the brake assembly from that axle,, http://www.ehow.com/way_5731956_ford-rear-brake-replacement-instructions.html then remove the bearing cap,, cotter pin, and nut from the spindle , ( you might want to replace the wheel bearing at the same time due to the bad axle ) remove the axle bolts,, and shock bolts, from the axle beam. remove axle beam assembly

Sep 23, 2011 | 1996 Ford Contour

3 Answers

What are swey bars on a ford focus


A sway bar is a suspension piece that keeps the left and right side of vehicle connected to help with turns. They are held together through sway bar links at each end, which are fairly common to break or rattle over bumps.

Mar 27, 2011 | 2003 Ford Focus

1 Answer

Have a 1996 explorer sport with 200k. Daughter said the truck started to drive "like a boat tossing and turning" at highway speed. Front end was rebuilt not long ago. shocks seems fine and...


Yes this sounds like A sway bar condition and yes you can Replace just the links and bushings. I would not replace the sway bar its self unless that is infact what broke. I hope this helps you out. i would appreciate it if you would rate me.
thank you
Aaron

Nov 15, 2010 | 1996 Ford Explorer

1 Answer

Can not remove rear door liner in a 1996 Ford Contour. I need to replace electrical window.


if you have removed all the screws try pulling on the bottom of door panel and look behind panel some have push in type some have lift up panel to remove.

Sep 13, 2009 | 1996 Ford Contour

1 Answer

1996 ford f-150 rear end, loud thud usually when turning to the left or backing up while turning. ?


Look over the suspesion. You may have sway bar or leaf spring broken or loose.

Jul 05, 2009 | 2004 Ford F150

1 Answer

Where is the ignition module located on the 1996 ford contour?


tragik nc: In looking this car up in both the 4 and 6 cyl configurations, Ford said that the ignition control module is no longer a separate component. It is actually integrated into the PCM (power control module)
This is located in the right rear corner of the engine compartment behind the power steering reservoir.
Good Luck, mybunkey>>>>>>>>>>>>>>>>>

Apr 20, 2009 | 1996 Ford Contour

2 Answers

Spark plug firing order


If it is a 2.5L dohc motor the firing order is 1-4-2-5-3-6  cyls. numbers from left to right 4-5-6 in front and 1-2-3 in rear thats looking at the motor from the front of vehicle.

Nov 25, 2008 | 1996 Ford Contour

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...