Pontiac 2007 G6 GT drivers door will not open from the inside. How to repair.

mages for 2007 pontiac g6 gt hazard switch repair

It typically, should be incorporated in drivers side dash next to inside door panel or in dash below drivers side.

You need to pull the door panel off, this requires a special tool that reaches between the panel and the shell, then it pulls the fastener out. You then remove any screws that are in the arm rests and trim like pull handles on the inside. Then you can remove the panel. Once that is done you can see a plastic film that covers the door shell and working parts. Remove this. Then you need to remove the hardware that holds the window and associated activators. When that is done, you can access the inside of the door shell and remove the bolts that hold the door handle and put the new one on.

Fuse inside the trunk dummy

u need to buy a headlamp socket because pontiacs faulty wiring has a short that melts the part.... im replacing 1 right now... it sux

you stated that the fuse was good, but did you check the relays located in a black box on drivers side, under the hood.

Check the wiring on the headlight. You may have a damaged wire or bad ground.

if it was me i would be getting a hold of the company that install the glass for you it maybe the switches and the plugs for you speaker is loose wish you the best of luck Michigan Man

park lamp and license plate share same fuse.check park lamp fuse.if fuse good you have ground wire problems.

This car does not have a auto trans dipstick, the level can only be checked by the dealer, this is a growing trend that started with most German cars, the filter is inside the trans pan and only needs changing every 60,000 miles.