Question about Dodge Dynasty

1 Answer

1992 dynasty with V6,intermitly stalls warm/cold during city driving,sometimes starts right back sometimes have to let it sit for a few mins.then it starts,,,any sugestions??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,803 Answers

The most likely cause of that symptom is a failing Crakkshaft Position Sensor. It is not hard to fix. It is located in the transmission bell housing just behind the engine block and is held in by a single 10mm bolt. A new sensor should come with a locating "Dot". This is a stick-on piece of thick paper that you stick on the end of the sensor. This sets the proper gap between the sensor and the flywheel. (The flywheel simply knocks it off of the sensor when you start the engine.) To find it on the engine look at the transmission bell housing/engine area and look for the wire that connects to the sensor....It will be the only thing with a wire going into the bell housing. The sensor looks like the picture below. You don't even have to take the bolt all the way out. Just loosen it and slide the sensor mount up off of the bolt.


1992 dynasty with V6,intermitly stalls - dttech_7.jpg

Posted on Mar 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine cut out


Has anyone checked fuel pressure cold and hot ? Check engine light on ?

Sep 26, 2013 | Chevrolet Lumina Cars & Trucks

1 Answer

I have a 1992 dodge dakota 3.9l v6 when im driving the motor will just cut out. sometimes it will start right back up and sometimes it will take like 15 to 20 min before it starts back up. no check engine...


One way to confirm if it's a spark problem or fuel delivery problem is, when it quits and won't start, remove air intake hose at throttle body opening and spray some WD-40 ( 2-3 sec. ) into throttle body, then try to start. If it fires up momentarily then stalls again, have fuel pressure tested. The WD-40 acts like quick start and if that fires the engine over, then you have spark, but not enough or any fuel.
If that doesn't help, no start at all even with WD-40 sprayed in throttle body, then I'd think real serious about changing the hall effect pick-up ( pick-up coil) in distributor, if you have that style distributor. It is located under distributor cap below rotor, it looks like a round black plate in shape with wiring and connector at end of it. Remove cap, remove rotor, and lift it out, unplug from connector. Replace it in same position, then re-install rotor, then cap. They were a pretty common problem in earlier years. Engine would just quit anytime after it was warmed up, then sit for 15-20 minutes, then restart and go for a while and do it again.

Sep 03, 2011 | 1992 Dodge Dakota

2 Answers

Car stalls when driving


Take notes , when this happens.
For instance : engine warm or cold , outside conditions (cold , hot) , car driven for a while , long or short distance when problem occures etc.... , that may help for diagnosis.
It very well may be temperature relaited , sience it has to sit (cool off) for 5 min.
Ignition coils sometime do that.
I'm mechanic shop owner and intermittent problems are the hardest one , so any piece of iformation on above mentioned events may give a clue.
Good luck.
Greg.

Jul 14, 2010 | 1997 Mitsubishi Eclipse

1 Answer

Truck will not start


your fuel tank has water in it and in cold temps it surrounds the filter on the pump and ices over cause gasoline ges way colder than water

Jan 21, 2010 | 1992 GMC Sierra

1 Answer

STALLING


needs a new temperature sensor for the cold start

Jun 15, 2009 | 1994 Jaguar XJ6

2 Answers

1992 pontiac boneville, keeps stalling


Have you chg.fuel filter and had a fuel pressure test done? Does it have spark after it stalls? Fuel pumps are a common problem, they work when cold get warmed up they quit, after a while quit all together. Do the fuel pressure test.

May 05, 2009 | 1995 Pontiac Sunfire

2 Answers

I have a 93 cadillac deville and trouble starting


Check your IAC idle air control sensor. This is a sensor that makes sure that your car is getting the right amount of mixture with the fuel. It is located in the right back of the engine behine the intake. If this helped pleae rate

Feb 12, 2009 | 1992 Cadillac DeVille

1 Answer

1990 Dynasty Intermitent Fuel Pump


Does the pump cycle eventually if you keep cycling the key off/on, without trying to start the car ?

Sep 05, 2008 | 1993 Dodge Dynasty

1 Answer

1991 dodge dynasty v6 3.3


get rid of the dodge junk and get a ford

Aug 15, 2008 | 1991 Dodge Dynasty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...