Question about 1998 Cadillac Seville
Installed new fuel pump and fuel filter in 1998 cadillac seville engine turns over but will not start
Is there a check engine light ? I ran into this problem with other domestic brands, most common problem I found was the crank position sensor. PCM wasn't getting a signal from cps in turn not power the fuel pump. First thing I would do is check for DTC. If crank sensor shows good, you can unplug the pump and with a test light check power supply to the pump. You will either need to have some body cycle the ignition to the on position while you are checking for power or position the test light were you can get to it quickly while you cycle the ignition, reason being pump will only get power for a few seconds with out the engine running. The vehicle was in a rear end collision prior to this was it ? Some manufactures put an impact switch in the fuel circuit to shut off fuel in the event of an accident, but that was more of a Ford thing. GOOD LUCK
Posted on Jul 06, 2014
MAKE SURE YOU DID REPLACE FUEL PUMP WITH NEW SOCK.THE OLD PUMP SOCK IN THE TANK STOPPED UP.CHECK FUEL PUMP FUSE AND RELAY.
Posted on Mar 25, 2011
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Oct 14, 2013 | 1998 Cadillac Seville
May 21, 2012 | 1993 Cadillac Seville
Jul 09, 2011 | 1998 Cadillac Seville
Aug 16, 2010 | 1992 Cadillac Seville
Aug 04, 2009 | 1995 Cadillac Seville
Jul 05, 2014 | 1998 Cadillac Seville
304 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: