Question about Chevrolet Camaro

1 Answer

I wont to know its location on this vehicle - Camaro Chevrolet Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 1,498 Answers

Hi there,

My name is Mike. A couple times a day I go looking around to give some pointers to our clients (you). I do this so that your problem will be routed to an expert with a background in solving problems similar to your own.

With that in mind, look at it your question from our point of view, it's missing a few key ingredients.

We need a little more info. Like what 'IT' is and what vehicle 'IT' is on.

More is better:

To get to the right person, you will need to post your problem again with the Make, Model and Year of the vehicle. The category is important too. Try and find the make and model there also.

For future reference,
Describe your problem clearly, concisely and with as much detail as possible. Include recent events, is it new, used, has it ever worked, do people mess with it, etc. Anything that will help describe the problem.

Often, a problem can be the result of a seemingly unrelated event. It is always a good idea to include a recent history.

Additional information such as what steps have already been taken, has the product ever worked, is it new, etc. can have a bearing on providing the best solution for your particular circumstances.

Remember, you are a key participant in this process. We are not there, you are. We depend on you to be our eyes and ears. We can only respond to what you provide us. Without you, all our talent is worthless. How's that for an ego build?

What you get out of the experience depends on what you put in to it. So help us help you.

It would be also be advantageous in your case to repost your problem so that it is correctly categorized and starts over at the top of the queue. This way it can be directed to someone with expertise in the area you need.

Best regards

i wont to know its - e86b923.gif

Posted on Mar 24, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Engine starts but wont turn over. No spark to coil pack. No fault showing on computer.

What make an year vehicle do you have ? A faulty sensor could bring down the 5volt reference circuit in the PCM / ECM , causing no spark ,no crank . Does the check engine light come on when you turn the key on an go off after a few seconds ? Not trying to start the vehicle , just key in the on position . As far as the TDC sensor , need to know make , model an year vehicle . They put them in different places !

May 09, 2015 | Cars & Trucks

1 Answer

I have a1994 ford explorer and it wont stay started i change the fuel pump the crank the coil pack but it still wont stay started

I'm not familiar this vehicle, but hope this information is of some help, first of all is your vehicle diesel if so does it have a priming bulb inside the engine compartment if so is solid if your try to squeeze it if the answer is no get the ford stared dash to the compartment and pump the bulb till it's solid if that works until you manually stop the engine then I know what the problem is. not many people know this but actually inside the fuel tank is a primer pump that pressurises the fuel line up to the priming bulb to make it solid at all times. This may need replacing if what I said above is what your experiencing, the fuel primer pump is usually located from the top of the tank. as I said I'm not familiar with you vehicle so it's only a suggestion of the possible cause of your problem.

Good Luck.

Mar 16, 2015 | Ford Explorer Cars & Trucks

1 Answer

Domelight wont shutoff

First of all, what type of vehicle is it? But without knowing the vehicle type. You should check your door switches. Older vehicles had a small round plunger switch on each door frame. But newer vehicle now have a multifunction door assembly switch. You can attempt to unplug the switch. They are normally located near the door hinges and covered by a big flexible weatherproof rubber tube but at the end of the tube is a connector. Unplug it and see if the dome light goes off. I would try the driver door first. Because it gets used the most and is more likely to go out because of its use. Also check your dome override button if you have one. Hope this helps.

Nov 27, 2012 | Cars & Trucks

1 Answer

Console lights wont turn off 2009 torrent

Dont they turn off after a couple of minutes like a lot of vehicles if not then the timer/relay is faulty ,now where it is located i wouldnt know sorry not seen this car here in spain

Nov 17, 2012 | 2009 Pontiac Torrent

1 Answer

Cooling fan not working pontiac montana sv6 2005

Your electric fan should only kick on when the van tells it to. The way this is accomplished is by a sensor. I dont know where it is located on your vehicle specifically, but they are sometimes located in the radiator (common for aftermarket fan kits).

May 04, 2012 | 2005 Pontiac Montana SV6

1 Answer

Need to know location of code for keypad.

they are hidden throughout the vehicle and there is no one location. kinda need to know the type of vehicle., but you might be able to find it in the fuse panel... thats a typical location to find it.

Feb 21, 2011 | Ford Focus Cars & Trucks

2 Answers

I need to change my fuel filter but dont know wheres its located

once again, you need to help out with stuff like year/make/model

Jun 18, 2010 | Cars & Trucks

2 Answers

The screw that holds the sunroof to the arm that opens it came out and is out of alignment with the other side and wont close.

You will need to locate a replacement screw and reinstall it in the arm, Try looking for the screw on the interior of your vehicle, it could have fell in there, so all you nned to do is reinstall it. If your vehicle is still covered under Factory Warranty, go to the Dealer and have them repair it.

May 28, 2010 | 2006 Cadillac SRX

2 Answers

Need to know how to fix the speed sensor on a 1992 subaru legecy

the snsr is located on the right side of trans and can be viewed from the passenger side of vehicle looking down at trans from under the hood.

Apr 10, 2009 | 1991 Subaru Legacy

1 Answer

Wont stay idled

It is located on the top of the engine near where the throttle cable is located.You can purchase a repair Manuel with detailed instruction on you vehicle.Haynes or chilton repair manuals are around $25.

Aug 24, 2008 | 2002 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides