Question about 1993 Toyota Tercel

1 Answer

How to change the valve stem rubbers on a 1993 toyota tercel

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,911 Answers

Take it to a tire shop, you do not have the tools to break a tire down.

Posted on Mar 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No compression in one cylinder in a 1993 Toyota tercel


Could be a burnt valve or bad set of piston rings on that cylinder. Probably would be more feasible to replace the engine with a lower mileage one.

Feb 23, 2015 | 1993 Toyota Tercel

1 Answer

Where is the egr valve on a 96 toyota tercel


top of the tappet cover there is a rubber hose hooked to the egr valve that seats into the valve cover

Oct 01, 2014 | 1996 Toyota Tercel

1 Answer

1993 toyota tercel 5sp Manual 274000 km high


hi you can by cleaning produckt forthis.its also a good thing,
to messure when all filters and spark plugs are changed.
also the oil.using a cleaning produck can gif you some 5pk,
back.

Oct 18, 2013 | Toyota Tercel Cars & Trucks

1 Answer

I was looking for valve adjustment specs on my 1993 Toyota tercel 1.5L how to procedure


There are no valve adjustment specs as the valves are hydraulic controlled . If you have a noise it will be from faulty/worn followers .Or from worn rocker bushes and shafts

Sep 28, 2013 | 1993 Toyota Tercel

1 Answer

Leaking valve stem seals 1998 toyota tercel how to fix without removing the head


you cannot ,not on this type of engine ,if the seals are gone that bad then it most likely new guides as well

May 06, 2011 | 1998 Toyota Tercel

1 Answer

The car is switch off when i stopped and it produce sometimes a darck smoke


if it is High mileage , could possibly be Valve stem seals?

May 03, 2011 | 1993 Toyota Tercel

1 Answer

1993 toyota tercel 1 cylinder has low compression


There is no quick fix on low compression.
Less hope for a stick valve.
Do an oil change with 30 weight oil.
Ran it for few minutes and hope it's just a stuck valve.

Feb 15, 2011 | 1993 Toyota Tercel

1 Answer

I have a 1993 Toyota Paseo, which I have been told is almost mechanically identical to the 1993 Tercel. I think I there is a leak in the seal of the oil pan. Please give me instructions for replacing the...


Are you sure have a leak,? you saw it? they usually don't leak only from the valve cover gasket.
If you see oil drip by the passenger side of the oil pan the leak could be the crankshaft seal.
if the oil is in the center of the engine rear main seal is the problem.
If al around the oil pan is wet with oil but the oil do not make it to the floor, then the person who is doing the oil changes is not cleaning properly.

Jan 17, 2011 | 1993 Toyota Tercel

2 Answers

1993 TOYOTA TERCEL 1500cc Valve Seals Replaced now smokes much worse


You either have had the wrong valve seals installed, they are physically missing, or the valves are incorrect (too loose in the guides/stem too thin). The rocker arm seals will not contribute to your issue. If it did not have the oil smoke before you took the head off, the issue is with whatever the machine shop did. Valve seals have to fit TIGHT, or oil will go down the valve stem into the intake.
Take the head back to the machine shop & tell them to fix it. For free.

Aug 23, 2008 | 1993 Toyota Tercel

1 Answer

To change the oil pan gasket in a 93 Tercel


is not hard, i changed mine 95 tercel

Jul 22, 2008 | 1993 Toyota Tercel

Not finding what you are looking for?
1993 Toyota Tercel Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...