Question about Mercury Milan

1 Answer

I was told that I need a discharge sensor 2006 Mercury Milan. The AC blows but they said the sensor in the dash is not telling the AC to come on. But when I try to buy this part no one knows what that is?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 335 Answers

There are two sensors; Climate Control Sun Sensor located on the dash or rearview mirror, and an Ambient Air Temperature Sensor located by the climate control panel. I believe the one you're looking for will be the Ambient Air Temperature Sensor.

Posted on Mar 28, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2010 mercury milan is blowing hot air instead of cold and sometimes when on defrost it blows out the ac vents and when on heat blows out defrost vents. we have changed all fuses and sensors. Help.

Does the A/C compressor engage whe A/C is turned on ? Low on refrigerant ? These system are very complex an will set diagnostic trouble codes , you're best bet , take it to a qualified repair shop . There are fuse boxes an relay boxes hidden all over your vehicle , i 'd venture to say you didn't check all the fuse's !

Apr 28, 2017 | Mercury Cars & Trucks

2 Answers

Key stuck in ignition in park. Check charging system comes on. Dealership says it might be a fuse.

Key Stuck in Ford Fusion (2006 model) - YouTube

? 1:21
Jun 18, 2014 - Uploaded by Jessica East
#Ford #Fusion #Key #ignition #Stuck #FordFusion2006. ... i have a 2006 mercury milan and my key got stuck in there last night,... it to park with a little bit of force. will see what happens next time. good video, nice to know.

Key Stuck in Ignition While in Park
Dec 16, 2012 - KEY STUCK IN IGNITION / SHIFTER BINDING CONDITION FORD:2006-2007 Fusion LINCOLN: 2006 Zephyr MERCURY: 2006-2007 Milan

Nov 06, 2015 | 2006 Mercury Milan

1 Answer

How do i replace throttle body 2011 mercury milan

your car has a gas pedal accelerator it is a sensor on the gas pedal1_7_2013_3_51_23_pm.png

Jan 07, 2013 | 2006 Mercury Milan

1 Answer

I went to start my 2006 Mercury Milan this morning & it jus clicked. Got a jump from someone but i am not sure if it's the battery or starter, what should i do?

you need 2 get your battery tested any auto sparky will do it they can also check your starter only takes bout 5 mins

Sep 08, 2011 | 2006 Mercury Milan

1 Answer

Condensor is leaking into cab. Cannot find the drain tube in the engine compartment to try and clear it... Does anyone know where the drain is located?

  • The condenser won't leak in the cab. Do you mean the heater core? That would leak onto your floorboard if it's leaking. This is located behind the dash. The condenser is full of r134 refrigerant gas. If that's leaking then a discharge of the AC system and a repair would be needed.

  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 12, 2011 | 2007 Mercury Milan V6 AWD Sedan

1 Answer

How do I flush my 2006 mercury milan transmission?

You need a power flusher to accomplish flushing your transmission correctly. Have a shop do it for you, it's a very expensive tool and nit very cost effective for a DIY'r

Mar 28, 2011 | 2006 Mercury Milan

1 Answer

Upgrading 2006 Mercury Milan's sound system with MP3 jack.

Even though your current radio has an AUX button the radio is not programmed to utilize it.
There is no 'easy' way to add the '07 Job 2 and later year model's factory Aux input.
You will need to buy an aftermarket solution. Something like this

Oct 02, 2009 | 2006 Mercury Milan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

655 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

gerry bissi

Level 3 Expert

4376 Answers


Level 3 Expert

81294 Answers


Level 3 Expert

5687 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides