Question about Volkswagen New Beetle
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
P0011 - Intake camshaft position timing ( over advance bank 1 )
O0420 - catalyst system efficiency below threshold bank 1. Hope this was helpful.
Posted on Dec 02, 2009
SOURCE: vw jetta 2002 code p1296/po118
Both of these codes indicate trouble with the signal from the coolant temperature sensor.
So either the sensor is bad. The thermostat is not working properly and the coolant temperature is truly way out. The wiring to the sensor is short or open. The computer is bad and it is manifesting itself through this fault.
Does the car warm up properly? If it runs hot, or takes forever to warm up, this indicates a problem with the thermostat.
If the car runs at the proper temperature the next thing to look at is the coolant temp sensor and wiring. Some resistance values for VWs are here:
You might also be interested in this recall if your car is below 100k miles:
Posted on Jan 19, 2010
its the coolant temp sensor located on the lower hose neck above the transmission . you only need a pair of needle nose pliers for removing the clip that hold it in. good luck.
Posted on Nov 14, 2010
where is the dipstick to check transmission fluid looked everywhere
n my wv bettle was setting at a stop light n just shut off any ideas what it could be
Posted on Aug 17, 2011
Tips for a great answer:
Mar 20, 2014 | 2001 Volkswagen Golf
Jan 16, 2014 | 2001 Volkswagen Beetle
Feb 17, 2011 | 2001 Volkswagen Jetta TDI
Jan 15, 2011 | 2002 Volkswagen Jetta TDI
Dec 04, 2010 | 2001 Volkswagen Beetle
Nov 14, 2010 | 2001 Volkswagen Beetle
Nov 11, 2010 | 2002 Volkswagen Jetta TDI
Feb 10, 2010 | 2001 Volkswagen Jetta TDI
Oct 04, 2009 | 2001 Volkswagen Beetle
1,152 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: