Question about 1999 Mazda MPV

1 Answer

1999 mpv mazda,oil light blinking,just put a new oil switch,open cap see oill pumping up at cam

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Sounds like oil pump is weak. Did you happen to run it low on oil? Regardless, I suspect oil pump is going bad and should be replaced in very near future.

Posted on Mar 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will the oil pressure sensor prevent ignition to the motor? 1999 Ford Laser - KN or Mazda 323


no oil sensor not related

fuel ,spark a broken timing belt

fuel
pump or relay you should be able to hear the fuel pump working
if engine light is on
crank angle sensor

Nov 05, 2016 | Ford Cars & Trucks

1 Answer

Where is the fuel shut off switch for 1996 mazda mpv


Only on a ford

Do you not hear the fuel pump come on?

Do you have spark or injector pulse when cranking?

Dec 06, 2012 | 1994 Mazda MPV

1 Answer

Stupid question but I'm just not sure. What does it mean when the oil light is on and it makes a long beep like noise from time to time? Should I only get an oil change?


It's an indication of low oil pressure. Could be low on oil. Could be the oil pump. Could be excessive engine wear in the main engine bearings. As the engine runs the main bearings (in the oil pan and between the piston rod bearings) create pressure. If a couple of quarts of oil don't turn it off (if it's low), it could be the pressure switch being bad and sending a false signal. Lastly, the main bearings and oil pump. That's cheapest to most expensive.
Hope I helped. If so please rate my answer, and leave a comment. Thanks.

Dec 02, 2010 | 1999 Mazda MPV

1 Answer

96 mazda mpv minivan 165k mi. Ran fine until one day just died.Had towed home.3 mech.tried diagnose gave up wouldn't start-turns over-no start. Last mech.replaced timing belt&idle pulley. Still no...


I was browsing unsolved problems. If you still have the problem, I'll try to help you. But it's going to be awhile trying to communicate back and forth. First...Check the engine for spark. Take off a plug wire and stick a screw driver in the wire end and place the metal part of the screw driver next to something on the van that's metal. Have someone crank it over for just a second or two and see if a small spark jumps from the screw driver to the metal part. I'll check back for your answer.

Mar 05, 2010 | 1996 Mazda MPV

1 Answer

2000 mazda mpv van wheres the oil pump located 2.5 liter


Oil pump is located inside the oil pan. You must remove it to access the pump..

Dec 06, 2009 | 2000 Mazda MPV

2 Answers

3 liter mazda mpv overheating


You probably never cleaned the cooling system out.

If you have not get it done by pros.

It seems something is blocking the flow. If the water pump went bad you will know. Rarely ever heard a impeller breaks off like you think. The bearings and the seal break first.

Check and see also if the heater valve is working.

As for the over heating even new thermostats fail. Reverse flush is needed or the procan measure the pressure in the radiator cooling system and edetermine if there is a engine pressure problem. Tools and experience is the key in the game of diagnosis.







wfg8.com

May 17, 2009 | 1995 Mazda MPV

1 Answer

1990 mazda mpv power steering pressure switch


You can try a junk yard or better yet the dealer for new.

May 09, 2009 | 1990 Mazda MPV

1 Answer

Location of oil pressure switch.


how change oil pressure sensor in 2001 mazda mpv dx

Apr 10, 2009 | 2001 Mazda MPV

1 Answer

Don't know which engine oil to buy?


20W50 would work as long as you will always be in a warm climate... generally 10W30 is sufficient.

Robert

Please take a moment to rate this solution.. thanks

Jan 25, 2009 | 1999 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

242 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...