Question about 2006 Pontiac G6

1 Answer

I have 2 key fobs and neither one will unlock the doors. Everything else on them work

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 158 Answers

Try pressing the lock and unlock buttons together for 10 seconds and see if this reprograms your fobs

Posted on Mar 24, 2011

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

janlinekbmw
  • 146 Answers

SOURCE: electronic door locks not working

It will be a bad microswitch in the mechanical lock driver's door and because of the microswitches do not get the impulse when other doors to unlock! Unfortunately, this microswitch is part of the lock and can be purchased separately! Only whole lock! ( Nr. 9. is it )5abc095.jpg

Posted on Jul 01, 2010

Testimonial: "Excellent advice - thanks!"

tbirdfan1
  • 3051 Answers

SOURCE: key fob will not lock or unlock doors on 06 Sonata

Hi there
i have the same problem but mine is the sensor that is under the dash that is faulty so i had them disable it untill i can get a part that they need to order so i would have your dealer check the sensor .. if it is under warranty they will replace it for free

Posted on Mar 08, 2009

michigan man
  • 3533 Answers

SOURCE: key fob no longer unlocks car doors or trunk

you may have to replace the remotes and then have them reprogramed for the car because they do go bad but if there is an autozone near you they will test the remotes for free

Posted on Mar 01, 2009

  • 7 Answers

SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock

For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Posted on Feb 14, 2009

Murphybanton
  • 2004 Answers

SOURCE: key fob for hyundai elantra not working

Please dont worry yourself so much the security locks needs to be reprogrammed to enable it work effectively. Same happens to other vehicles as well.

Consult Hyundai garage close to you or if you have it in your manual.

Good luck.

rate this.

Posted on Apr 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Range rover p38 problems


I have the same problem sometimes
1 Check the condition of your battery, if old, it will not give full power required to communicate with the security system.
2 If you don't have the EKA of your RR, try this next time you get caught, put key in the drivers door look, press unlock button on key fob and at the same time turn to unlock, if all locks unlock then the engine should not be immobilized - Good luck

Jul 13, 2014 | 1996 Land Rover Range Rover

1 Answer

Key fob dont work, but door lock works ok, key fob battery change.


1. Get in your vehicle.
2. Close the door.
3. Put key in ignition
4. Do not turn on the ignition yet.
5. Hold down on the unlock button on the door panel. Do not let up.
6. Turn the key to ON, OFF, ON, OFF (while still holding the unlock button on the door panel).
7. Release the unlock button.
8. The door locks should cycle, indicating that you did everything correctly.
9. Have all your remote entry fobs available. Hold down on both the lock and unlock buttons until the door locks cycle. Do the same on all key fobs. This will re-program all of them.
10. Turn ON the ignition key to exit the program mode.
11. DONE.

Apr 18, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

Bmw drivers door only wont lock/unlock with key fob


Could be your driver door lock mechanism that is going bad , since the other door are working, it cannot be the fob. I would try to change the driver side door latch mechanism.

Apr 02, 2014 | 2008 BMW 320i Automatic

1 Answer

My lock and boot button does not work on my key fob


My remote would not work for any function. Took it appart and cleaned the circut board with alcohol and now everything works.

Oct 29, 2012 | 2003 Jaguar X-Type

1 Answer

How can I reprogram my Jaguar X Type Key so I can unlock and lock my doors?


if your just programming the fob to the module and it has not been replaced and your just needing a manual reset,then follow the folowing procedure:

1 Insert key into ignition
2 Turn key to 'I"
3 Turn key "II" and back to 'I' quickly 4 times
4 Alarm system will chime once when key is back to 'I' for the
fourth time
5 Remove key from ignition
6 Press any button on each key fob and alarm system will chime
for each fob if it has been programmed correctly
7 Press unlock/lock/trunk etc to make sure everything works

Dec 12, 2011 | 2003 Jaguar X-Type

3 Answers

My Porsche Key fob no longer unlocks the doors


Insert key into door barrel or ignition lock and turn key, whilst doing this press the unlock/lock button, the led on the dash should flash to indicate this has initialised the key to the car, then remove key and test operation of remote. If this fails then a new remote plus coding to the car by your dealership is needed

Feb 16, 2010 | 2005 Porsche 911

1 Answer

C240 mercedes key wont turn seems locked... I went to my car used fob doors unlocked when I tried starting i inserted the key in the ignition and the fob will not turn seems locked..now all of a sudden the...


I have a 2001 C240 with the same issue. I removed the positive battery cable from the battery and kept it off for 30 seconds then replaced it. Everything was reset and the key worked.

Jan 12, 2010 | 2001 Mercedes-Benz C-Class

Not finding what you are looking for?
2006 Pontiac G6 Logo

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...