Question about 1995 Oldsmobile 88

2 Answers

Map sensor location - 1995 Oldsmobile 88

Posted by on

  • Anonymous Apr 03, 2009

    same thing with my 2005 vue 4cyl.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hey they dont have map sensors only mass air flows and idle air control valves. But mine is supercharged so.. . . .

Posted on May 13, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Year of the car would help.

Posted on Oct 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'96 chevy express van 1500...location of M A P sensor on 5.0 litre


1996 Chevrolet Truck G10 1/2 ton Van 5.0L SFI 8cyl

The MAP Sensor is located: Front seating area, center, under engine cover, rear passenger side of intake manifold, above valve cover, mounted on bracket.Here's a link to what it look's like Brad. MAP Sensor at AutoZone com Best MAP Sensor Parts for Cars Trucks SUVS

Jul 23, 2015 | Cars & Trucks

1 Answer

Where is map sensor located on my ford mondeo mk111 di estste year 2001


most MAP sensors, are located right after the air filter it's probably a silver box with an electrical sensor to it

Nov 15, 2014 | Ford Mondeo Cars & Trucks

1 Answer

Map sensor location


The MAP sensor in your car is a Manifold Absolute Pressure sensor, and it is located inside of the manifold.

May 08, 2013 | 1987 Pontiac Grand Am

2 Answers

Where is the map sensor located on the pacifica


The MAP sensor on the Chrysler Conquest is located either on the passenger side or the driver side down around knee level. The Manifold Absolute Pressure sensor (MAP sensor) is one of the sensors used in an internal combustion engine's electronic control system.-------------------------------------------------------------------------------------
Car Key Programmers

Nov 27, 2012 | 2004 Chrysler Pacifica

1 Answer

Where is the map sensor located on a 1.9 litre vw jetta?


For exact location and replacing procedure of VW jetta MAP sensor,click the link below and follow the details with diagrams:-----Where is MAP Sensor Located on VW Jetta http://technoanswers.blogspot.com/2012/11/where-is-map-sensor-located-on-vw-jetta.html
---------These will help.Thanks.

Nov 25, 2012 | Cars & Trucks

1 Answer

Map sensor location


Located on top cylinder on transmission side.The MAP sensor is located either directly on the intake manifold or it is mounted high in the engine compartment and connected to the intake manifold

Check out related help links to MAP sensor and its problems:----
Click the link below:-----

MAF, IAT, MAP and Coolant Level Sensor problem all together on Mazda MPV? http://schematicsdiagram.blogspot.com/2011/12/maf-iat-map-and-coolant-level-sensor.html
----------

Oldsmobile Manifold Absolute Pressure (MAP) Sensor...

---------

How to test MAP sensor?

---------------
Working of Manifold Absolute Pressure (MAP) Sensor...
--------------These will help.Thanks.

Nov 23, 2012 | Cars & Trucks

1 Answer

I need to replace the map sensor in a 2.4 alero but I do nor know where it located.


Here is a diagram of where the map sensor is located on this particular vehicle, i have also included the removal and installation procedures as well

Hope this helps....

REMOVAL PROCEDURE

  1. Remove the air cleaner outlet resonator.
  2. Disconnect the manifold absolute pressure (MAP) sensor.
  3. Remove the MAP sensor attaching screws (1).
  4. Remove the MAP sensor vacuum hose (2).
INSTALLATION PROCEDURE

  1. Connect the vacuum hose (2).
NOTE: Refer to Fastener Notice in Service Precautions.

  1. Install the MAP sensor attaching screw (1).
Tighten
Tighten the screw to 6.5 N.m (5.7 lb in) .

  1. Connect the MAP sensor connector.
  2. Reinstall the air cleaner outlet resonator.


asetech74_0.gifasetech74_1.gif

Sep 15, 2011 | 2000 Oldsmobile Alero

1 Answer

Need piture for 1995 buick rivera supercharger of were the map sensor is at


MAP SENSOR ON TOP OF INTAKE BESIDE THE SUPERCHARGER. TAKE THE NEW MAP SENSOR USE IT FOR REFERENCE LOCATING OLD MAP SENSOR. WHEN YOU SEE IT ON INTAKE IF MATCH UP WITH OLD MAP SENSOR THEY MATCH UP YOU LOCATED THAT IT.

Sep 14, 2010 | 1995 Buick Riviera

2 Answers

Replacing the MAP sensor??


REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Locate the MAP sensor and remove the retaining screws
  3. Detach the electrical connector.
99e56ea.jpg

Fig. On the 3.1L engine, the MAP sensor is located alongside the intake manifold

06cd371.jpg

Fig. MAP sensor and its bracket arrangement-3.4L (VIN E) engine

c92a20a.jpg

Fig. Location of the MAP sensor on the throttle body adapter-3.4L (VIN X) Engine

ef21261.jpg

Fig. The MAP sensor is located just behind the throttle body mounting base-3.5L (VIN H) engine

c7cd8f9.jpg

Fig. MAP sensor and its location alongside the supercharger-3.8L (VIN 1) Engine

98ee1cd.jpg

Fig. On the 3.8L (VIN K) engine, the MAP sensor is located on top of the PCV valve cover
  1. Remove the vacuum hose and lift the MAP sensor from the engine.
  2. Installation is reverse of the removal procedure.

Hope helps (remember rated and comment this).

Aug 06, 2010 | 2000 Oldsmobile Intrigue

2 Answers

1998 chevy suburban map sensor


Hi, The Map sensor on a Suburban is located.
Beside of the ignition coil. on the intake.
Is a litle sensor with a connector of 3 wires.

I hope this work for you. OK

Jun 28, 2008 | 1998 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

368 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...