Question about Buick LeSabre
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: signal light problem
If the signal lights don't work on either side, front and back, check the flasher, usually located on the fuse block. If this isn't it, let me know, we can continue from that point.
Posted on Nov 18, 2008
SOURCE: 1995 Buick LeSabre - horn blows
My horn would honk without any assistance from me. The
reason was because the plastic cover for the air bag and horn switches had
shrunk so tight that it pressed on the horn switches. If your problem is
intermittent then cold temperature would also cause the cover to shrink. This
is how I solved the problem on my 1995 Buick LeSabre:
Disconnect the negative battery cable.
3. My horn relay was the second from the left as I faced the rear of my car. It was gray. Some may be black.
4. A small green retainer tab had to be pushed out before I could pull the relay out. On the back of the relay were two orange wires that supply 12V. One green wire that goes to the horns and one black wire for ground that goes to the horn switch under the air bag.
5. I cut the black wire and wired in a spst push button switch that I connected to ground.
6. I mounted the push button switch near the driver’s door on a flat part of the dash. I used very strong double sided tape to secure the button switch to the dash.
My horns now are activated when I push my new horn switch button. My problem solved.
Someone recommended removing the air bag/horn switch unit from the steering wheel and relieving the tightness of the plastic cover. There are probably more than one way to this.
Posted on Jan 25, 2009
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
Posted on Mar 20, 2010
Tips for a great answer:
Jul 06, 2012 | 2002 Buick LeSabre
Oct 19, 2011 | 1998 Buick LeSabre
Jun 07, 2011 | 2001 Buick LeSabre
Apr 22, 2010 | 1994 Buick LeSabre
Oct 21, 2009 | 1998 Buick LeSabre
Sep 17, 2009 | 1993 Buick LeSabre
Mar 01, 2009 | 1993 Buick LeSabre
Jan 26, 2009 | 1997 Buick LeSabre
38 people viewed this question
Usually answered in minutes!