Question about 2002 Ford Explorer

Open Question

Were is the egr vacum solenoid located on a 2002 ford explorer

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

yotaguy
  • 232 Answers

SOURCE: where is the inline fuse for the alternator on a 2002 ford explor

I see two or three,the schematic shows two in series coming of the wire from the battery junction box to the back of the alternator and a third coming off the second wire,it's a tough call because schematics even factory schematics aren't always right but either way follow the wiring from the back of the alternator,and you should find them.

Posted on May 15, 2009

  • 5 Answers

SOURCE: 1996 ford explorer v-6 4x4

If you're asking about the electronic pressure control solenoid, it's on the driver side of the valve body. There are 4 sols on that side, it's the one closest to the rear. It's bigger & heavier than the other 3.

Posted on Dec 16, 2008

chrischronic
  • 235 Answers

SOURCE: 1999 ford explorer-Solenoid switch location?

solenoid switch is on top of starter . thare is also a starter relay in the fuse box under the hood . find this relay and see if it clicks when the key is turned over.get someone to turn key while you put your finger on the relay if its clicking then the starter solenoid is bad,some of thesesolenoids must be replaced with the starter.

Posted on Jan 16, 2009

  • 1201 Answers

SOURCE: 1998 ford explorer starter solenoid location?

Usually mounted on the inner fender well by the battery, the positive battery cable is hooked to it.

Posted on Dec 19, 2009

Dirt Dobber
  • 253 Answers

SOURCE: 2002 Ford Windstar p0300 skips and backfires under load

Just put a coil on a 2002 today. Coils fail a lot with no codes given

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2002 Ford f150 evaporative emission control system sensor where is it located


on top of the canister purge can , next to the solenoid of same purpose

Jan 30, 2016 | Ford Cars & Trucks

3 Answers

Ford Taurus. Check Engine Light Code P1400


P1400 Exhaust Gas Recirculation valve position sensor
P1401 Exhaust Gas Recirculation valve position sensor
P1402 Exhaust Gas Recirculation metering orifice restricted
P1403 Exhaust Gas Recirculation differential pressure sensor
P1404 EGR Temperature Sensor circuit
P1405 Exhaust Gas Recirculation Differential Pressure Feedback Sensor upstream hose off or plugged
P1406 Exhaust Gas Recirculation Differential Pressure Feedback Sensor downstream hose off or plugged
P1407 EGR solenoid -No Flow Detected
P1408 EGR solenoid -Flow out of Self- Test Range
P1409 EGR Vacuum Regulator solenoid circuit malfunction
---
The sensor for the EGR Valve position is not functioning correctly.

Oct 16, 2010 | 2002 Ford Taurus

1 Answer

I'm not sure if i got the egr vac hose and the fuel pressure reg hose backwards?


The vacum hose that goes to the fuel pressure regulator will have vacum all the time and will come from the in take, the one for the EGR will not have vacum all the time and that hose will come from the EGR control solenoid a black looking solenoid with two ports coming out of it.

Jun 14, 2010 | 1999 Ford Expedition

1 Answer

I have a ford explorer sport 2002 and my chek engine light came on it put out a code PO401 do you know what i need to buy


PO401 code means that:
The PCM has determined that there is insufficient flow in the exhaust gas recirculation system. Definition: EGR system fault (Exhaust Gas Recirculation) Probable Causes: a. Blocked passage on EGR system b. Failed EGR Valve c. EGR solenoid faulty d. Failed EGR pressure sensor where applicable e. Failed EGR position sensor where applicable

Mar 08, 2010 | 2002 Ford Explorer

1 Answer

2003 4.0 V6 explorer with the vacume line off the egr it runs, but runs rough. when the vacume line is hooked up to the egr it cuts off. i put a new egr on and it did the same thing please asap..


First. Check the vacum routing from the egr. facing the engine, the vac.
line should go to the right and connect to the egr vacum regulator
solenoid. The line from the solenoid to manifold vacum. The solenoid
is also connected to the powertrain ctrl. module And some models,
have a egr sensor. the two vac.lines from the sensor(if equipped)go to
the exaust below the egr valve. The three wires from the sensor go to the pcm. At this I would plug in the obd2 scanner if no vac.leaks or
bad connections have been found. This can narrow the field greatly.
You can stop by an autozone/napa etc. they will scan it for free.
I hope this helps. Good luck.

Feb 03, 2010 | 2003 Ford Explorer Sport

1 Answer

Where is the egr valve located on a 2002 explorer xlt


The EGR valve should be located on the intake manifold. Hope this helped and best wishes.

Jul 28, 2009 | 2002 Ford Explorer

1 Answer

1993 ford explorer egr not where book says unale to locate.


Its located on the innlet manifold with a vacum hose attached to it,

Jul 19, 2009 | 1998 Ford Explorer

1 Answer

I have no vacum from the throttlebody to the egr valve solenoid therefore my egr valve can,t work


some of the solenoids do not kick in till the car is in gear or moving is there a code in the comp fo egr problem

Apr 16, 2009 | 2002 Mitsubishi Mirage

1 Answer

2002 Ford Explorer 4.0L V-6


do you have a code for egr? if you do follow the hose all the way to the egr solenoid and meke sure the othe hose atached to the solenoid has vacium, the egr only gets vacium when the computer triger it but not all tyhe time

May 26, 2008 | 2002 Ford Explorer

Not finding what you are looking for?
2002 Ford Explorer Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...