Question about 1984 Chevrolet Camaro

3 Answers

The car steers really hard, the battery light came on and the indicator of cold or hot was going to hot. We shut it off and it started again but we shut it back off and we have not moved it. What is it?

Posted by on

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 507 Answers

Or if it's a serpatine belt, one belt for all accesories, check the belt tenisnor. If it has lost tenison, the belt would appear find but not enough pressure on rotate accesories.

Posted on Sep 05, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 375 Answers

Try greasing the front end and check the air in the tires the indicator is totally different pro--Make sure the coolant is at the proper level. There may have been an air pocket in the system, most time they will work their way out, and leaves the coolant level low. If not, you may need to check for an air pocket.

Posted on Aug 03, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that has over 500 points.

  • Master
  • 398 Answers

Check for broken belts. Sounds like your belt that drtives ;your alternator and power steering pump may broken.

Posted on Aug 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2003 GMCHD 2500 and the heater is not blowing hot air, turned off the truck and started it again and it will blow hot for 5 seconds and turn to cold again. have you come across this problem before


It is running a test cycle and getting stuck. There are a couple of options. Disconnect the battery, then drive the vehicle around without using the AC for 10 min, if the AC is defaulted to come on after a battery interuption, then shut the car down then turn it on again. You are trying to get the electronic actuator to reset and resume proper function. Another option is to try this: Start the car, adjust the pax side full hot, drivers full cold, wait 30 sec then shut car down, then start car back up and reverse the settings, pax full cold, drivers full hot. In both solutions, the vent actuators are stuck at either the full open or full closed, so you are trying to get it to 'self check' and allow them to resume proper function. After two years, I simply removed them altogether since I live where it is hot an only need cold.works just fine....

Nov 01, 2011 | 2003 GMC Sierra

1 Answer

My 1993 dodge caravan 3.3 v-6 is taking a while to start hot or cold, but then runs fine until you shut it off and start it again. any ideas?


check the spark plug gaps ,should be around 25th if too wide this will cause hard starting hot and cold

Jan 21, 2011 | 1993 Dodge Caravan

2 Answers

Last night, I was driving and smelled something hot and then the battery light came on and the power part of steering and brakes went away. It is very cold here. The lights are still working. Could it be...


Check to see if the belt [ s] are still on the motor. You may have had something seize and break the belt that powers these items. There is also a seperate belt that powers the A/C [ lower right side of engine ].

Jan 13, 2011 | 2002 Chevrolet Silverado 2500HD

1 Answer

Does the 2002 regal have a cold motor sensor Car hard to start when cold motor (in the morning )


Your vehicle uses the coolant temp sensor and the intake air temp sensor to determine the engines temperature on a cold start. If one of them is dramatically different than the other it will flag a code.

Is the check engine light on?

When was the last time you had a tune-up? if recently what brand of plugs where used?

Have you noticed any hard start issues after a hot soak? A hot soak would be driving the car until fully warmed up, shutting of the engine for approximately 15 to 20 minutes, and then starting the engine again.

Oct 27, 2010 | 2002 Buick Regal

1 Answer

2006 Chevy Cobalt. My power steering goes out.


It sounds like the power steering motor is overheating pre maturely. Changing the motor should take care of the problem. What really happens is the motor reports to the power steering module that it is over heating and the module is shutting power to the motor down, the motor is actually no overheating.

Feb 02, 2010 | 2006 Chevrolet Cobalt

1 Answer

High temperature gauge reading, low battery voltage reading


The loud whine you speak of indicates one of two things a bad serpentine belt or alternator, The first thing would be to check the belt.Look for cracks worn spots or glazing. If the belt looks ok then take the belt off and start the engine for a minute or so and listen for noise.

Jan 01, 2009 | Ford Explorer Sport Cars & Trucks

1 Answer

Intermintent starting in cold weather


I had the same issue with a S-10 blazer that by wiggling the key while trying to start the truck the warning lights would come on and the engine would start. We replaced the ignition switch and solved the problem.

Nov 22, 2008 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...