Question about Chevrolet Impala
Your impala doesn't have a resistor , it has a blower motor control processor and it doesn't work the way you think it does
Chevy Trailblazer EXT Blower Motor Won Turn Off
Blower Motor Control Processor
The blower motor control processor is an interface between the HVAC control module and the blower motor. The blower motor speed control, battery positive voltage and ground circuits enable the control processor to operate. The HVAC control module provides a PWM signal to the control processor in order to command the blower motor speed. The processor supplies 12 volts to the blower motor through the blower motor voltage supply circuit. The control processor uses the blower motor ground as a low side control to adjust the blower motor speed.
HVAC Blower Motor Circuit
Posted on May 27, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
It is a bad blower motor resistor and it is mounted on the bottom of the A/C heater housing on the passenger side of the vehicle under the glovebox area. Hope this helps. Please rate this a fixya if it helps. Thanks.
Posted on Sep 13, 2008
SOURCE: 2006 Chevy Impala - Heater
the blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate me!!
Posted on Dec 02, 2008
it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble
Posted on Feb 19, 2009
The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.
Posted on Jul 20, 2009
Your looking for the blower resistor. Its on the passenger side under the dash. Two of the wires go the the blower motor. The wire connector and the resistor can burn or corrode. The replacement is easy two screws hold the resistor in and the connector can be replace with **** connectors.
Posted on Dec 12, 2009
Tips for a great answer:
Sep 25, 2014 | 2008 Dodge Ram Pickup 1500
Feb 04, 2013 | Cars & Trucks
Feb 02, 2013 | 1995 Buick Park Avenue
Oct 20, 2017 | 2002 Mazda MPV
Jan 13, 2011 | 2004 Isuzu Rodeo
Jun 15, 2010 | 2003 Chevrolet TrailBlazer
Feb 19, 2009 | 2002 Chevrolet Avalanche
Aug 12, 2018 | 2007 Chevrolet Aveo Sedan
61 people viewed this question
Usually answered in minutes!