Question about 2006 Chrysler Town & Country

1 Answer

My 2006 chrsyler town and country van has no pick up. can only go about 10mph up a hill. someone told me its the egr valve. what you u think

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 784 Answers

Yes it can be. how many rpm is with 10 mph in tachometer? Also can be faulty oxigen sensor and air flow sensor, And can be faulty catalysator.

Posted on Mar 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08' town and country shows codes p0406, p0404, p0301, p0300


egr valve is stuck open at idel exhaust gas is entering engin causing lean condition and missfire your po300 301 codes replace egr and clear codes

Feb 09, 2014 | 2005 Chrysler Town & Country

2 Answers

My 2005 town and country does not have an egr valve - but idles very rough when stopped


I had the same problem and your right no egr on 2005 town and country I have the same vehicle and the place for the egr is covered by a metal plate I also had the same exact problem with my van misfire bad idle at stop lights and after replacing every sensor there is and testing every part and injector with Ohm meter I read an article about the intake manifold plenum gasket leak can cause misfire so I bought new intake manifold plenum gasket set for only $7.99 and installed them and like magic the van ran perfect no more misfire no sluggish start from light Van is fixed finally!!!

Sep 30, 2012 | 2005 Chrysler Town & Country

1 Answer

My 2001 town/country 3.3 flex fuel oerheated, it has a leak in the heater core. Now the van is hard to start and will only go 40 mph full throttle, if it doesnt stall. I was told to change the egr val


Those van are very common for egr valve problems but usually set a check engine light try to un plug the valve. Its also possible you have a plugged coverter

Jul 22, 2012 | Cars & Trucks

1 Answer

The a/c was working but now it only works on high. How can this be fixed? I have a 2002 Chrsyler Town and Country mini van.


The blower only works on high? If so it sounds like you need a new blower motor resistor/module. It will be located on the passenger side behind the glove box.

Jul 16, 2011 | 2002 Chrysler Town & Country

1 Answer

Finding the egr to replace it in the 2006 chrsyler van 3.3 liter engine send diagram also please


You dont know where it is,or how to check it, but you know its bad????? Its just behind and below the throttle body.

Dec 11, 2009 | 2006 Chrysler Town & Country

1 Answer

Describe your 2006 Chrysler Town & Country Problem p0404 engine code


P0404 IS EGR POSITION SENSOR PERFORMANCE..YOU NEED A NEW EGR VALVE..RECOMMEND DISCONNECTING BATTERY WHILE REPLACING EGR VALVE..SOMETIMES CODE WILL NOT GO AWAY EVEN AFTER REPLACING VALVE AND CLEARING CODE WITH SCANNER..VALVE IS LOCATED ABOVE ALTERNATOR ON END OF CYLINDER HEAD..THE BOTTOM BOLT CAN BE TRICKY TO REMOVE AND HAVE HAD TO REMOVE ALTERNATOR TO GET BOLT OUT..YOU WILL NEED A NEW GASKET FOR TUBE AS WELL..ABOUT 120 BUCKS FROM DEALER(CAN)

Jul 25, 2009 | 2006 Chrysler Town & Country

2 Answers

I have a 06 crysler town and contry code p0404 egr flow ckt range/perf. cleared code once and came back on what can i do to fix..


you need to replace the egr valve..mounted on front cylinder head just above alternator..disconnect battery while you replacing it..have seen code come back even after replacing valve..this should cure problem

May 17, 2009 | 2006 Chrysler Town & Country

1 Answer

Code p0404


replaced the EGR valve

Jul 05, 2008 | 2006 Chrysler Town & Country

Not finding what you are looking for?
2006 Chrysler Town & Country Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...