Question about 1996 Audi A4

1 Answer

Starting i need to find a way of bleeding my car as it hasnt been started in a few months .........help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

If you are trying to prime the oil system, simply pull off the the primary ignition coil wire, or if it doesn't have one, remove the wiring harness going to the coil, turn the motor over for about 15 seconds, and go from there. To prime the fuel system, simply turn the ignition switch to the on position, wait 2 seconds, turn it off, wait two seconds and turn it back on again, do this about five times, and the fuel system will prime itself.

Posted on Aug 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1994 chevy surburban with a 6.5 turbo diesel and it hasnt been plug in for a few month so i was wondering what would b the easiest way to start it and what can i do to make it easier to start for...


By plugging it in I assume you mean the block heater for the engine.
I would plug it in for an hour or two before starting. also give the glow plugs plenty of time to heat up before starting. If you don,t have a garage to put it in try to find a place out of the wind and with direct sun in the day this may help some. laying an old blanket or quilt or even a tarp over the hood and front end could help some. after sitting for a prolonged period of time in cold weather hook a charger up to the battery before starting to top off the battery's charge. Hope this helps.

Dec 30, 2013 | Chevrolet Cars & Trucks

2 Answers

I have a 96 cavalier 2.2 5 spd


the pressure plate might have gone bad or need resurfacing if glazed.
also the flywheel could be glazed.

Jan 30, 2013 | Chevrolet Cavalier Cars & Trucks

1 Answer

CITROEN C2 HDI KEEPS CUTTING OUT WHEN ACCELERATING, ENGING MANAGEMENT DID SHOW THROTTLE SWITCH PROBLEM BUT LIGHT HASNT BEEN ON SINCE, BUT STILL KEEPS CUTTING OUT ON ACCELERATION WHEN COLD


i have recently bought a citreon c2 1.4 hdi furio sensodrive, iv had it for a couple of months now but recently in the morning its giving me trouble starting up, as i start it and after a few secs it keeps cuting off, but after a few attempts it bes ok for rest of the day, and also i was concerned about the diesel pre heat light, as it never comes on , and when i rand the dealers who i got the car off they said it dosnt have 1 due to its straight injection, is that true

Mar 07, 2010 | 2006 Peugeot 405

1 Answer

My car has had a few problems lately, can you help


I have the same problem with not starting. I have noticed that if I go easy on the gas pedal right before I pull into the parking space or the last 20-30 seconds before I shut off the engine, it will "cooperate" much better when I start next time. Also fillip up on Shell V-Power premium twice in a row on long trips seems to solve the problem for a few days; have no idea why!

Jan 09, 2010 | 2002 Audi A6

1 Answer

I have a 1985 Chevy S-10. I have not started or drove this vehicle for a few months. I go to start it today and the clutch goes all the way to the floor with no resistance. Please help?


Your S10 has a clutch master cylinder and slave cylinder, a hydraulic clutch system.

You need to fill the master cylinder and bleed both the master and slave cylinders in order for the clutch mechanism to work properly.

Dec 27, 2009 | 2001 Chevrolet S-10

1 Answer

My 1993 infinti j30t hasnt had powersteering for a number of months now is it possible my pump has gone out the original problem was the pressure line


if you pumped out all the fluid the pump may have dryed out at that time and its finaly given up the gost now, look to see if its full of strearng fluid lift your car up at the front on a jack (both wheels clear of the ground) then start your car and turn the wheel fully from left to right a fuw times this may bleed any air out the rams, if it still dont waor its your pump died on you

Oct 25, 2009 | 1997 Infiniti.5 J30

1 Answer

Wont start


DME relay is faulty, its seperate from the ecu and was most likely fried when the ecu went........did anyone try to run an on board diagnostic code pull?

Jan 11, 2009 | 2001 BMW Z3

2 Answers

Wont start


did you check the fuel pump relays?

Aug 29, 2008 | 1996 Chevrolet K1500

Not finding what you are looking for?
1996 Audi A4 Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...