Question about 1995 Oldsmobile Aurora

Open Question

How do you bleed a heating cooling system on a 95 olds aurora 4.0 northstar

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 38 Answers

SOURCE: 1991 daihatsu applause super selection eng-HD-E1

let the car get up to operating temp and squeez the top radiator hose, if you feel the coolant squeeze out into the motor you thermostat is fine, but if you feel the hose and it feels presurized you need a thermostat. Also check to make sure the fan is operating at operating temp because that would cause overheating. ALL vehicles require the cooling system to be bled. Some have a bleeder screw (usually near the thermostat ) if not fill the radiator and keep toping it off at the coolant tank.

Posted on Apr 28, 2010

  • 110 Answers

SOURCE: how do you bleed cooling system for 1995 nissan pickup truck

  1. Open radiator cap and air relief plug.
  2. Fill radiator with coolant to specified level.
  3. Close air relief plug.
  4. Run engine and bring to operating temperature.
  5. Race engine two or three times under no-load.
  6. Stop engine and let cool, then add coolant as necessary.

Posted on May 10, 2010

  • 20 Answers

SOURCE: overcharging electical system

I can't remember what it is called but there is a thermistor or something on one of the battery cables that is the problem, replace the cable.

Posted on Jul 18, 2010

  • 615 Answers

SOURCE: how to replace a starter on an 97 olds aurora with

Not sure how different, but on the 2001 4.0 you remove the fuel rails and intake manifold. Starter is under the intake manifold. Not too difficult of a job.

Posted on Nov 03, 2010

  • 96 Answers

SOURCE: does 95 aurora northstar engine

The 1995 Oldsmobile Aurora with the Northstar engine has a timing chain.

Posted on Feb 08, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have sludge in the coolant in my l997 Olds Aurora/

pink sludge --very serious
it is a failed transmission oil cooler allowing transmission oil into the cooling system
Oil and water do not mix and in a cooling system prevents the heat transfer from the cylinder wall to the coolant and from the coolant to the radiator fins

Feb 02, 2017 | 1997 Oldsmobile Aurora

1 Answer

How to change water pump on 2001 olds aurora 3.5

does anyone have experience changing a water pump on a 2001 ...
Aug 13, 2008 - aurora.................good luck. if u got the "short star" (3.5 dohc v6) good luck. if u got the 4.0........even better luck. happy trails. TonWon ยท 8 years ...

Aurora 4.0 Exhaust Leak and Water Pump Whine - YouTube

? 0:46
Dec 13, 2012 - Uploaded by Brendan Doyle
Aurora 4.0 Exhaust Leak and Water Pump Whine. Brendan Doyle ... How to Install a Waterpump on a Cadillac Northstar engine. ...How to access spark plugs on a 2001 Oldsmobile Aurora 3.5L Engine - Duration: 3:19. Dennis ...

Oldsmobile Workshop Manuals > Aurora V6-214 3.5L VIN H ...
Oldsmobile Workshop Manuals > Engine, Cooling and Exhaust > Cooling System ...Aurora V6-214 3.5L VIN H SFI (2001) ... Install the new water pump gasket.

How to change water pump on 2001 olds aurora 3.5 - Fixya
Mar 4, 2013 - 4.0? It's not that hard to replace but you need a special socket to changeit ... The starter motor sits in the "valley" between the two bank of cylinders ...

Mar 04, 2013 | 2001 Oldsmobile Aurora

1 Answer

Does 95 aurora northstar engine have a timing chain or belt

The 1995 Oldsmobile Aurora with the Northstar engine has a timing chain.

Feb 08, 2011 | 1995 Oldsmobile Aurora

1 Answer

Added colant and the car is now overheating

That's because you need to bleed the cooling system, now. Here is a link to an article that will tell you how to bleed the cooling system on your car.

Dec 24, 2010 | 1995 Oldsmobile Aurora

2 Answers

How do i bleed air from the cooling system on a 2001 cadillac sts with the norstar engine

how do i bleed my ciiling system on a 2002 deville with northstar

Nov 21, 2010 | 2001 Cadillac Sts

1 Answer

Why does My 95 Jetta keep over heating I replaced all hoses and water pump and the thermostat

you have to bleed the very top hot hose after fitting any hoses to the cooling system, EUrope we have a small bleed valve fitted.
wear rubber gloves and when hot/running undo topmost hot hose clip to vent...

Sep 09, 2010 | 1995 Volkswagen Jetta

1 Answer

2001 Aurora water pump replaced but now every time car is started Low engine coolant warning comes on but goes out when reset and doesn't come back on until car is started. Checked and coolant level is...

On the Owner's Manual there's a procedure you have to follow to bleed the air in the cooling system, until you bleed the system for air, the low coolant light will come on every time.

The process is rather simple and quick, all you need is a flat head screw driver.


Good Luck!! Don't forget to rate this post!!

Sep 03, 2010 | 2001 Oldsmobile Aurora

1 Answer

How do i change the stater on olds aurora with northstar engine

northstar engine the starter is under the intake manifold, better get a manual

Aug 23, 2010 | 1996 Oldsmobile Aurora

2 Answers

How to fix no heat in 95 aurora olds. and a/c stays on with defrost on.

The A/C compressor is supposed to run in defrost mode. The only modes the compressor won't cycle is floor only and face only. This is to keep the seals in the system lubed during the winter.

If you don't have heat, check the coolant level. If the level is low you won't have heat.

Mar 04, 2010 | 1995 Oldsmobile Aurora

2 Answers

99 do you bleed out air from cooling system?

There is no need to bleed air out of the system as the Northstar is self purging.

If you are having overheating problems the most common overheating problem with the Northstar engine is a blocked purge line. It's job is to purge air out of the cooling system.
There is a small diameter hose coming from near the top of the coolant tank(Not the cap!),this is the purge line.
With the engine idling,pull the purge line from the tank,if there is no coolant flow from this small hose,it is blocked and this will cause overheating.If the hose is clear, check for blockage at the nipple on the tank.

Air locks in the Northstar engine shouldn't be a problem as the system is self purging, given that all hoses are clear.

Oct 05, 2009 | 1999 Cadillac DeVille

Not finding what you are looking for?
1995 Oldsmobile Aurora Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides