Question about 2000 Dodge Caravan
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I've been having this problem with this car for a while.This is the third time which I needed to change the damn solenoid in 3 years.You need to take the whole air filter off,you have in the front two screws,and two more just to loose the clamps.You need to pull the whole thing out,once you take it out,you should be able to see it under two black hoses,it has 3 screws into it,it's very easy to take off and replace,about 2 hours total.No more domestic cars for me for as long as I live!Good luck!
Posted on Jan 20, 2009
SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
Posted on May 30, 2008
SOURCE: 2000 dodge caravan. Speedometer
hi there try to get a price on the speed sensor located on the transmission this sensor tells the computer how fast the van is going in turn the transmission shifts gears and there will be information sent to the speedometer . the reason the van only goes in low gear is to protect the system because the sensor is damaged so replace the speed sensor and try again , let me know how its running after relpaceing the sensor good luck
Posted on Jul 05, 2008
USUALLY A SHIFT SOLENOID DTC IS REPAIRED BY REPLACING THE TRANS SOLENOID PACK ASSEMBLY..LOCATED ON OUTSIDE OF TRANSMISSION..YOU MUST BE CAREFUL WHEN CHANGING PACK..CLEAN ALL DIRT/DEBRIS FROM OUTSIDE OF PACK..YOU DON'T WANT ANY DIRT TO ENTER TRANSMISSION..SOLENOID IS A SMALL BOX LOCATED ON SIDE OF TRANS FACING FRONT OF VEHICLE..YOU MUST REMOVE TRANS COOLER LINE HOSES FROM FITTINGS ON TRANS..REMOVE INPUT SPEED SENSOR..UNPLUG PACK..8MM SCREW HOLDS IT..3 BOLTS HOLD PACK TO TRANS..YOU MUST CLEAN ALL GASKET RESIDUE THOROUGHLY BEFORE INSTALLING PACK..I'D RECOMMEND GETTING SOMEONE WHO HAS DONE THIS BEFORE IF YOU ARE NOT COMFORTABLE DOING THIS..I HOPE THIS HELPS
Posted on Dec 30, 2009
transmisssion comes out from under vehicle.jack up vehicle or place on lift if available. first remove front tires, in center of brake rotors remove large nut in center. disconnect lower control arms on left and right. pull both left and right drive axles. disconnect all cables connected to transmission, disconnect two transmission cooling lines, remove lower frame connected to vehicle body and transmission and engine. remove inspection cover on transmission, remove eight bolts around outer edge of transmission, remove four bolts that connect torque converter to flywheel.slide transmission out horizontally to remove.
Posted on Jun 13, 2010
Tips for a great answer:
Feb 12, 2018 | Dodge Cars & Trucks
Nov 29, 2013 | 2000 Dodge Grand Caravan
Mar 24, 2013 | 2000 Dodge Grand Caravan
Aug 13, 2011 | Dodge Grand Caravan Cars & Trucks
Feb 28, 2011 | 2000 Dodge Grand Caravan
Dec 28, 2010 | 2000 Dodge Caravan
Sep 25, 2010 | 2005 Dodge Grand Caravan
Dec 30, 2009 | 2000 Dodge Caravan
Jul 08, 2009 | 2000 Dodge Caravan
263 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: