Question about 1993 Buick Park Avenue

1 Answer

Car will not fire but will turn over (93 buick park avenue

Posted by on

  • calebcalebho
    calebcalebho Jan 13, 2012

    try jiggling the battery cables or tightening them

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

Crank sensor? or module under coils

Posted on Mar 23, 2011

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: turn signal flasher

there are 2 one for the hazards and one for the blinkers

the hazards are under the dash about where your right knee would be you have to remaove the lower portion of the dash (2 screws)

the blinkers are way up under the dash by the parking brake.....way up you have to get on your back and move wires to see it if the flasher still works a little you can hear it.....again its way up there but you dont have to remove anything to get to it.

I just changed mine it took 10 times as long to find it as it did to replace it

Posted on Sep 10, 2008

Molson02536
  • 3854 Answers

SOURCE: 93 PARK AVENUE OIL PRESSURE TO HIGH

If the oil filter was over torqued and the gasket was rolled off the filter's gasket grove would case the gasket to blow out. Case would be not lubricating the O ring gasket on the filter before installation would also case the gasket to come off the grove on the filter and the oil pressure pushing through the system would blow it out. Note: follow instructions on the oil filter prior to installations and check the gasket for leaks upon start up and warm up. Hope this help's.

Posted on Jun 03, 2009

ZJLimited
  • 17970 Answers

SOURCE: I need to find firing order for a 1999 Buick park

1999 Buick Park Avenue 3.8 liter V-6 VIN "K"

e18bec5.gif

Hope helps (remember rated this).

Posted on Jun 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a picture of firing order on a 1991 Buick Park Avenue


Check this site I believe the black images is the coil pack firing order. I used a coil pack from a different model but had to open it up and change the firing order since the spark wires wouldn't reach for my 91 buick. You should have some knowledge about wiring before attempting that. Basically I just switched the wiring on each side inside the coil pack.https://www.google.com/search?q=buick+1991+park+avenue+firing+order&tbm=isch&tbo=u&source=univ&sa=X&ei=reisU9eSH9HioAThh4D4BQ&ved=0CC8QsAQ&biw=1440&bih=748

May 15, 2014 | 1991 Buick Park Avenue

2 Answers

97 buick park avenue change cam and crank sensor still no fire


asd relay or fuse
camshaft not spinning
bad pcm
damaged wiring harness

Mar 25, 2013 | 1997 Buick Park Avenue

2 Answers

96 buick park avenue wont start but turns ova theres no gas gettin to the engine


you probaly have a bad crank sensor. this will not let the fuel pump kick in if it goes bad

Apr 20, 2012 | 1996 Buick Park Avenue

1 Answer

Blower motor resisror where is it in a 93 park ave


I think its mounted under the hood on the fire wall beside the blower motor by the passenger, in front of the glove box.

Jan 29, 2012 | 1993 Buick Park Avenue

2 Answers

Need fire order for 93 buick park ave


Here you go. I hope this helps and good luck.


clifford224_220.jpg

May 17, 2011 | 1993 Buick Park Avenue

1 Answer

I have a 1991 buick park ave and it idles high when in park and when I'm driving


Try replacing your throttle position sensora(TPS). Had the same problem with my 93 park avenue.

Feb 09, 2011 | 1991 Buick Park Avenue

1 Answer

Firing order for 1997 buick park avenue


1997 Buick Park Avenue 3.8 liter V-6 VIN "K"

8f4ea58.gif

Hope helps (remember rated and comment this).

Sep 09, 2010 | 1997 Buick Park Avenue

1 Answer

I need to find firing order for a 1999 Buick park


1999 Buick Park Avenue 3.8 liter V-6 VIN "K"

e18bec5.gif

Hope helps (remember rated this).

Jun 19, 2010 | Cars & Trucks

1 Answer

93 buick park avenue wont shift into overdrive after a mile or so.


1993 Buick Park Avenue. The overdrive shifts in and out on flat ground. It holds o.k. when in a slight pull up grade.

Mar 07, 2009 | 1993 Buick Park Avenue

1 Answer

93 Buick Park Avenue Wont start and when it does it shuts off after a few minutes


I would try to clean the battery terminal & make sure the cables are tight

Sep 15, 2008 | 1993 Buick Park Avenue

Not finding what you are looking for?
1993 Buick Park Avenue Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...