Question about Acura Integra

1 Answer

I got problem with wipers they only work when you press down and hold they only work on high

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 127 Answers

Sounds like you need to replace wiper switch

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wipers work only on high on 2013 Toyota Tun


Gerald, Could not find a lot of info. on the net to your Tundras problem. Sounds like the wipers have a faulty wiper motor control/resistor/circuit board/switch. You may have to take it in and have a good Tech. diagnose and estimate repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Windshield Wipers Only Work on High Speed eHow
2014 Toyota tacoma adding intermittent wipers

Jul 28, 2016 | Toyota Tundra Cars & Trucks

1 Answer

1998 dodge caravan my battery was dead and after replacing it my panel lights are blinking window wiper and washer bottoms below radio


Same problem with my 98 grand caravan! Turn heater on high with air directional toward your face. Press & hold top back wiper button & bottom back wiper button (1 button between) until all buttons light up. Release buttons. Then it will go thru reset process. After a few mins. If top button is still lit up, repeat steps again. Found instructions written in back of my manual. Worked like a charm!

Oct 16, 2014 | 1998 Dodge Caravan

1 Answer

How to tighten windshield wiper nut


There should be a plastic cap covering the wiper arm nut

You may find the spline in the arm is stripped & need a complete
new arm

Feb 19, 2013 | 1998 Ford Explorer

1 Answer

1998 Dodge grand caravan .there is a module that needs reprogrammed,this happens all the time. How?


Put your controls all the way to cold(mine is all the way to left). Turn your blower switch all the way to High. Put the position to console vents(all the way left).Hold down top left button(rear wiper) and bottom left button(rear washer) at the same time until all lights are solid. Then release. Let the buttons flash until only top left(rear wiper) is flashing. Then press top left(rear wiper) to end test.Should help those pesky flashing lights unless there are deeper Problems!

Nov 17, 2011 | 1998 Dodge Grand Caravan

1 Answer

My wipers Only work on high and even then only the driver one works and not for very long the passenger one try's to work but only comes about half way up and slams back down, they also will randomly...


look at the wiper arm base,a plastic cover at the bottom of the arm. If you pop the cover off
there is a 13mm nut that holds the arm,they come loose ,just turn the wipers off and set the arms
where they should be when off and snug the nuts down

Sep 19, 2011 | 1999 Oldsmobile Intrigue

1 Answer

The lights controls of rear wiper switch is flasher


My 97 Voyager has done the same thing. It was control panel programing, the following instructions is how to program your control panel: 1) SET BLOWER ON HIGH 2) SET MODE TO PANEL 3) SET TEMP TO COLD 4) PRESS WASH AND REAR WIPER TOGATHER AND HOLD FOR 5 SEC. IT WILL GO THROUGH A SERIES OF FLASHING, WHEN DONE THE REAR WIPER SHOULD BE THE ONLY ONE FLASHING PRESS REAR WIPER TO EXIT. DO THIS WITH VAN RUNNING. This worked for my 1997 Voyager. I hope it works for yours.

Jan 24, 2011 | 1998 Plymouth Voyager

2 Answers

Lights flash on ac rec and rear wiper buttons. Put on new ac com


With my 1998 TC you have to start car turn to cold and fan on high. Tehn hold down the rear wiper and WASH buttons until the lights start flashing differently. Let it run through until only the rear wiper light is blinking. You should here it cycling through the different functions. When it is jsut the rear wiper blink press that button and the system is reset if there are no problems. A low voltafge problem had caused mine to act up.

Aug 05, 2009 | 1998 Chrysler Town & Country

1 Answer

Passager side wiper stopped working


try tightening the nut that holds the arm on .its under a plastic cover on the car body end of the wiper arm

Jun 22, 2009 | 2003 Chevrolet Impala

1 Answer

Wipers dont work on high.


you need to replace the window wiper motor.. it doesnt go high enough and stay at that speed for a long time.. its obviously defected

Jun 02, 2009 | 1994 Oldsmobile Cutlass Supreme

2 Answers

Replaced battery,now rear wiper control lites are flashing.


The procedure for re-setting the HVAC control panel on a 1998 Dodge Grand Caravan follows:
With ignition on but not running
1. turn knob to air vents
2. turn fan knob to ON
3. temperature setting on COLD (2X) {I have dual temp controls}
4. hold top(rear wiper) and bottom (rear wiper with wash) buttons pressing down together until all the buttons cycle through (this will require 1 to 2 minutes of continuous pressing)
Hopefully, this also applies to 1997 version. I learned this from a very helpful local Dodge service adviser

Jan 21, 2009 | 1997 Dodge Caravan

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...