Question about 2001 Dodge Dakota

1 Answer

Blower moter has nothing but high speed for some time now i have no blower at all

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 249 Answers

That sounds like a bad blower motor resister, undertuhe dash on the right hand side

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mini one - air vents only work when it is on full, so you have to get blasted with air or nothing at all. Any ideas?


Please check for a blower resistor problem. The fan speed is controlled by a resistor which controls blower speeds. The resistor works the lower speeds while usually high speed bypasses the resistor for full fan speed only. You either have a resistor or resistor electronic module. Google location for locaton of resistor. ( mini one blower resistor location) There is alot of info that may help you.

Oct 16, 2013 | Mini Cars & Trucks

1 Answer

2005 kia spectra blower only blows 1 & 4 speeds


Could be the blower motor resister,it's located by blower motor,2 screws hold it on,easy to remove,click here to see part.

Dec 30, 2012 | 2005 Kia Spectra

1 Answer

Blower moter will run only on high


The most common cause is a bad blower motor resistor. It attaches to the blower motor and controls fan speeds. It's typical for a bad resistor to lose 1 speed at a time until you are left with just 1 speed as you are experiencing.

Oct 30, 2011 | Cars & Trucks

1 Answer

My heater motor only works on high


A bad blower moter resistor can cause the blower to default to high speed only. The resistor is
located behind the lower right side of the dash on the heater box just left of the blower moter.
The fan switch can also cause this problem, but more often then not it's a bad resistor.
Hope this helps.

Nov 22, 2010 | 2006 Chevrolet Colorado

1 Answer

FAN BLOWER (FOR A/C AND HEAT) ONLY BLOWS ON THE HIGHEST SETTING. IS THERE A FAN SPEED CONTROL OR RELAY THAT CAN BE REPLACED, OR IS IT SOMETHING ELSE?


Hello leebarker
The blower moter switch or the blower moter controler can cause this
problem. Remove the plug from the switch, use a 12v test light to locate
the 12v power wire in the plug. Next with a small jumper wire bring power from the 12v contact to the low and medium speed contacts on
the plug if the blower changes speed replace the switch if it still only
has high replace the controler. The blower controler is located on the
passenger side end of the heat-a/c box near the blower moter.
By the way the key must be in the on position for this test.
I hope this helps. Good luck.

Jul 10, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I HAVE FORD FOCUS 2003 ZX5 BLOWER MOTOR WORKS ONLY AT HIGH SPEED


It's quite likely the the blower moter relay needs replaced. When this relay burns out you end up with off and high, nothing inbetween. I hope this helps.

Mar 15, 2010 | 2001 Ford Focus

2 Answers

My dodge dakota blower moter only runs on high all other setting don't work. whar could it be? And if it is the resister where is it located?


the high blower relay controls the high blower only
you need a new blower motor switch you control on the dash

Feb 27, 2010 | 2004 Dodge Dakota

4 Answers

What will make a blower in a car only work on high 0n a 1996 sunfire


Could be two things. Heater control..or heater switch. Or the moter is not recieving the reostat info from control. Check at heater wher wires go into it..as you change positions of switch you should see a voltage drop or increase, if u do then the moter is bad...if u do not then replace the heater control unit. :)

Sep 07, 2009 | 1996 Pontiac Sunfire

1 Answer

Blower fan


it sounds to me like your blower moter resister or your blower moter switch are going bad both are right under the hood next to the blower moter one has 2 witers on it the other has 4 it usuley on the pass side right near the window

Dec 03, 2008 | 2000 Chevrolet Venture

4 Answers

1998 GMC Sierra pickup truck cabin fan problem


Your blower moter is under your glovebox and very easy to replace.I dont think thats your ploblem.I would pull off the dash.It will snap right off without breaking anything.Then pull out the part that holds the selector switch for the fan speed.Then you unplug that switch.Clean the copper contacts.Plug it back in.If everything works again like it should and did in my truck then it is either that switch that is bad or the wiring harness.I would replace that switch.

Oct 20, 2008 | 1998 GMC Sierra

Not finding what you are looking for?
2001 Dodge Dakota Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...