Question about 2001 Dodge Dakota

3 Answers

I have a p0442 code on my 2001 dodge Dakota how do I fix it?

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,740 Answers

P0442 Evaporative Emission Control System Leak Detected (small leak)
Look for a cracked vacuum line going to your evaporative cannister. Cannisters are usually 1- 2 quarts in size and located here:
http://media.photobucket.com/image/2001%20%252522Dodge%20Dakota%252522%20Evaporative%20Emission%20Control%20canister/hammerz71/EVAPSystem.jpg (Near gas tank)
Look at items 7, 8, 9 and 10 in the picture but inspect all of the vacuum lines for damage. Somewhere there is a bad line. Most often the damage is very near clamps but if something struck the lines damage could be away from the clamps.

Kelly

Posted on Mar 22, 2011

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Expert
  • 1,114 Answers

You have an evap system leak, the most common cause is the gas cap is faulty, and in need of replacing. If this is not the case, then check your vacuum hoses.

Posted on Mar 22, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

This indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. In fact, the leak can be from a hole as small as 0.04" in diameter. The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.

Posted on Mar 22, 2011

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Mr BrokRench
  • 1623 Answers

SOURCE: Error codes P0442 and P0455 in Dodge Dakota 2001

Hello shoretex...Yes sir you can repair this yourself...
p0442 is medium leak detected ...p0456 is small leak....and p0440 is a general evap system failure.. evap codes are a common thing. gas caps are an inexpensive place to start. There are two types of evap hoses on the Dodge... hard plastic and soft rubber.... before you replace parts check the soft rubber first at the evap cans and pump located about a foot in front of the gas tank fill pipe on trucks located next to the transfer case or right behind the trans on the driver side. hard plastic lines will brake or rub through...check spots where lines come in contact with anything. this is a common thing with older trucks...hair line cracks will kick a p0442 code, and a p0445 code...When you find a leak, repair it, and rescan...sometimes there are several leaks, continue with inspection and repairs until you get it all fixed up.... Remember..start at simple and work from there...
i will post the evap. system in more detail to help you troubleshoot the problem.
EVAP System: The Evaporative Emission (EVAP) Control system used on all vehicles is the charcoal canister storage method. This method transfers fuel vapor from the fuel tank to an activated carbon (charcoal) storage device (canister) to hold the vapors when the vehicle is not operating. When the engine is operating, the fuel vapor is purged from the carbon element by intake air flow and consumed in the normal combustion process. The evaporative system includes the following components: *Fuel tank *Evaporative emission canister vent solenoid *Fuel tank pressure sensor *Fuel pipes and hoses *Vapor lines *Fuel cap *Evaporative emission canister *Purge lines *Purge valve solenoid EVAP System Operation: The EVAP purge solenoid valve allows manifold vacuum to purge the canister. The Powertrain Control Module (PCM) supplies a ground to energize the EVAP purge solenoid valve (purge on). The EVAP purge solenoid control is Pulse Width Modulated (PWM) or turned on and off several times a second. The EVAP canister purge PWM duty cycle varies according to the operating conditions determined by the mass air flow, the fuel trim, the engine coolant temperature, and the intake air temperature. For certain EVAP tests, the diagnostic will be disabled if the TP angle increases to above 75% . The evaporative leak detection diagnostic strategy is based on applying vacuum to the EVAP system and monitoring for vacuum decay. The fuel level sensor input to the PCM is used to determine if the fuel level in the tank is correct to run the EVAP diagnostic tests. To ensure sufficient volume in the tank to begin the various diagnostic tests, the fuel level must be between 15% and 85% . The PCM monitors the fuel tank pressure/vacuum level via the fuel tank pressure sensor input. Results of Incorrect Operation: Poor idle, stalling and poor driveability can be caused by the following: *Malfunctioning purge solenoid. *Damaged canister. *Hoses/lines split, cracked and/or not connected properly. Evidence of fuel loss or fuel vapor odor can be caused by the following: *Liquid fuel leaking from the fuel lines *Cracked or damaged canister *Inoperative canister control valve Vacuum hoses that are: *Disconnected *Mis-routed *Kinked *Deteriorated *Damaged The evaporative leak detection diagnostic strategy is based on applying vacuum to the EVAP system and monitoring vacuum decay. The PCM monitors vacuum level via the fuel tank pressure sensor input. At an appropriate time, the EVAP purge solenoid and the EVAP vent solenoid are turned on, allowing engine vacuum to draw a small vacuum on the entire evaporative emission system. After the desired vacuum level has been achieved, the EVAP purge solenoid is turned off, sealing the system. A leak is detected by monitoring for a decrease in vacuum level over a given time period, all other variables remaining constant. A small leak in the system causes DTC P0442 to be set. If the desired vacuum level cannot be achieved in the test described above, a large leak or a faulty EVAP purge solenoid is indicated. This can be caused by the following conditions: *Disconnected or faulty fuel tank pressure sensor. *Missing or faulty fuel cap. *Disconnected, damaged, pinched, or blocked EVAP purge line. *Disconnected or damaged EVAP vent hose. *Disconnected, damaged, pinched, or blocked fuel tank vapor line. *Disconnected or faulty EVAP canister solenoid. *Disconnected or faulty EVAP vent solenoid. *Open ignition feed circuit to the EVAP vent or purge solenoid. *Damaged EVAP canister. Any of the above conditions sets DTC P0440. A restricted or blocked EVAP canister vent path is detected by drawing vacuum into the EVAP system. The PCM turns off the EVAP vent solenoid and the EVAP purge solenoid (EVAP vent solenoid Open, EVAP purge PWM 0% ). The PCM monitors the fuel tank pressure sensor input. With the EVAP vent solenoid open, any vacuum in the system should decrease quickly unless the vent is blocked. A blockage is caused by the following conditions: *Faulty EVAP vent solenoid (stuck closed). *Plugged, kinked, or pinched vent hose. *Shorted EVAP vent solenoid driver circuit. *Plugged evaporative canister.

Good luck shoretex, hope this helps...please take time to rate me a fixya.

Posted on Jul 20, 2009

  • 296 Answers

SOURCE: 2001 dodge dakota 4.7 liter engine codes

Auto Zone will do a free code read and tell you what they are

Posted on Mar 07, 2010

  • 77 Answers

SOURCE: ihave dodge caravan sport 2001

This indicates a fuel vapor leak in the EVAP control system. It means a very small leak has been detected. .The (EVAP) emission control system prevents the escape of fuel vapors from a vehicle's fuel system. Fuel vapors are routed by hoses to a charcoal canister for storage. Later, when the engine is running a purge control valve opens allowing intake vacuum to siphon the fuel vapors into the engine.

A code P0442 most likely means one or more of the following has happened:

  • A loose or improperly affixed gas cap
  • A non-conforming gas cap (i.e. not factory/original brand)
  • A small leak/hole in a fuel vapor hose/tube
  • Other small leak in EVAP system
  • Faulty vent o-ring seal

With a P0442, the most common repair is to:
  • Remove and reinstall the gas cap, clear the codes, and drive for a day and see if the codes come back.
  • Otherwise, replace the gas cap, or
  • Inspect the EVAP system for cuts/holes in tubes/hoses
Few places to check - rubber hose under air box (requires removing the air box) and hoses connecting to EVAP system under the van on the drivers side.

Posted on Jan 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I no my solend is bad


A code P0442 most likely means one or more of the following has happened: A loose or improperly affixed gas cap A non-conforming gas cap (i.e. not factory/original brand) A small leak/hole in a fuel vapor hose/tube Other small leak in EVAP system Faulty vent o-ring seal Defective vent valve Defective purge valve Defective leak detection pump

Read more at: http://www.obd-codes.com/p0442
Copyright OBD-Codes.com

Oct 01, 2015 | 2003 Dodge Dakota Club Cab

1 Answer

P0442 EVAC SMALL LEAK DETECTED. CAN'T FIND THE LEAK


what can cause a evap leak on an 03 dakota

Jun 02, 2011 | 2001 Dodge Dakota

1 Answer

I have a 2003 dodge dakota quad cab 4.7l v-8 4x4 with p0440pd and p0442pd for engine codes that are on can't find out what they are.


P0440-GENERAL EVAP SYSTEM FAILURE, Check your vacuum hoes by the cannister close to your fuel tank.
P0442: Evap leak monitor, Small Leak Detected, check/change your gas cap should fix that problem!
I hope this helps!

Mar 05, 2011 | 2003 Dodge Dakota Club Cab

1 Answer

P0442 Evap system small leak--What does that mean and how do I fix it


P0442 Means you have a leak in your EVAP system.
The EVAP system prevents gas vapors from entering the air .
This code can be set by a leak in the lines or a clogged charcoal canister.
Most common reason is If you did not put your gas cap on all the way.
Hope this helps
Leave feedback please
thank you FixYa

Sep 20, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

Code is p0442


Try this website for resolving car problems by downloading a FREE service manual for your vehicle. This is not an owners manual but a factory mechcanic's manual.

http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

May 01, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

2002 dodge dakota with a check engine light code 442


P0442:

Small leak detected in evaporative purge system

if i had to guess I would say that your gas cap is not on tight enough or that is is bad. chrysler has had a lot of bad gas caps that cause EVAP service engine lights.

Feb 12, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

Kills unless i have it in neutral until warm then fine


http://www.obd-codes.com/p0442
click here for p0442 info

as for the stalling issue i can't think of anything that would cause that, possibly a vacuum leak?

Jan 04, 2010 | 2002 Dodge Dakota Club Cab

3 Answers

I am blowing error codes P0442 and P0456, can i fix it myself


P0442 Evaporative Emission Control System Small Leak Detected
P0446 Evaporative Emission Control System Vent Control Circuit Malfunction

You should replace the VAPOR CANISTER PURGE REGULATOR.

Oct 03, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

P0442 odb2 code


P0442 Evaporative Emission Control System Leak Detected (small leak) this could be a defective leaking purge valve or a pressure sensor switch.

Apr 11, 2009 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
2001 Dodge Dakota Logo

725 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...