Question about 1983 Ford Escort Gt

1 Answer

Help how do i get my wings off my mk 2 escort

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Hi, rub across seams with sandpaper under your thumb and you will see all the spotwelds, You can then dill them out,Make sure you dont drill through the lip of the inner wing.you can buy a special drillbit to do this,You will also need a good sharp chissel. file a v into the top cutting edge of the chissel use with v facing upwards this will cut remainder of spotwelds easier. You will need to remove doors and do the same. Hope this helps.Phil

Posted on Sep 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to no the valve clearances on a mk 2 1600 escort asap


valve clearances are 0.20 mm inlet and 0.55mm exhaust.these need to be done when engine is cold.

Jun 16, 2011 | Ford Escort Cars & Trucks

1 Answer

HEAD GASKET HAS GONE, NEED TO SEE A DIAGRAM BEFORE I REMOVE AND FIT NEW ONE ON MY FORD ESCORT RS 2000 MK 5.


you should not need a diagram. most gasket kits have the correct torque and order of torque for your fitting procedures. if unsure, put everything of in a line, then reverse to put it on . cheers goodluck

Jun 28, 2010 | 1992 Ford Escort 4 Door

1 Answer

I have three wires on a ford escort mk 2 alternator 1 thin blue and two red what do the red ones go to and how do i tell them apart


the two red wires technically join together into the 1 wire,then goes down into the starter motor solenoid i.e the live feed which then goes bk into the battery to charge the battery.

Feb 04, 2010 | 1983 Ford Escort Gt

1 Answer

Where is the heater control valve on a mk 5 escort


should be in the centre of the bulk head near the wind screen under the bonnet

Dec 02, 2009 | 1991 Ford Escort

1 Answer

How do I replace a front drivers side wing on a ford escort? Does it need to be welded at all?


as far as i remember they were screwed on, remove grommets (small plastic covers) and remove screws. hope this helps.

Sep 05, 2009 | 1999 Ford Escort

1 Answer

1995 ford escort lx fan relay locations


right hand side under bonnet on the wing or at the back by the battery depending on model build

Nov 10, 2008 | 1995 Ford Escort

1 Answer

Fuel shut off switch


Hi

Try the boot. Thats where they used to put them. Possibly under the spare wheel.

Have a good root around in there.

Regards

Geordie

Jun 20, 2008 | 1996 Ford Escort 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...