Question about 2005 Nissan Sentra

1 Answer

Blower wont blow high or low speed, and is not the fuse?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 127 Answers

Blower motor relay. blower motor doesn't have fuses only the relay controls are fused. change blower motor relay High and low have separate relays

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is an AC diode fuse? I have a 2006 AWD Pontiac Torrent the AC/Heat doesn't work, I've changed all fuses for the HAVAC and still no AC/Heat blowing out of vents. What could be the problem?


Could be a number of thing's ! Testing the electrical circuit is the way to find out what's wrong . Using a wiring diagram and a DVOM - digital volt ohm meter . Videos on youtube showing how to test it ! Without testing i would only be guessing . Does it work in high speed ? In high speed it by-passes the resistor . If it doesn't work in any speed more then likely the blower motor is the problem !
Air Speed
The HVAC control assembly applies ground to the blower motor control circuit that corresponds to the selected blower speed. The resistors and the blower motor are in a series circuit. The following list represents the number of resistors in series with the blower motor per particular speed request:
• Low speed--3 resistors
• Medium 1 speed--2 resistors
• Medium 2 speed--1 resistor
When the operator requests High speed, the HVAC control assembly applies ground directly to the blower motor through the high blower motor control circuit. The resistor card has a fusible link which, if blown, will require that the card be replaced.

Blower Motor and Resistor Diagnostics by Wells

Jun 11, 2017 | Pontiac Cars & Trucks

1 Answer

Ac blower motor stopped working


YJ car.
the blower is dead. is that it?
does it blow full speed on high
do you have 12v on terminal A of blower , term B is 0v ground
got that, then the blower is dead.
if not 12v, then the controls are bad.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

page 47
4 parts to make blow
1: fuse 12 good.
2: switch heater /on off.
3: high, med,low speed, use high, its direct.
4: the blower,
one of those points has no 12v on high,
use a simple voltmeter to find the failed point.

Jan 14, 2014 | 1994 Jeep Cherokee

2 Answers

Blower fan not working


The resistor bank is bad for slow speeds, the switch is bad for high speed. In your test, you have voltage, but the switch wont carry the amps, to run high speed. Open circuits will not blow fuses. Replace both switch and resistor bank for all speeds. Make sure to clean leaves and trash from fan housing and see if fan spins freely.

May 17, 2017 | Cars & Trucks

1 Answer

Why wont my a/c or heater fan come on?


When the blower works only on the high setting its usually a bad blower resistor which is right near the blower motor. now you say it would always blow high regardless of the fan speed setting that would indicate probably the climate control unit or a connector problem somewhere. finally it not working at all may be the climate control unit or connection went bad even further. it might have a blown fuse or a bad blower motor in addition to the climate control unit or connector problem .check for power and ground at the blower motor. the power is supplied from fuses and may have a relay also. the ground is supplied from the climate control unit and goes through the resistor to control the fan speed. good luck

Oct 30, 2011 | 1997 Lincoln Continental

1 Answer

1992 gmc pickup keeps blowing heater fuses I replaced the blow motor and it keeps blowing


Have you replaced the blower resistor . some times they can cause the fuse to blow . You may need a muiltmeter to test the current draw on the blower motor circuit. the draw should be less then half of the rated fuse .( 20 amp fues draw is less then 10 amps) You did not say but does the blower work on high only or the lower speeds with out blowing the fuse ? if it does work on low or high with out blowing the fuse i would replace the blower resistor

Mar 06, 2011 | GMC Sierra 1500 Cars & Trucks

1 Answer

The airconditioner only works in my 2006 H3 when the car is physically moving over 25 mph. If it is going slow or idling there is no air coming from the blower/fan. When it does blow it is only on a low...


There is a HVAC relay and FUSE in the under hood fuse box, have you check both of these? If the blower works on any speed, the blower is good. You say it blows on lowest speed? The blower speed resistor is mounted on the blower housing. The HIGH SPEED BLOWER RELAY is mounted on the blower motor. You may have multiple problems but check fuses first, if all is OK, then a qualified repair shop will need to check further. You do NOT need the whole A/C system replaced. If it does blow cold, thats good, you just need the blower working.

Nov 03, 2009 | 2006 Hummer H3

3 Answers

A/c fans wont blow


If the fuse is blown for the blower then there is a short, that is not an answer, go to the blower and check to see that the blower motor connector has 12 volts to it when the blower is set to high speed on control, if it does then u need a new blower motor, if it doesn't then the control switch is defective or the blower motor speed control resistor is defective.

May 13, 2009 | 2000 Mercedes-Benz S-Class

1 Answer

Car heat blower is not blowing heat/air into the car


it's either a fuse or it's a bad blower motor, it could be a bad blower motor resistor but usually you'll get either high or low only, so if you have nothing on any speed, high low etc, and all the fuses are ok chances are it's your blower motor.

Jan 16, 2009 | 1999 Audi A4

1 Answer

Car heat blower is not blowing heat/air into the care


it's either a fuse or it's a bad blower motor, it could be a bad blower motor resistor but usually you'll get either high or low only, so if you have nothing on any speed, high low etc, and all the fuses are ok chances are it's your blower motor.

Jan 16, 2009 | 1999 Audi A4

Not finding what you are looking for?
2005 Nissan Sentra Logo

Related Topics:

524 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...