The impeller can fall off the water pump internally and it will not leak, but no coolant will circulate.
If you need further help, reach me via phone at https://www.6ya.com/expert/jason_e95d2f9c1ac9610d
SOURCE: how do I replace the transmission coolant lines
Take a small 90 degree pick. Inspect the fitting closely. Use the pick to "roll" the retaining clip off the fitting. The line will simply pull once this is done. U can install the clip first on reinstallation (inspect them closely) and then simply push the line into the fitting. It will "click" into place. Note u will have to orient the line perfectly to push in.
SOURCE: Drain Engine Coolant in 2005 Chevy Silverado 2500 HD
there is a petcock at the bottom of the rad drain ti from there and use a antifreeze tester to check protection temp
SOURCE: I have changed my transmission filter and fluid
CHECK TO SEE IF THERE IS AN OVERDRIVE SWITCH LOCATED IN THE SHIFTER! USUALLY YOU CAN PUSH THIS SWITCH TO DISENGAGE THE OVERDRIVE, OR RE-ENGAGE IT!
SOURCE: i'm changing the transmission fluid
no need, just drop the pan and replace filters and gaskets. add 4 qts start and check fluid level, add till full
226 views
Usually answered in minutes!
×