Question about 1991 Eagle Summit

3 Answers

On a 1991 eagle summit, how do i remove the knob for rolling down the window to get the door panel off?

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 56 Answers

Their is a special tool that's used,you can get one from most auto parts stores,or you can go to BestBuy and ask car stereo installer to remove the handle.You dont need the tool to put it back on,it just snaps back on. Hope this helps you

Posted on Mar 22, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Eagle Master
  • 22,114 Answers

If you prise the inside piece back a bit and look at the back of the winder you might find a metal horse shoe type clip ,this is the most common fixing for a vehicle of this age ,if it has one then make a small sort of a hook up with a thin nail or a piece of fence wire to pull it out and watch where it pings too as they always disappear when i take them off sometimes up to 20ft away

Posted on Mar 22, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Expert
  • 1,114 Answers

Use a flat head srewdriver to pull the handle away from the door panel, and you will see a C clip that is holding the handle to the window crank shaft. Take another flat screwdriver and pop the C clip out. To reinstall the handle, put the C clip in place on the handle, then gently tap it into position on the window crank, and it will snap on.

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 91 Eagle Summit will not shift after 2nd gear can not figure out whats wrong or if it's something to do with the PCM or the electronic Control unit any idea's on what to look into first?


Your transmission is in limp mode. It will only shift into second and remain there. About the only thing you can do is bring it to a transmission shop, but I can tell you you will need a rebuild or a new/used transmission. Realistically it will cost at least $1K to repair.

Sep 17, 2013 | 1991 Eagle Summit

1 Answer

1991 Eagle Summit leaking fluid on Driver's side


It's likely the radiator, like you think.

Apr 16, 2013 | 1991 Eagle Summit

1 Answer

Trying to get diagram of 1992 eagle summit 2 door hatchback ecm wiring


Autozone.com has free diagrams in their repair section. They may have what you need.

Sep 10, 2011 | 1992 Eagle Summit

1 Answer

I need to replace the driver side door knob. I beleive I will have to remove the door panel. How do i do this? Ir is a 1991 Honda Accord EX.


Leave the window rolled up:
remove the door panel
remove the lining
remove the two bolts 10 millimeter
you may need wiggle the latch out and unhook it from the outside of the door or you may have to reach up inside to remove the latch
Good Luck Tim

Apr 17, 2011 | 1991 Honda Accord

1 Answer

CAN NOT REMOVE DOOR PANEL


after removing door handles,arm rests, etc.,roll down your window,the panel will only come off after the window is rolled down.push the top of the panel towards the window,there's a piece of trim connected to the top of the door panel that hooks to the top of the inner door

Nov 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

I am having a problem with the roll down window on the right rear door of 1991 Escort


the gears inside the door probley have to be greased remove the door panel leave window up and inspect for broken parts

Mar 23, 2009 | 1991 Ford Escort

1 Answer

The right rear electric window won't roll up all


the window regulator is going bad,it has a up cable and a down cable so I would replace it before it wont go up at all,they are pretty inexpensive around $70.00 at a decent parts house,its a pretty simple job, remove the door panel,locate window to regulator bolts.remove them,take glass out thru top, locate 3 bolts that hold motor assy. remove them take bolts holding regulator in place remove them,take motor and regulator out thru holes in door.you can do it! have a good day DB

Feb 27, 2009 | 1991 Honda Accord

1 Answer

Trying to remove driver side interior door panel on '88 Toyota PU


There is a cotter pin in the window crank, a pair of needle nosed pliers should be able to grab it

Dec 02, 2008 | 1988 Toyota Pickup

1 Answer

Manual window won't roll up


so is the right rear door ??
if so here are some instructions.
  1. If applicable, remove the regulator handle by pulling the clip out with a wire hook.
  2. Remove the inside door handle and disconnect the latch rod.
  3. Remove the screws and detach the clips attaching the door panel (see trim pad remover.
  4. Disconnect the power window and courtesy light harnesses.
  5. Remove the door panel bracket and carefully remove the plastic cover
  6. Remove the screw attaching the door lock crank. Disconnect the latch rod from the latch side.
if you have an email address i can send some images on how to do it.
hope this helps

Jun 07, 2008 | 1991 Honda Accord

Not finding what you are looking for?
1991 Eagle Summit Logo

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Stewart Dibbs

Level 2 Expert

302 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...