Question about 2005 Toyota ECHO

1 Answer

The rear water pump does not pump water onto the windscreen I dont have the owners manual and dont know how to fill this rear tank up or if it runs thru from the front one

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Auto Scaner The rear water pump does not pump water onto the windscreen I dont have the owners manual and dont know how to fill this rear tank up or if it runs thru from the front one

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windscreen washer leaking under drivers side since hard frost and jets not operating but motor sounds ok, how easy to check / replace water resevoir


Procedure to change the windshield washer tank or pump on an E46.

Tools needed: 10mm spanner (in toolkit), small-medium flat blade screwdriver

Undo the 10mm nut, highlighted in the red circle. This is the only fastener holding down the washer tank. Lift the tank up about 4", allowing you to unclip the black plastic heatshield around the washer pump. This is where you need the screwdriver, to lift the securing tab from the washer tank (yellow circle). You can actually pull out the complete washer pump from the tank. Just gently pull up, it is a friction fit.

Now unclip the washer level sensor plug (green circle). This clip is a little difficult to figure out. I pulled it hard and it came off. Taking a closer look at it once it was off, I couldn't quite see how to unclip it from its securing catch.

At this point you have removed the washer tank. The two tabs at the bottom of the tank fit into recesses in the body work, in order to secure the tank. There is a filter screen in the tank, where the washer pump plugs into the tank (blue circle). Just pry this up with a screwdriver to remove it. I had bought a new one, just in case. You can see the fluid level sensor socket on the left side of the tank in this pic.

Now unclip the pump connector from the pump. Pinch the tab at the top of the connector. This will unclip the connector from the securing tab. Pull out the water hose from the nozzle on the pump

Replace the pump filter screen into the tank, if necessary. Plug in the new washer pump into the filter screen. Connect the water hose back onto the pump.

Position the washer tank into its approximate location and clip the sensor for the fluid level back into its socket on the tank.

Secure the heatshield back onto the tank.

Now position the washer tank into its secured position and fill with a little water, in order to test the pump out. Fasten the 10mm screw back into the plug.
Attached Thumbnails attachment.php?s=c787447079490cef122b8106459565a0&attachmentid=58887&stc=1&thumb=1&d=1128905455 attachment.php?s=c787447079490cef122b8106459565a0&attachmentid=58888&stc=1&thumb=1&d=1128905493 attachment.php?s=c787447079490cef122b8106459565a0&attachmentid=58889&stc=1&thumb=1&d=1128905680

Dec 07, 2010 | 2003 BMW 330

1 Answer

Just been given a friends car to drive - Daewoo Lanos and I would like to check the water... where do I fill it? I can see the Coolant tank and the windscreen well but cant seem to see where to fill...


Dont use water. Pressurized system requires coolant/water mixture to maintain proper boiling point. Coolant is added to coolant tank you have identified, there is no direct fill to the radiator, it fills out of the coolant tank.

Jul 07, 2010 | 2001 Daewoo Lanos

1 Answer

Rear washer and front washer pump not working nissan terrano


On the Terrano's the washer pump that controls both the rear window and the headlight washers are fed from the same water reservoir found closest to the front of the vehicle. The one closest to the windscreen is for washing that windscreen but the larger one to the front washes both of the area's mentioned in your posting. On that unit there are two seperate pumps, one for the rear and one for the headlights. These have a tendancy to stop working through a variety of reasons. To check out the wiring a "Multimeter" is needed. Put the multimeter onto 12V if there is a setting for that on yours, if not put it onto 24V as most have that setting. Disconnect the wiring harness closest to the water reservoir and try each pin within the connection leading TO the reservoir. Attach one lead of your multimeter to an "Earth/Ground" point on your chassis and use the red lead to test each pin for voltage. If no voltage is found then try all of your fuses found near the drivers right knee area, but if voltage is found then try removing the pumps from the reservoir and purchase new ones that match. Usually a "Generic" model for the pump will be found to fit. I know I was able to find one when this same thing happened to me.

Hope this helps.

Feb 25, 2010 | 1998 Nissan Pathfinder

4 Answers

2003 kia rio- water pumps


I would follow the mechanics recommedations. I think he's taliking about the cam and crankshaft seals. Yes the water pump should be replaced as well. The pump that sprays windshield washer fluid onto the windshield is called the windshield washer pump. The water pump is on the engine and pumps water (coolant/antifreeze) through the engine to the radiator and heater core.

Oct 29, 2009 | 2003 Kia Rio

2 Answers

Second hand truck, no owners manual - gas tank size?


This truck should have an 18 g tank. It is not likely to have been changed.

Jul 14, 2009 | 1991 Ford Ranger Supercab

3 Answers

Peugeot 1007 windscreen washer water jets


Hi

It is usually the fuse. This blows very easily.(eg Ifyou operaten the washers when the fluid is frozen or partially frozen)

Look in your handbook. And in the fuse box in the engine compartment

Regards

Vince

Jun 11, 2009 | 2006 Peugeot 405

2 Answers

Horn plus rear windscreen wiper not working


i presume you mean wiper water pump... first locate the relays for the horn and rear wiper and replace them... usually found in the fuse panel under the dash... then fill up the rear water resevoir for the back wiper and try it again.

Robert

Jan 11, 2009 | 2000 Ford Focus

1 Answer

Back windscreen water filler


unless your van is different than my 2006 sl you fill it under the hood in the washer fill (passenger side). If the rear doesn't work it sounds like a clogged line.

Jul 05, 2008 | 2006 Nissan Quest

3 Answers

Refill back windscreen wiper with water


i didn't know there was a seperate one i have same car and mine u just fill in the front under hood and hose goes to back and it's fine.

May 24, 2008 | 1995 Subaru Legacy

Not finding what you are looking for?
2005 Toyota ECHO Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...