Question about 2002 Chrysler Sebring

1 Answer

I change my timeing belt now my car will not start

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Are the timing marks aligned properly

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Zx2 ran fine for a bit after timing belt change, now no start.


suspect the timing belt tension was to low and has jumped a few teeth initially(run rough) and then jumped further or stripped teeth(will not start at all).
check timing belt position setup....
if its 1-2 teeth out of timing you could put a new belt on with engine correctly setup.
.if its completely wrong the your engine will have internal damage(valves bent and pistons dented)

Nov 17, 2013 | 1998 Ford Escort

1 Answer

When do i replace the timing belt on my seat inca van 2004


Those belts are usually supposed to be changed every 60,000 miles. Behind the timing belt cover is your water pump. They can make noise when going out, but usually a timing belt makes no noise, just breaks. If you ever have to change the water pump, it is always suggested to change the timing belt as well. VS. If your timing belt gets stretched, it will make a bit of a noise, but your car will start running poorly at the same time. Hope I was helpful

Jan 08, 2013 | Cars & Trucks

1 Answer

Changed timing belt now it will not start. is there a reset


Something was not 'connected' or 'timed' correctly. Also check your fuses.

Dec 31, 2012 | 1999 Mazda MX-5 Miata

1 Answer

After changed a new water pump,timing belt,idler pully,tensioner for 2004 lexus ls 430, when start engine has a noise look like from pully


COULD BE A BAD BEARING IN THE IDLER PULLY OR THE TENSIONER ON THE TIMING BELT OR THE SERPENTINE BELT. IF ITS A SQUEEL IT MAY BE SOME COOLANT GOT ON THE SERPENTINE BELT. TRY TO WASH THE BELT WITH WATER AND LET DRY COMPLETELY. IF NOISE REMAINS RETURN TO THE SHOP THAT DID THE WORK.

Jul 17, 2012 | Lexus LS 430 Cars & Trucks

1 Answer

Kia rio not starting


Timing belt should have been changed at 60,000 miles. A loose timing belt or teeth missing from synchronous belt will lose timing. Damage to valves can occur if timing is not correct.

May 29, 2017 | 2004 Kia Rio

1 Answer

Harmonic balance pulley came loose.broke both belts on alternator and power sterring pump. one of the belts wore a hole in my timing belt cover.part of the belt got intertwinded with the timing belt.the...


If it ran prior to removing the distributor, it maybe 180 degrees out. Remove the cap, leave the rotor in place, loosen the bolt and lift it up,turn rotor until it is on the opposite side and place it back in.

Mar 25, 2017 | 1989 Toyota Camry

1 Answer

Went to start my car this morning been running fine and it will crank but wont start the maintance required flashes 10 times then goes off it is a 2004 honda accord lx


Timing belt ever been changed? Sure does sound like the problem. An old belt will snap on a cold start. Might want to look to see if the belt is tight and in place. These belts break regularly on Hondas with over 70,000 miles on them. Timing Belt change interval is 50,000.

Feb 11, 2010 | 2004 Honda Accord

1 Answer

Car wont start possible jump timing


car wont start could be many things.your timing belt change is due at 60000 miles.if you at a 100000 miles and not change it.you timing belt have a tensioner that keep it tight. .when it wears it loses tension and cause timing belt to slip time.i would check fuel system and ignition system for spark first before having.timing belt change. its going to cost you.

Jul 15, 2009 | 2001 Hyundai XG300

Not finding what you are looking for?
2002 Chrysler Sebring Logo

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...