Question about 2000 Toyota Celica

2 Answers

The electric aerial on my 1999 Celica will not retract, making a horrible grinding sound, though it did go down once, but stuck again now, is the only option to replace it ?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 880 Answers

Yes. The plastic gear tape is faulty.

Posted on Mar 22, 2011

Unplug it for now
Replace when you want

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When the key is in the ignition, It won't go back to the Run position from the start position causing a grinding sound to happen.


Sounds like a bad spring in the ignition cylinder or the ignition switch itself isn't returning the key and switch to the Run position as it should. Most any auto repair facility can check and replace the switch for you. Note that the ignition lock cylinder (where you put the key in and turn) is NOT the switch. The switch is connected by a linkage up to the lock cylinder. The cylinder moved the linkage and the linkage moves the switch.

It would not hurt to squirt some WD-40 or other spray lubricant in the lock cylinder to see if that resolves the problem. Don't use lithium grease though, only use a light lubricating oil spray, and don't go crazy with it. Just a couple of squirts.

May 03, 2015 | Cars & Trucks

2 Answers

Horrible engine knock in 1995 toyota celica


Check for oil pressure.Check the compression in each cylinder.
Yank the valve cover to see if the camshaft is actually turning during cranking mode,only.
Disable the fuel pump or disable the spark(fuel disable preferred)
The engine may have "eaten" something it shouldn't.
A valve may be broken off inside the cylinder head.
Usually an exhaust valve.

Feb 21, 2013 | 1995 Toyota Celica

1 Answer

Aerial has stopped working


It sounds like your aerial mechanism is worn out ,or needs lubricating ,if you can get to it open the casing and add a finger full of petroleum jelly this should be ample lubricant and you may have to physically move the aerial down ward to get it to work again .

Aug 28, 2012 | Daewoo Lanos Cars & Trucks

1 Answer

1996 toyota celica convertible antenna replacement


a rubber duck type aerial is best(the b......s can"t rip it off)and the good news is you can but them with the offset grommet as standard at most accs shops.start at the aerial end and tape one end to the other so that you can pull it through.

May 08, 2010 | 1996 Toyota Celica

1 Answer

Electric aerial on 1998 Toyota Celica


The grinding noise means that the gear in the motor slides over the retracting shaft, you will probably need to get a new one.

Apr 19, 2010 | 2000 Toyota Celica

1 Answer

1998 Gen 6 Celica. Recently replaced aerial motor.


YOU COULD HAVE BLOWN A FUSE CHECK FUSE BOARD .

Oct 21, 2009 | 1998 Toyota Celica

1 Answer

Rear-end grinding noise in 1993 GMC Sierra 1500


your description sounds like the gears inside the the same differential you just replaced.

Oct 13, 2009 | 1993 GMC Sierra K1500

1 Answer

I have just bought a lovely mazda 323F (s reg) however the electric aerial won't go up even though the motor (and the stereo) appears to be working. I have put some WD40 on it, is there anything else I can...


Does the antenna motor make any sound when you turn on the radio? (you should be able to hear it when it goes up and down. If you hear nothing, the antenna motor should be checked, as it may have burned out. If you hear something, the gears have probably stripped, so the motor runs, but won't extend and retract the antenna. countrycurt0

Oct 08, 2008 | Mazda 323 Cars & Trucks

2 Answers

2000 Celica making grinding noice from right front wheel.


you need to change the wheel bearing. you need to pull out the whole hub and the bearing has to be pressed out and in again with a new one

Aug 25, 2008 | 2000 Toyota Celica

Not finding what you are looking for?
2000 Toyota Celica Logo

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...