Question about 1999 Dodge Intrepid

1 Answer

Headlights brake lights and radio does not work but fuses are good

Posted by on

  • 9 more comments 
  • itsyaboinate Sep 11, 2008

    I have the same problem and it just happened to become a problem right after i installed a stereo.

  • kittycat346 Sep 22, 2008

    It's funny but I have the same problem after installing a new stereo. I even replaced all the fuses to see if that might be it and it fixed the lights but no radio still.

  • donner06 Dec 04, 2008

    everything but my radio works and I checked all the fuses?????

  • Anonymous Jan 04, 2009

    yea all fuses work no radio and its all lit up like its on.

  • Anonymous Jan 28, 2009

    same thing happened after i installed and removed an hid kit the highbeams work though

  • Anonymous Feb 02, 2009

    My brake lights stopped working. I have replaced the bulbs and checked the fuses (not easy to figure out which was brake light - still not sure but checked M13, 37 and 34) and all are okay. Does anyone have a solution?

  • Anonymous Feb 02, 2009

    I have the same problem, no brake lights. Have replaced bulbs, and checked fuses (M13, 34 & 37 - not sure which is correct but they were all okay). Any suggestions?

  • GMoney P Feb 25, 2009

    I have a recurring issue of my brake lights going out all the time for my 2007 Dodge Nitro, I have taken it to the dealer on all occassions to replace and it still burns out. Radio was not working properly too and had that replaced, worked for awhile and now doesnt work again, going outside to replace yet another brake light! Can you say electrical problem? Too bad dodge doesnt want to acknowledge it as such! Hmmph.

  • Anonymous Feb 26, 2009

    break lights not working checked all fuses all are good .bulbs are new.

  • Anonymous Mar 09, 2009


  • Anonymous May 05, 2009

    i have the same problem lights don't work it's fustrating me i've had like 4 guys look at it and can't find what it is.



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Electrical wiring trust me ive been through it regret buying this car..

Posted on May 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1992 Subaru Legacy. The tail lights will not come on anymore. The lights work fine when I apply the brakes, but not when just running

Did you change the radio recently..if so you tapped into the wrong wire...and if not then I would say you have a bad headlight switch or a broke ground dome where

May 28, 2014 | 2000 Subaru Legacy

1 Answer

No headlights, tail lights, running lights, turn signals, dash cluster, interior lights and no radio. Hazards work and brake lights work when brake applied. What to do. Fuses are good but no power tofse...

Hi Luis
Some Chevrolets have two fuse panels. One under the engine hood,and another in the side of the dash or under back seat...check this,and if so,recheck those fuses acording to the diagram on the lid. 2nd....check for short to fuse panels...good luck

Nov 01, 2013 | 1988 Chevrolet C/K 3500

2 Answers

1994 dodge dakota my headlights and tail lights and brake lights don't work my abs and parking brake lights are on my dash lights don't work either I replaced the headlight switch and still no

These are all different circuits. The brake lights are on a 10amp fuse - the headlights are on a 50amp fuse - and the parking and dash lights are on a 20amp fuse.
Do you have power going into the headlight switch and the brake light switch ?

Jan 29, 2013 | Cars & Trucks

1 Answer

I have a 99 Jeep Grand Cherokee Limited i have brake lights that work when i apply brakes, but as as soon as i turn my headlights on the fuse blows and i have no working tailights with the headlights on. ...

There is definitely a short in the park lights system. Did you just have a radio installed....since the illumination wire sometimes gets grounded and will cause that fuse to blow until you fix that wire.

Aug 17, 2011 | 1999 Jeep Grand Cherokee

1 Answer

Headlight,brake lights and radio light is out.

An over charging condition can burn out bulbs. Are the turn signals flashing faster than normal? Either way I would have the generator voltage checked. You acan do this with a simple volt meter accross the battery with the engine running but have somone hold the throttl open just off idle for the test. Also you can check in with Advance Auto parts or others, they will check your charging sytem for you for free I think.

Good luck

Feb 06, 2009 | 1999 Mitsubishi Mirage

1 Answer

Geo tracker lights and radio not working

power loss.
any good car elect. tech find this pronto.
just takes a volt meter to find the voltage drop point.

top fails:
1: corroded fuse box on right front finder (under fuse box)
2: did you say it kills motor too. cant figure above.

what about heater fan, it uses tons of current.
as does HL followed by tails.

20amps, 15amps and 5amps respectively

you have resistance some where.
and load , kills the voltage .

for me.
check battery voltage , when it dims out.
then of ok 12.5v is ok key on,not started.
then check voltages at a right fender , fuse panel
all points there, 12.5vdc , same as battery v.
if OK
check voltage at the fuse above right knee
with load full, hl, fan, brakes, just key on.

now you know what circuit is fail ing by now.

report back with this facts.

Oct 16, 2008 | 1991 Geo Tracker

1 Answer

I have check all the fuses I can think of and just replaced the headlight relay fuse and I still have no headlight. A friend of mine jump started my car the other day and touched the jumper cables...

I would replace the bulbs wich dont work and take the radio out and see if there is a fuse behind there as there usually is as this could of blown causing the radio not to work.

Jul 30, 2008 | Plymouth Sundance Cars & Trucks

Not finding what you are looking for?
1999 Dodge Intrepid Logo

Related Topics:

198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides