Question about 2000 Mercury Sable

1 Answer

Fuel neck replacement. How much is the part, what would be reasonable to repair($)?

Posted by on

1 Answer

The parts will only be avail at a dealers
parts counter,go there for a price

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I replace the fuel neck?


The fuel neck is attached to the fuel tank using a hose connection and clamps. The other end where the fuel enters is attached to the body using small bolts. You will have to look up inside the panel area to see these bolts. The fuel neck may be extremely diffucult to loosen/remove from the hose connection at the tank as years of weather/elements will cause the hose connecting the two to become hard and will not want to come apart. Although a fairly simple repair, there will be a moderate level of diffuculty seperating the old filler pipe to install a new one

Mar 10, 2016 | 1996 Chevrolet Blazer

1 Answer

Fuel filler neck on 2004 Dodge Intrepid sxt


Most fuel fillers have a couple of screws inside the cap area ,i think your being fobbed off try another local garage ,one thats knows what their doing .

Jul 24, 2013 | 2004 Dodge Intrepid

1 Answer

Gas tank


When you say it only leaks when you fill it up - do you mean WHILE you are at the pump, adding fuel to the tank , or WHEN the tank is full??
If it happens during refueling, the filler neck may have rusted allowing some fuel passing thru it en route to the tank to leak out. The filler neck can be replaced - and may even be subject of a recall. Contact you dealer to make sure it hasn't been recalled for these types of problems before spending *your* money to fix a manufacturer's defect.
Many times, this indicates a tank that has a hole near the top of the tank - which is much better than one at the bottom. There are products - and professionals - that can repair (or replace) these problems / parts. Locating and accessing the hole can be another story however.
Removing the tank for repair / replacement can cause you to incur additional expenses to replace fuel senders, etc. that seem to be fragile enough to break during removal.

Jun 06, 2013 | Mercedes-Benz E320 Cars & Trucks

1 Answer

Takes forever to put fuel in


Check for a crimped fuel vent hose on the filler neck. System is
a closed type for emissions but there is a vent hose running from
the tank back up close to the fill spout. You will have to get under the truck to check. This hose runs over the top of the frame to the top of the fuel tank. For easier repairs than dropping the tank remove the bed bolts on the drivers side and loosen the 2 on the
passenger side. Remove the screws holding the filler neck in and
have someone help you lift the rear body drivers side. You can block this up for easier access to the top of the tank. Also easiest
way to replace fuel pump when needed

Sep 07, 2010 | 2005 Chevrolet Silverado

1 Answer

What can i do to fix the problems of po440,441 and 446?


Hello, and welcome to FixYa. Please allow us to assist you.

You have a verry common condition; we see this quite often.

The codes you mention are usually caused by one (or a combination) of the three things that follows.

1. You do not have the 'factory' fuel tank cap fitted to the car; 'Aftermarket' fuel caps do not seal properly, and the leak of thefuel fumes under the cap will light the light.

2. The o-ring that seals the cap to the fuel filler neck is worn, or otherwise compromised, which will also allow the fumes to escape and light the light.

3. There could be rust on the filler neck tube, which would not allow a tight seal between the cap
s o-ring seal and the filler neck.

I would recommend replacing the fuel cap with a factory replacement, and inspect the filler neck sealing surface for rust buildup. If you see rust, a replacement filler neck will be in order.

Thanks for choosing FixYa fo assistance today.

Jun 10, 2010 | 2001 Toyota Corolla

1 Answer

Need to put out Check Engine Light


Sensor diagnosis? there is no sensor for the fuel neck, there is a pressure sensor that reads air pressure for the fuel tank, How do you know it needs a fuel neck? unless there is a crack, or a rust hole, I cant think of a reasone to replace it. you should be able to replace it if needed, A dealer will need to get that, or a salvage yard.

Oct 17, 2009 | 1999 Isuzu Rodeo

4 Answers

Gas leak on fuel filler neck, how can I fix this?


if it's a hose or pipe go to dealer or junk yard get another if broken clamp replace if neck part of tank call rad shop see if the can solder if you drain & pull tank

Aug 30, 2009 | 1995 Buick Regal

1 Answer

Is it Realistic to replace fuel tank neck on my car


if you have ever done mechanical work its not bad undo it at the tank then there are 3 screw around neck inside filler door remove cap first then undo any attaching vacuum lines and install new one

Aug 23, 2009 | 2002 Hyundai Accent

Not finding what you are looking for?
2000 Mercury Sable Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...