Question about 1996 Chevrolet S-10 Pickup

1 Answer

Have a 1996 chevy s 10 4cyl with manal trans cant get cabel un hooked from the trans help plsss

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I believe the hydrualic line has a fitting like air tools you have to push back on the outer sleave and it should release,, auto zone may have the tool

Posted on Mar 30, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is transmission vent tube for 1996 chevy K1500 - suspect it is clogged but cant find it


vent from trans comes out of trans on the passenger side of the trans.it is located about 1/3 the way back on top of the trans.a rubber hose will be attached and usually connects with the transfer case vent hose.If the trans overheated chances are there is a problem with the transmission.if the fluid smells burnt you have bigger issues.

Mar 09, 2014 | 1996 Chevrolet K1500

1 Answer

96 Cavalier Auto Trans left turn and stop


Trans fluid maybe low, and/or trans filter stopped-up. Drop pan...change filter...replace fluid.

Oct 03, 2012 | 1996 Chevrolet Cavalier

1 Answer

1996 chevy blazer wiring diagram for a valet 712t


Is this an aftermarket installation then?

Jul 04, 2017 | 1996 Chevrolet Blazer

1 Answer

I have a fule pressure tester and cant find where to hook it up on a 1996 chevy corsica 2.2L.


hook it up to the to the schrader valve on the fuel line. on top of engine.

Aug 28, 2011 | Chevrolet Corsica Cars & Trucks

1 Answer

Hello I have a 1996 chevy truck 5.7 with a automatic trans and I just replaced the intake manifold gaskets, it runs really good but now the transmission slips in third gear.. did I hook somthing up wrong?...


There isn't anything related to the trans from the intake manifold other then the shift cable support bracket. Check to see if the adjustment of the cable was disturbed when the gasket was replaced, it may not be fully in drive.

Mar 17, 2011 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

1996 chevy blazer


no the safty switch is to stop you starting it up in gear,,and then running yourself over! if you took it off it must be shorted out or the car wont start in any gear

Feb 23, 2010 | 1996 Chevrolet Blazer

1 Answer

I have a 95 ford escort wagon with a auto trans,, I was getting on a road and there was a bang,, nothing,,,the motor runs, theres fluid in the trans(still red and smells good not burnt) I have no gears...


typical problem is the pump shaft and gear in the transmission,i cant remember if it can be changed with the transmission in it,its behind the pan on the drivers side,i pulled a transmission out of a 95 escort to fix the same problem a few years ago that had 150,000 miles on it and it drove to California and back with no problem

Jan 30, 2010 | 1995 Ford Escort

1 Answer

Engine fan for 1996 chevy cavalier wont run I just discovered i have the same problem but with my 1996 chevy lumina, 3.1 V6, my mechanic that had just replaced my cracked head and gaskets, noticed that...


ok there is a sensor the one control the fans but you can find a load information just go to autozone.com and aalso you can find the location of the sensor too

May 16, 2009 | 1996 Chevrolet Lumina Mini

1 Answer

1998 Chevy Cavalier ETS OFF always on and Check Engine light on


you have an senser bad'' you can un-hook the batter for a few seconds or longer and it will reset the system'''and see what happens''''''my names is james e-mail me back if this helps at'' jay_win2002@yahoo.com p.s. un-hook the ground cable '''not the pos.'''''

Jan 30, 2009 | 1996 Chevrolet Cavalier

Not finding what you are looking for?
1996 Chevrolet S-10 Pickup Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...