Question about Jeep Cherokee

1 Answer

Location of throttle body sensor on 89 jeep cherokee

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 878 Answers

Look to see if you see any wire coming from throttle body the sensor is a small little black box which is held down by two tiny screws

Posted on Mar 21, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Throttle position sensor on jeep cherokee


If you are wanting to know where it is located, it mounted on the throttle body at the end of the throttle shaft. If you want to check it

Jul 12, 2014 | 2002 Jeep Grand Cherokee

1 Answer

Where is the throttle position sensor on my Jeep grand cherokee limited 6 cly. located


TPS is on the rear of the throttle body the throttle shaft that is attached to the gas pedal cable passes through the TB and goes directly into the TPS.

Sep 05, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Location of tps and map sensor on a 02 jeep grand cherokee 4.7l


Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

May 07, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Jeep 89 dianostic scanner


the renault designed (pre1991)jeep computer systems were very simple and diagnostic codes were non existant diagnosis is by scan data not codes common failuer parts were oxygen sensors and crank sensors throttle position sensors were failure prone also BUT need to be ajusted correctly to ork properly

Feb 16, 2010 | 1989 Jeep Cherokee

1 Answer

How do you change the tps on a 2000 jeep grand 4.7


The exact placement of the throttle position sensor generally is located on the side of the throttle body below the air intake tube on top of the engine.

To replace simply remove the air intake duct (usually one plastic screw), locate the sensor, disconnect wire plug in, remove the two sensor mounting screws (torx screw variety, size not remembered) and the sensor will come off. When replacing be sure to line up the throttle shaft with the proper groove inside the sensor...it should just slip in there pretty easily with a little bit of wiggling. Reinstall doing the reverse of the above.

Take's about 5 - 10 min to replace from start to finish and remember to clean the throttle body before starting this job to ensure no dirt will enter the engine. Good luck, Merry Xmass

Dec 24, 2009 | 2000 Jeep Cherokee

2 Answers

Location of throttle position sensor


the throttle position sensor is located on the side of the throttle body even with the throttle plate.

Jul 08, 2009 | 2003 Jeep Grand Cherokee

3 Answers

98 jeep grand cherokee limited 4.0 litre. starts up, during warm up process engine will idle irradically and stall out. starts back up and does the same thing. no check engine light on. cleanrd throttle...


Does this thing have a throttle body that looks like a computer-controlled carburetor?

If so, start motor and verify that it behaves irratically and then stalls.

then, spray WD-40 liberally around base of throttle body where tb meets intake manifold.

Start motor...

Does the problem go away, at least whilst for a little while?

Yes?

You gotta vacuum leak. Replace gasket under TB and tighten bolts to factory spec.

Mar 09, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Vin location


On my 1989 Cherokee, it is on the edge of the driver's side door. Hope that helps.

Jun 12, 2008 | 1989 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...