Question about 2007 Chrysler Sebring Sedan

Open Question

My 2007 Sebring is making a loud "whining" noise when I accelerate. I've just replaced the idler pulley and tensioner. Any suggestions? Does the alternator make that noise?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 599 Answers

SOURCE: GET TENSION OFF THE IDLER PULLEY

loosen nut in center of idler pulley ..then loosen tension bar with 12mm socket til it walks away to remove belt

Posted on Jan 14, 2009

  • 51 Answers

SOURCE: engine noise

If it gets worse when turning the wheel at a stop, then it's the power steering pump. Could be the power steering fluid also. Check your belts for wear or damage. The idle pulley will make a constant noise, sometimes whining sometime screeching. To check idler pulley it is best to remove belts.

Posted on Oct 14, 2008

alicantecoli
  • 22114 Answers

SOURCE: my blower motor makes loud noise on top settings

new motor by the sound of it ,but never worked on one so i couldnt tell you where it is,other than its no doubt a complete unit with the resistance so it will not be cheap

Posted on Nov 18, 2008

  • 6982 Answers

SOURCE: Loud squealing sound in my engine

Try removing the belt and turning each pulley by hand. If everything is smooth and free, with the belt still off, drive down the block once and see if the noise is there (this will eliminate all rotating accessories on the front). If you hear the noise, then there is a problem deeper inside. Oil pressure is good? Dont' forget when doing this, you will have no power steering, so be careful.

Posted on Jan 17, 2009

blueextc3221
  • 15935 Answers

SOURCE: Can't get A/C belt around pulleys on my 01 Chevy Tracker 2.5 V6


Removal & Installation

1.6L Engine
A/C Compressor Belt

  1. Disconnect the negative battery cable.
  2. Loosen the A/C compressor mounting bolts.
  3. Pivot the A/C compressor towards the engine in order to relieve the tension on the belt.
  4. Remove the A/C compressor drive belt from the pulleys.

To install:
  1. Properly route and install the A/C compressor drive belt on the A/C compressor, the power steering (if equipped), and the crankshaft pulleys.
  2. Adjust the A/C compressor drive belt to obtain 6-9 mm (0.24-0.35 in) deflection.
  3. Tighten the A/C compressor mounting bolts to 13-20 f t. lbs. (18-28 Nm).
  4. Connect the negative battery cable.

Alternator Belt
  1. Disconnect the negative battery cable.
  2. Remove the power steering pump and the A/C compressor drive belt.
  3. Loosen the generator mounting bolts.
  4. Pivot the generator towards the engine and remove the accessory drive belt.

To install:
  1. Properly route and install the generator drive belt on the pulleys.
  2. Adjust the alternator drive belt to obtain 6-8 mm (0.24-0.32 in) deflection for a used belt or 5-6 mm (0.20-0.24 in) deflection for a new belt.
  3. Tighten the generator mounting bolts to 17 ft. lbs. (23 Nm).
  4. Install the power steering and the A/C compressor drive belt.
  5. Connect the negative battery cable.

Power Steering Pump Belt
  1. Disconnect the negative battery cable.
  2. Loosen the power steering pump mounting bolts.
  3. Pivot the power steering pump towards the engine in order to relieve the tension on the belt.
  4. Remove the power steering pump drive belt from the pulleys.

To install:
  1. Properly route and install the power steering pump drive belt on the power steering pump and the crankshaft pulleys.
  2. Adjust the power steering pump drive belt to obtain 6-9 mm (0.24-0.35 in) deflection.
  3. Tighten the power steering pump mounting bolts to 22 ft. lbs. (30 Nm).
  4. Connect the negative battery cable.

Posted on Apr 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Chrysler town & country is making a whining noise and gets louder when I accelerate. Also my light is on for rear defroster, but it doesn't defrost. Help!!!!!!


If the whining noise is coming from under the hood, have all pulleys checked for wear. ( Alternator/tensioner/idler etc ). A bad pulley will whine. As for the rear defrost, check the wires that go to the back window. There will be one on each side of the rear glass. One may be seperated/broken from the glass causing the defrost not to operate

Jan 21, 2016 | Chrysler Cars & Trucks

2 Answers

How do I find out out what is causing the very loud humming/whining noise.


Did you check your pcv valve on the other Asian cars the diaphragm gets wholes burnt in and causes that a lot will also cause a slight miss .
My number is 270-556-7357 you can text me more about and I will help you all I can

Apr 09, 2015 | 2004 Mazda 6

1 Answer

My 92 chevy blazer is making a loud squealing noise sounds like my belts but its not that I've replaced the belt and the tensioner what else could it be?


Bearings in Alternator, water pump, power steering pump or even a squeal from Vacuum line, EGR diaphram or similar. Check power steering fluid level.



Now when you replaced the tensioner, did you notice more pulleys that were just "there" and not connected to anything? These are idler pulleys and are helpful in routing the belt. They have bearings too!

Pleae rate my info.

Nov 15, 2012 | Cars & Trucks

1 Answer

Engine whine


It could be any of the pulleys on the engine. Water pump, ac compressor,alternator, idler, or power steering pump. I would say that it is more than likely the power steering pump wining. That would be my first suspect

Aug 21, 2012 | 2002 Dodge Intrepid

2 Answers

2010 Kia Sedona making a whining noise from under the hood.


I have a 2009 sedona replaced the idler pulley and the tensioner pulley and the whining sounds are gone $85 belt +pulleys

Aug 16, 2012 | 2010 Kia Sedona 3.8

1 Answer

Clicking sound near cambelt


It might be the idler pulley or automatic tensioner. When either one dries up, the bearing wears out and starts causing whistling or whining noises, might need replacing. Try replacing the cheapest one, the idler pulley to see if it stops. If not, it might be your belt tensioner.

Jun 25, 2012 | Cars & Trucks

1 Answer

I have a 2005 Lincoln aviator that was making a loud whining noise so I took it to the ford dealership and they told me I needed a new idler pulley and belt and that it would be $350 to fix it. I want to...


yes, but if you look under your hood, you should be able to narrow down where the noise is coming from in that large engine compartment. also think about replacing the belt tensioner as well since you are replacing the belt with the idler pulley. its good preventative maintenance!

May 12, 2011 | 2005 Lincoln Aviator

4 Answers

Loud accelerating whining


It is the bearing in the idler pully. about $35 and 30 minutes of work and its fixed.

May 20, 2009 | 2006 Chevrolet Trailblazer

6 Answers

A high pitched whining noise in the engine.


This Noise Description sounds Indicative of the Sounds that come from the Serpentine Belt Or Related parts such as Belt Idler Pulley or Belt Tentioner witch also has a Pulley, but if Tensioner itself is Literally BROKE I've replaced a number like this it will cause a Whining noise . Best case scenario its just the Belt, and if any of the other Problems turn out to be the Culprit the Belt MUST be Replaced Anyhow as Damage is Being caused By the Very Whining you hear.
PLEASE Spend the Extras $ for the BEST BELT as this Drives your Water pump, Alternator, A/C Compressor, Power Steering Pump All Crucial to Control of, easy Steering ,All Electrical-Power Distribution, The COOLING of Engine << VERY CRITICAL Component
The Pulleys usually have a more Hum type Whining. So I would say at Best The BELT , And WORST Belt Tentioner is Broke

Jan 14, 2009 | 2002 Dodge Caravan

Not finding what you are looking for?
2007 Chrysler Sebring Sedan Logo

Related Topics:

994 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...