Question about Mitsubishi Passenger

1 Answer

Triton 2000 2.4 . Is there any type of relay from the ign switch. All of a sudden nothing from ign key. power ok. when turn ign on to start nothing except fast clicking from under dash.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 161 Answers

Battery starter or selenoid on starter...sounds like weak battery sure to eliminate by trying to boost tapping on starter while attempting to start may also work as they get stuck up sometimes.hope this helps.

Posted on Mar 21, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have new starter and sylinoidswitch and put new ign. Switch when truck started 2 times it fails to start now please help ford expid. Triton 2000

Does the vehicle crank and not start or does it not crank at all? If a no crank, do the headlights come on when the switch is turned on?

Jul 01, 2015 | Ford Cars & Trucks

1 Answer

2000 chev wont start at key

I think the purple wire (or maybe the yellow) from the neutral safety switch goes to the coil side of the starter relay, turning it on so power is sent from there to the starter solenoid. You could check for this signal to the relay with a test light. The key must be held in start while you probe the other two terminals for the relay. If the signal is there, either a bad relay or the coil side of relay is not grounded properly. It is possible that the coil side ground is the neutral safety switch-grounding the relay's coil side only in park or neutral-in which case the nagging light on shifter (between off and run, it only works?) may be telling you the safety switch is the problem.

You may need to look at a wiring diagram, Greg. But the starter relay is the last component in the start circuit before the starter solenoid. From battery to ignition switch to "crank" fuse to neutral safety switch to starter relay to starter solenoid to starter-and back to battery through ground. That is the start circuit. Just that the wiring tying them all together makes it complicated.

Apr 10, 2014 | 2000 Chevrolet Silverado 2500

4 Answers

Won't start

IF battery voltage is above 12.2 volts, I'd suspect a bad IGN switch

Feb 19, 2018 | 2005 GMC Yukon Denali

1 Answer

1996 nissan 200 sx wont start

check ign switch and all the relays clutch has a safty switch may be a bad relay

Nov 23, 2013 | Cars & Trucks

1 Answer

My 2000 bravada oldsmobile wont start is it the sartaer

It depends upon what actually happens when you turn the key. If the engine turns over, but doesn't start, it is NOT the starter. If all you hear is a clicking sound, or the starter motor engages but doesn't have the power to turn it over, then it could be wither the starter or the battery. A quick and easy check when this happens is to turn on the interior light. If, when you turn the key and get the click or no activity, the interior light dims way down or goes completely out, it is probably the battery. If you turn the key and get nothing at all, things are more difficult. The interior lamp test should be performed. If the light goes out immediately, try the battery. If the light doesn't flicker or dim at all, then the problem could be the starter, the starter relay, the Park/Neutral Position (PNO) switch, the ignition switch, or the IGN E (Fuse 22) or IGN A (Fuse 34) fuse in the fuse block under the hood.


Nov 10, 2013 | 2000 Oldsmobile Bravada

2 Answers

99 cabrio has power, starter bench tested good, but nothing when turning key. radio, lights work

With the starter installed try checking for power from the ign to the starter, you will need a test light for this..Have someone hold the key in the starting position and then check to see if the light comes on..
If it does not than you might have a bad ign switch or natural switch

Oct 23, 2013 | 1999 Volkswagen Jetta

1 Answer

91 Acura legend won't turn over. Changed the starter relay and checked the starter, it's good. Now what do I do?

Power flows from Fuse 35 50A to IGN switch. Start by checking that fuse. From IGN switch to starter on black/white wire. Check for battery voltage on that wire at starter. If no voltage, check for voltage on black/white wire at IGN when turned to START. If no voltage, check for good power coming into the IGN switch on the the white wire from Fuse 35

Feb 04, 2018 | Cars & Trucks

1 Answer

2002 Chevy S10, 2.2 L automatic. Intermittently, when I turn the key, ALL electrical goes off. No gauges, no door lights, clock, anything. I've been able to get it start in two ways - jiggle the cable...

Ignition switch maybe , GM has problems with switch . Test it ! Do you know how to do automotive electrical testing ? Test main powers to the ignition switch . Back probe the B+ power wires Both are red at the ignition switch ! They get B+ from IGN A & IGN C fuse's in the under hood fuse/ relay box ! One is 40 amp , the other is 20 amp .
This problem your having you say happens when you turn the key , correct ? Turn the key to ? ON - START ? or doesn't matter ? The ignition switch supply's B+ voltage to all the things your losing power to.

May 30, 2017 | 2000 Chevrolet S-10

1 Answer

Why wont my 2000 sunfire start?

starter relay,ignition switch,park switch.need to use a volt meter and start at the starter,see if you have at least 12 volts.if there is have the battery tested.does your head lights come on?next no voltage, go to the fuse box under the hood and check for (2) 12 volt powers with the key on and a good ground.if ok replace the move the trans shifter to neutral with foot on brake and try and start if it starts you need park switch.if not next is the ign.switch to test,you will need to locate the starter wire and check for voltage when starting if none replace the ign.switch hope this helped.also the alternator has nothing to do with the cranking of the engine on this car.

Nov 25, 2009 | 2000 Pontiac Sunfire

1 Answer

Think the ign switch is bad, not key switch, but column switch. need expert advice on how to change. any ideas??? key turns, locksmith said key switch is not problem, key turns but no starter action? help...

did you check your fuses and relay for power a test light will work. start with the fuse first. the relay should have 1 power all the time. the other will with the key turned to start. rare for the switch to go bad. best of luck

Aug 07, 2009 | 1988 Jeep Comanche

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides