Question about 1995 Honda Accord

1 Answer

IM JUST WONDERING HOW HARD IT IS TO REPLACE THE ALTERNATOR IN MY 1995 HONDA ACCORD EX 4 CYLINDER VTEC

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 8,215 Answers

Hi, you have to remove the power steering pump to get the alternator out. Please let me know if you have questions, and thanks for using FixYa.

1994-95 Accord

See Figure 4
EXCEPT V-6 MODELS

  1. Disconnect the negative battery cable, then the positive cable.
Remove the power steering pump.
  • Drain the fluid from the system as follows:
    1. Disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir.
    2. Start the engine and allow it to run at fast idle. Turn the steering wheel from lock-to-lock several times, until fluid stops running from the hose. Shut off the engine immediately; don't run the pump without fluid.
    3. Reattach the hose.

  • Disconnect the inlet and outlet hoses at the pump. Remove the drive belt.
  • Remove the mounting bolts/nuts and remove the pump.
  • IM JUST WONDERING HOW HARD IT IS TO REPLACE THE - jturcotte_1292.gif

    Fig. Fig. 1: Once the drive belt and mounting nuts/bolts are removed from the pump, it can be removed from the engine
    .


    1. Unplug the multi-connector from the back of the alternator.
    2. Remove the terminal nut and remove the wire from the terminal.
    3. Loosen the through-bolt, adjustment locknut, and the adjusting bolt.
    4. Remove the belt from the alternator.
    5. Remove the adjustment nut and bolt.
    6. Remove the through-bolt and the alternator.
    jturcotte_1293.gif

    Fig. Fig. 4: Alternator mounting on 1994-95 Accords


    To install:

    1. Fit the alternator into place. Install the through-bolt and tighten it to 33 ft. lbs. (45 Nm).
    2. Install the adjustment bolt and nut.
    3. Install the belt and adjust the tension. Tighten the locknut to 16 ft. lbs. (22 Nm).
    4. Connect the wire to the terminal and tighten the nut.
    5. Engage the multi-pin connector to the alternator.
    6. Install the power steering pump.
      1. Install in reverse order. Adjust the belt tension, fill the reservoir and bleed the air from the system. Tighten the bolts/nuts to the following:

        1984-85 Accord and Prelude pivot bolt 32 ft. lbs. (45 Nm); adjusting nut 20 ft. lbs. (27 Nm) 1986-89 Accord pivot bolt 28 ft. lbs. (39 Nm); adjusting nut 16 ft. lbs. (22 Nm) 1986-87 Prelude pivot bolt and mounting nut 28 ft. lbs. (39 Nm) 1990-93 Accord through bolt 33 ft. lbs. (45 Nm); mounting nut 16 ft. lbs. (22 Nm) 1988-91 Prelude mounting nuts and bolts 35 ft. lbs. (49 Nm) 1994-95 Accord mounting nuts 17 ft. lbs. (24 Nm) 1992-95 Prelude mounting nuts and bolts 16 ft. lbs. (22 Nm)
      2. Properly enable the SRS system, if equipped, and connect the negative battery cable.


      SYSTEM BLEEDING

      1. Make sure the reservoir is filled to the FULL mark; do not overfill.
      2. Start the engine and allow it to idle.
      3. Turn the steering wheel from side-to-side several times, lightly contacting the stops.
      4. Turn the engine OFF .
      5. Check the fluid level in the reservoir and add if necessary.
    7. Connect the positive battery cable, then the negative cable.

    Posted on Mar 21, 2011

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    What's is the spark plug gap for a 1995 Honda accord ex vtec


    spark plug gap for a 1995 Honda accord David, .039 to .043 inches or 1.1 mm, for your spark plug gap on your Honda.

    Mar 28, 2016 | Honda Cars & Trucks

    1 Answer

    I have 96 honda accord ex 4 cylinder vtec engine the engine will no Rev past 3500 rpms


    maybe a sensor? cam position or flywheel? assume b series? my cars d series theres a chip in the distributer that fails though u may be onsparkless ign.get a fault code reader

    May 23, 2015 | 1996 Honda Accord

    2 Answers

    Im looking for a vtec valve for my 2001 honda accord ex?


    Check with local salvage yards that will give you a guarantee if you're looking for the cheap route or if you've got money to blow get a turn key crate motor to simply swap out with the old one

    Apr 23, 2011 | Honda Accord Cars & Trucks

    1 Answer

    Wandering where the alternator is located in a Honda Accord Ex 1995 4 cyl Manuel


    Alternator mounting on 1994-95 Accords



    c17hydro_17.gif


    c17hydro_18.gif
    Right next to where the word "stopper" is.

    Nov 13, 2010 | 1995 Honda Accord

    2 Answers

    What engine comes stock in a 1993 honda civic 4 door?


    stock engine for that car is a 1.4 in line 4 cylinder with efi.

    Mar 03, 2010 | 1993 Honda Civic 4 Door

    1 Answer

    Deciding on buying 2 cars, a 94 accord LX w/ 170K, the engine is so quiet it seems to perfect (its at a dealership). The 95 EX with 122K is not as quiet, has a VTEC engine and is really only loud when I...


    Well one easy answer for you. The VTEC enige is unbreakable and will rev higher than you think. When the VTEC kicks in you will get a bit more noise as the enige sucks more air but believe me as long as you keep ontop maintenance wise it will be the best buy.

    Dec 15, 2009 | 1995 Honda Accord

    1 Answer

    Connector for Speed Sensor on1996 Honda Accord Auto Trans.


    If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.

    Dec 13, 2008 | 1996 Honda Accord

    1 Answer

    I have a 1995 honda accord ex sedan with a 2.2L Vtec and its an automatic im currently in the process of turning it into a tuner... i still havent touched the engine and i tried to see if i could get my...


    Take the V-Tec control solenoid off and the base off the cylinder head then go to the dealership and get the parts that replace the gasket to seal the solenoid and the base module to the engine there is a clogged screen for the oil in there and the gaskets are most likely on the verge of leaking anyway. Cleaning this screen gives the 2.2 v tec all the required oil pressure to fix this problem. Most Honda or Acura dealers have these parts in stock yet, there are several different ones per engine family so I suggest that you take the solenoids and base plates with you to match up visually as i have experienced recently with a tuner, they are not all the same. many dealerships have these in stock because it is a common problem. You will see an immediate difference. Although the Honda accord is somewhat less aggressive with the v tec than say a prelude or an acura is. Due to differences in camshaft and cylinder head and intake designs for each car. Accords are typically a family oriented car whereas the prelude and Acura are more the sporty side of the equation.

    Nov 05, 2008 | 1995 Honda Accord

    Not finding what you are looking for?
    1995 Honda Accord Logo

    859 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Kevin Daniels

    Level 3 Expert

    1455 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...