Question about 1996 Pontiac Sunfire

1 Answer

Will not start, engine just cranks over. started a

Will not start, engine just cranks over. started a few hours later then failed the next attempt after that.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 90 Answers

Check for proper fuel rail pressure and spark.

Posted on Mar 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi a4 2.0 lt 2006 engine cranks but wont start . started this morning no problem . half an hour later no start . no warning lights on dash


The first thing that you must do here is to have the systems computer checked for fault codes, it should have a few in memory. the codes are read through the diagnostic port under the dash.

Oct 07, 2016 | 2006 Audi A4

3 Answers

04 PT Cruiser will only start after sitting like 10 hours or more but once u shut it back off will not start back up till another 10 hours Checked starter alternator and fuses. What could it be


Does the engine crank, but not start or will it not crank?

If not cranking, test battery, clean post and check wires for corrosion and good contact. Also check the ground wire between the engine block and the car body for good contact. If all good there, may be a problem in the ignition switch.

If the engine cranks but will not start, check the pressure on the fuel rail. If good pressure, check the ignition module.

Apr 19, 2015 | 2004 Chrysler PT Cruiser

1 Answer

Truck wont start with out a jump. Changed starter and selinoid. Had battery checked and charged. Started right up then checked again a few hours later and cranked right up checked a few hours later and...


It is likely you have a draw in the truck. Please see my tip at http://www.fixya.com/cars/r5925550-dead_battery_troubleshooting . These are genericinstructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Jun 13, 2011 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Truck ran fine set for an hour or so come back would not star 3 attempts waited for a little while cranked up. went out this morning would not crank up 5 attempts.Notice batt. was dragging went and had it...


Most of your discription would indicate a bad starter,
if your talking about the engine turning over or cranking

Some people call a no start or no ignition, a not cranking
situation, which is a wrong statement.

You may have a bad fuel pump, if the motor turns
over but won't start.

Jan 29, 2011 | Ford F-150 Cars & Trucks

1 Answer

While driving noticed check engine light ,slip,and ect light on dash came on proceeded my journey , when i started up the car again it took several cranks before starting. Next day drove about half a mile...


the bank#1 cam position sensor has failed.this is located in the back of the cyl. head closest to fire wall.takes several attempts to start because lack of signal puts ecm in fail safe mode and it substitutes a value to get engine started.about a$100 for sensor and half hour to put it in.

Jan 19, 2011 | 2004 Nissan Quest

1 Answer

2003 XK8 won't start


Remove plugs, clean and dry(warm) them and try again-common fault
John

Jan 03, 2009 | 2005 Jaguar XK8

Not finding what you are looking for?
1996 Pontiac Sunfire Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...