Question about 1985 Chevrolet Monte Carlo

1 Answer

My gas pedal in my 85 monte gas pedal is sticking. Can anyone help?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 90 Answers

You should clean the throttle body assembly and if necessary lubricate the accelerator linkage with a spray lubricant, or in a pinch, WD-40

Posted on Mar 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 85 ss Monte Carlo with an edelbroch carburetor. There is fuel getting to it to start however I have to hold my foot on the gas to keep her running as soon as I take my foot off the pedal it dies....


First off you need to stop running it when this problem is present. There is a big chance that it will catch fire and be destroyed. If sounds to me like it is getting too much fuel and you need to remove the carb and rebuild it. This would include a new float because it probably sank.

Feb 19, 2015 | Cars & Trucks

1 Answer

85 HONDA ACCORD WONT STAY RUNNING UNLESS PUMPING GAS NOT EVEN FULL THROTLE


You have a single fuel injector in it right. Try right at the end of the gas pedal cable at the engine there is an electrical plug and a little device that goes around in a circle when the gas is mashed. That is the throttle position sensor. Try unplugging that and if there is no difference in the revving then the throttle position sensor is out. If that is not the problem, then plug your engine into a an onboard diagnostic reader. 85 is an obd1.

Feb 19, 2015 | 1985 Honda Accord

1 Answer

Throttle body float stuck


They are pulling your leg

Only Carburators have Floats

A Throttle Body has Injectors

Could be an issue with the Mass Air Flow Sensor

Wrong reading on air flow you add too much fuel

Dec 13, 2012 | 1985 Chevrolet Monte Carlo

1 Answer

Gas pedal sticking. Car jumps sometimes


try cleaning throttle plate. dp this by removing air intake boot. open throttle and spray with carb cleaner and wipe out with rag.

Mar 12, 2011 | 2005 Chevrolet Monte Carlo

1 Answer

Gas pedal 'sticks' to the floor when accelerating


The gas pedal is recalled on many fords and toyotas and is a well known problem, get the pedal replaced

Jun 01, 2010 | 1995 Ford Ranger Supercab

2 Answers

Seems to stick in 1st and 2nd gear


First signs of the trans going out. rebuild or replace.

Jul 02, 2009 | 2003 Chevrolet Monte Carlo

1 Answer

Brake booster


If I understand you Question correctly you would like to know what you brake booster hooks on to? Its bolted through the fire wall by four bolts you can't see those bolts from outside in the hood. They can be seen up above the brake pedal on the inside of you vehicle . The master cylinder in mounted to the brake booster. The brake booster has a Push type rod that attached to the top of your brake pedal close to the brake light switch. Good Luck

Dec 09, 2008 | 1985 Chevrolet Monte Carlo

2 Answers

2005 Monte Carlo Change Oil Light Reset


Hiiiiiiiiiiii...........
Are 2 procedure to Reset the oil life.
1-- Using the accelator pedal.
Turn ignition ON with engine OFF
Fully press and release the accelerator pedal 3 times within 5 seconds.
The oil change light will flash a few times and them go OFF.
If the light is still on repeat the procedure.

2-- This procedure need the RADIO, if you have an aftermarket
Radio you don't be able to do.
Turn the ignition switch to ON position,
turn OFF the RADIO,
Press and hold the Tune disp, button for 5 seconds or until
Settings is displayed,
Press the seek ptype or seek pscan up and dow to scroll the main menu,
Scroll until the OIL LIFE appear on display
Press the 1prev or 2next to scroll the sub menu, RESET will be displayed , Press the TUNE disp buttom to reset,
A chime will be heard to verify the new settings and done
Will be displayed for one second.
Press the TUNE DISP to exit from the program,
A chime will be heard to verify the exit.

OK.. I hope this help on your question.
Thank you for use fixya.

Aug 23, 2008 | 2005 Chevrolet Monte Carlo

2 Answers

Sticking gas pedal on 1999 buick LeSABRE


actually my dad had the same problem with the gas pedal sticking on his low milage 1999 Buick LeSabre. As a result of this problem, he was involved in a wreck and the car was totaled. We have been told by his mechanic that this is a problem with that year of LaSabre.

Jun 14, 2008 | 1999 Buick LeSabre

Not finding what you are looking for?
1985 Chevrolet Monte Carlo Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...