Question about Chrysler LeBaron

Open Question

How do i replace fuel pump in 87 lebaron - LeBaron Chrysler Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 202 Answers

SOURCE: 87 firebird fuel pump

Remove the exhaust, drop the rear end, remove the fuel cap, and surrounding rubber flange. remove the two hanger straps (be sure to have fuel tank supported so it doesn't just fall out. Remove hoses/electrical connector. Pull tank out, and remove metal lock ring that holds fuel pump assembly in place. Remove fuel pump assembly. Installation is reverse of removal. I have had 7 of these cars, and am currently driving one now. If you have any other questions about it, please ask!

Posted on Mar 27, 2009

c17hydro
  • 2984 Answers

SOURCE: how do you replace the fuel pump in a 91 chrysler

This is if you have a carbuerator:


712c421.gif
Identification of the mechanical fuel pump inlet and outlet tubes


  1. Make sure the negative battery cable is disconnected. Have a metal cup handy to collect any fuel that may spill.
  2. Place a drain pan under the oil filter, then remove the filter with a strap wrench or equivalent.
  3. Disconnect the fuel and vapor lines, catching fuel that spills. Dispose of any spilled fuel safely.
  4. Plug the fuel lines to prevent leaks.
  5. Remove the attaching bolts and remove the fuel pump.
The fuel pump is NOT repairable. It must be replaced as a complete unit. Always use a new gasket when installing the pump and make certain that the gasket surfaces are clean.
To install:
  1. Clean the fuel pump and engine block gasket surfaces of all old gasket material or dirt.
  2. Position a new fuel pump gasket against the engine block, then situate the pump in position over the gasket with bolt holes lined up squarely. Install the retaining bolts and tighten them to 21 ft. lbs. (28 Nm).
  3. Connect the fuel lines to the pump (always start fuel line connections by hand-before using a wrench to tighten) and tighten the fittings to 175 inch lbs. (20 Nm).
  4. Clean the block surface, check the gasket, then install the oil filter, tightening it by hand only. If the gasket is damaged, replace the filter. Refer to Section 1 for the proper service procedures regarding oil filters.
  5. Start the engine and check for leaks. Check the crankcase oil level and refill as necessary.

Posted on Mar 07, 2010

witmoz
  • 389 Answers

SOURCE: 87 Silverado PU Fuel gauge moves to center &

should start checking for a grounded wire.

Posted on Aug 15, 2010

  • 10 Answers

SOURCE: 87 lebaron 2.2 turbo sat for 5 yr. want to sell,

want to sell- how much? and where are you located?

Posted on Aug 18, 2010

ZJLimited
  • 17970 Answers

SOURCE: where is the fuel pump

For 1987 Dodge Truck RAM 50 4WD 2.6L 2BL 4cyl...

The mechanical fuel pump is mounted on the side of the head, centered between the runners of the intake manifold. The intake manifold does not require removal, but access can be tricky. A selection of socket extensions, swivels and open end wrenches can be helpful.

40a79dc.jpg

Fig. Fig. 3: Mark the fuel lines and pump mating points

c4f42e7.jpg

Fig. 4: Unbolt the fuel pump assembly from the engine then

Hope helps.

Posted on Sep 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to test the engine control module in a 1993 chrysler lebaron


we replaced the part that is like an emergency fuel shut off in case of an accident. 1st time the new part was bad, bought another one for $18. works fine

Apr 27, 2012 | 1993 Chrysler Lebaron

1 Answer

The car for a few weeks now has been getting harder and harder to start, like fuel pump is going out, we have to turn key on and off a few times to get fuel to the rail. Now it wont run at all, it will...


The fuel pump pressure is an essential bit of information you need. Before you drop the fuel tank to replace the pump, check your fuel filter. that may be all you need.

Jul 20, 2011 | 1986 Chrysler LeBaron

3 Answers

I have a 1995 chrysler lebaron, it has not given me any problems. Done nothing weird until today, i had driven around made serveral stops, when i came out from the last one my car wouldn't start. Turns...


Well, look for spark, if you have it to the plugs, verified, then try having someone pound on the low spot of the fuel tank. while you try to start. Sometimes this will allow a fuel pump to restart. If that does it, replace the pump soon, it is pricey.

Oct 07, 2010 | 1995 Chrysler LeBaron

1 Answer

After replacing fuel pump car still stalls occasionally when turning or stopping,also pump seems to run most of the time and is noisy


Did your also replace the fuel filter. Clogged fuel filters are one of the major causes of premature fuel pump failures. If you did replace the filter then look at the fuel pressure regulator.

Mar 12, 2010 | 1986 Chrysler LeBaron

2 Answers

Where is the fuel pump located in a 1994 chrysler Lebaron gtc


Both 4 and 6 cylinder's fuel pump located in gas tank.

Jan 13, 2010 | 1994 Chrysler LeBaron

1 Answer

Have no spark in lebaron 4 cyl! 87 LEBARON


Remove the distributor cap,check to make sure the plug wires didn't lift out of cap,Have someone turn engine over while you watch if rotor is turning.
If those two things are ok,Lift rotor off distributor shaft,The ignition modular
is the round black plastic piece under the rotor.It just lifts out and has a wire plug to undo.Replace this.


Nov 16, 2009 | 1987 Chrysler LeBaron

1 Answer

Were is the fuel pump relate


In my 1985 Lebaron convertible 2.2 turbo the fuel pump is located in the fuel tank in the back next to the fuel sending unit.

Apr 28, 2009 | 1985 Chrysler LeBaron

1 Answer

95 chrysler lebaron gtc 3.0 starts for a second and then stalls out


What is the fuel pressure reading at the fuel rail?

Mar 19, 2009 | 1995 Chrysler LeBaron

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...