Question about 1995 Buick Regal

1 Answer

The stop light in the rear window works, but there is no stop lights on the tail lights.why is this?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 643 Answers

It is because they work on a link system meaning that if one , or both of the bulbs is burnt out then it wont allow either one to light

Posted on Mar 21, 2011

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Brake lights on rear tail

It sounds like you have to replace a "Relay" in your fuse box. This would be the large grey rectangular looking thing...I believe its the 2nd one closest to you from left to right...try changing it and see if you have your 3rd brake light back again. Good luck.

Posted on Aug 06, 2008

reichweinj
  • 71 Answers

SOURCE: 2006 Chevy Trailblazer Tail Lights

There was a recall on this, take to the dealer and they will replace the whole socket on this.

Posted on Nov 10, 2008

  • 7353 Answers

SOURCE: 96 monte carlo rear window brake light works but

are the bulbs good. do these use the same bulbs for brake/turn signals?. if the high mount light was working, then the brake light switch was good. brake light power goes through the turn signal switch. you will need to get a wiring diagram and verify the power is going in and coming out of turn signal switch.

Posted on Sep 21, 2009

  • 112 Answers

SOURCE: NO LEFT SIDE TAIL ,STOP OR BLINKER REAR LEFTLIGHT

did you try to replace the bulb in the back normally when it blinks fast like that its just the bulb and its doulbe film thats why the brake and blinker dont work

Posted on Dec 19, 2009

mpcheeseman1
  • 1400 Answers

SOURCE: how to replace right rear stop and tail light?

Should have acsess to lightbulbs in trunk of car.

Open trunk and remove any carpet or cover around light area.

Bulb should be in a socket,turn socket until it comes out of light lens.

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

On the fuse chart, what is the abbreviation for the brake light fuse


Should all be the same fuze. Check the bulbs and whether the harness to the rear lights that usually runs through the trunk hasn't been pulled.

Jun 25, 2014 | 1998 Toyota Camry

1 Answer

My two tail brake lights stopped going but rear window one still works.bulbs are still good.


trace the wires from back of light clusters and make sure the earth is a good connection to the car body/chassis

Apr 02, 2014 | 1992 Toyota Camry V6

2 Answers

Brake lights are not working but my back window brake light works and so do my tail lights and turn signals. 01 chevy malibu


if rear window stop light works has blown globes in other 2 tail and stop are different circuts fit 2 new globes only go in 1 way

Sep 16, 2013 | 2001 Chevrolet Malibu

2 Answers

Tail light doesnt turn on with headlights but works fine as a break light and turn signal, why?


in the rear lights you may have two bulbs one is the turn signal the other one is stop light / tail light the stop light / tail light has two filaments, one for the stop light (21 watt) & one for the tail light (5 watt) it is possible that the tail light filament is blown, try replacing the bulb to see if that fixes the problem,also check all the fuses as well.......hope this helps......cheers.

Aug 15, 2011 | 1994 Cadillac DeVille

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

1 Answer

Both front power windows stopped working


hope this helps. if u have any other questions just let me know


248015_1_103.jpg

Fuse locations for options not shown can be found in the corresponding wiring diagrams.
Amp.


1 - Headlight, Low Beam, Left (56b) 10
2 - Headlight, Low Beam, Right (56b) 10
3 - License Plate Lights (5icon_cool.gif 10
4 - Rear Window Wiper And Washer System 15
5 - Windshield Wiper/Washer 15
6 - Fresh Air Blower, A/C (X) 20
7 - Tail Lights, Right (58R) 10
8 - Tail Lights, Left (58L) 10
9 - Rear Window Defogger 20
10 - Fog Lights 15
11 - Headlight, High Beam, Left (56a) 10
12 - Headlight, High Beam, Right (56a) 10
13 - Horn (15) 10
14 - Back-Up Lights 10
15 - Engine Electronics (15) 10
16 - Power Sunroof, Front Map/Reading Light 15
17 - Emergency Flashers (15) 10
18 - Fuel Pump (FP), Heated Oxygen Sensor (HO2S)
Control Module 20
19 - Coolant Fan, A/C Relay (30) 30
20 - Brake Lights (30) 10
21 - Interior Lights, Clock, Luggage Compartment
Light (30) 15
22 - Cigarette Lighter, Radio, Luggage Compartment
Release 10

Separate Fuses

(Located above the relays)



- Fuse for ABS hydraulic pump relay 30
- Fuse for ABS main relay 30
- Fuse for A/C 30
- Fuse for power windows 20
- Fuse for cruise control 5
- Fuse for cigarette lighter 15

May 20, 2009 | 1997 Volkswagen Jetta

1 Answer

Brakelights not working


brakelite switch on top of brake pedal

Apr 11, 2009 | 2006 Hyundai Accent

1 Answer

Rear brake lights don't work


There is only one brake light switch. There should be a wiring harness connector somwhere in the back of the car. Follow the wires from the tail lights until you get to this connector. Take it apart and clean the terminals and reassembl. If this does not do it, move further up the harness until you next connector, do the same thing.

Good luck

Feb 08, 2009 | 1996 Chevrolet Monte Carlo

1 Answer

2001 Ford Ranger, tail light stopped working, everything else wor


fuses control each side of car so two feeds to rear lights if power lost in both rear lights and front side lights work then its a connection multiblock somewhere but never seen this vehicle in spain so i couldnt tell you where to look only a mechanics logical diagnostics,sorry about this

Dec 14, 2008 | Ford Ranger Cars & Trucks

Not finding what you are looking for?
1995 Buick Regal Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...