Question about Mazda MAZDA3

1 Answer

I have a mazda 3 2005 the trunk relese will not work the key will open the trunk

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 127 Answers

Need to check the trunk switch to make sure it working and is getting fire through it, i would use oam meter or test light, if it is not check fuses if it is check for fire at trunk release if it has fire change electric lock.. (dealer item)

Posted on Mar 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Open trunk without key 2003 Buick century


Push the trunk releses button inside the vehicle .

Mar 13, 2017 | 2003 Buick Century

2 Answers

Getting in the trunk the relese button isnt working


Check where the wiring harness runs up the drivers side trunk lid support arm. I just fixed that exact same problem on my Caprice. The ground wire is probably broken. When that happens, there is enough to pull the soleniod when there is no load, but when the trunk is closed and there is a load on the latch, there isn't enough power to pull the soleniod open to release the trunk. Is your license plate light working? They use the same ground. -------------------------------------------------------
Launch X431 Master

Mar 15, 2013 | 1996 Toyota Avalon

1 Answer

I have a 2000 mazda protege and the trunk won't


is the key turning in the trunk lid?

Nov 11, 2012 | Cars & Trucks

1 Answer

My pontiac G6 trunk lid is jambed,the dash indicator say 'Trunk Adjar" but we can niether shut it or get it open. both the key fob and the inside relese button seem to be be working in that you can hear...


there is a little finger in the latch that closes when the trunk is closed chances are that the little finger has closed but the trunk is still open... this can be fixed by looking at the latch on the lid you will see a slot with a metal arm in the middle take a screw driver and place it in the hole in the slot at the top. press the button on the fob to open the trunk while your pulling down on the screw driver the little latch should twist letting the screw driver move through the track and pop out now alowing you to close the trunk and being happy again.

Jun 12, 2010 | 2006 Pontiac G6

1 Answer

1999 porsche 996 replaced key fob battery disconnected battery now trunk releses are locked and cant access battery.How do you open frt trunk manually


Assuming the car battery is ok (if not, buy a male to male cigarette lighter at the auto store and connect to another car until charged enough to unlock the doors...but don't try to crank the ignition!). The trunks won't open if the battery went dead with the alarm set because arming the alarm physically locks the releases.

Sounds like the key code is switched off because you replaced the key fob battery. Try unlocking the car manual with the key in the door lock. Then switch the ignition on to reactive the keyless entry. If this does not work, you might also try pressing the fob unlock button with the key in the door lock until the dash led flashes.

Jun 10, 2010 | 1999 Porsche 911 Carrera

2 Answers

Enter trunk with no key


find the trunk relese wires in the loom going to rear find the correct colers from your wireing diagram cut them, pear the wires going to trunk...simpely trip the lock with a 12 volt alarm battery or somthing like that any thing that can give it 12v O.K.?

Mar 09, 2010 | 2002 Chrysler Sebring

1 Answer

Trunk release stopped workin fuse or connections?


is it locked from the out side some models you can lock form out side with the key try to open your trunk with your key then use your relese

Sep 21, 2009 | 1996 Nissan Sentra

1 Answer

Trunk release and fuel door release buttons do not work


i just bot mazda millenia and i can't find trunk release???!!!!

Mar 15, 2009 | 1996 Pontiac Grand Am

1 Answer

Volvo 1990 Model 740 Trunk Lock key was broken in it


if it can be opened from the outside i guess yo dont need t lock it in the first place right?!! wel that's a joke ok

now if you can drop the back rest of the rea seat you ca crawl into the trunk and pull the lever to relese the trunk open hopefully there is not much of stuff inside our trunk!!!!

Nov 14, 2008 | 1990 Volvo 740

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

443 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...