Question about Toyota Land Cruiser

1 Answer

79 series landcruiser ute 99 mod ! has had ful gearbox and transfer rebuild with upgraded input shaft new clutch ect ! done 10000 k since ! now went to turn around through a table drain got back onto highway in 4wd , i went to disengadge 4wd and lever was a little firm and noticed a noise coming out of assuming gearbox ? someone had said i could have smashed something in tranfer ! but i wasnt flogging car and drive carefully !

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Toyota Master
  • 881 Answers

Check transfer and transmission oil

Posted on Jul 08, 2017

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: Need to fit coil springs to Landcruiser 79 series ute (2004)

You need a coil spring compresser, and the proper skill level to use it.
If you try to change the coils without a compresser, you CAN & WILL GET HURT. Coil springs are not something to fool about with if you do not have the proper tools. These things are danagerous.

Posted on Sep 09, 2008

c1apton15
  • 3400 Answers

SOURCE: I have an 80 series petrol Landcruiser which

Couple of options: You must have truck up at least 24" or higher and trans (according to Rover) has to be rolled to one side. The other option from local gent who works on Rovers suggests losening motor mounts so motor can tilt backwards. They are tight - Either case sounds like alot of work..

Posted on Jan 03, 2011

  • 318 Answers

SOURCE: my landcruiser 79 series ute over heated temp gauge went into red replaced pump belts filled up with new coolant but now the gauge just stays in red permanently even when u first start car from cold.

You should replace the temp guage sender unit. First disconnect wire from sender and with a test light connect one end to wire and one to earth turn ignition on and gauge should start at base and slowly work its way up. Faulty sender. If gauge still on full when disconnected from sender then gauge is either stuck and need replacing

Posted on Dec 10, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota landcruiser ute. 79 series non turbo.Crunches going into 5th gear.


Do youknow how to double clutch,,, try it and if it doesn't ;crunch;, your synchronizer may be out t lunch.

May 14, 2017 | Cars & Trucks

1 Answer

How to replace clutch step by step on a toyota rav4 4wd


You need some very specialized tools to do that You'll need a jack to hold the transfer case once you remove all the bolts holding it to the transmission. Remove the drive shafts.Then you'll need to remove the transmission, again with a supporting jack. Once that has been accomplished , remove the bolts holding the clutch to the flywheel. I'd replace the pilot bearing in the flywheel that holds the input shaft to the gearbox before proceeding. There are special tools available to do that. Now assemble the clutch disk and the clutch plate and put the bolts back in without tightening them. Now take the clutch alignment tool and push it thru the clutch disk and into the new pilot bearing. position it so the clutch disk is dead center in the clutch plate and then finish tightening the bolts Put a new throw out bearing on the clutch release lever and reinstall the transmission and transfer case. Reinstall the drive shafts and replace any gear oil that may have spilled out of the transmission or transfer case. Adjust the clutch pedal clearance to spec and you're done.

Mar 30, 2013 | 1996 Toyota RAV4

1 Answer

My landcruiser 79 series ute over heated temp gauge went into red replaced pump belts filled up with new coolant but now the gauge just stays in red permanently even when u first start car from cold.


You should replace the temp guage sender unit. First disconnect wire from sender and with a test light connect one end to wire and one to earth turn ignition on and gauge should start at base and slowly work its way up. Faulty sender. If gauge still on full when disconnected from sender then gauge is either stuck and need replacing

Dec 10, 2012 | Toyota Land Cruiser Cars & Trucks

1 Answer

1979 landcruiser clutch did not release fully to get it into gear.I had rebuild the master and slave silinders.The problem is stil the same.


Problem might be on the Clutch plate is won or Preasure plate is weak wants to be changed. or sometimes your slave cylinder is won inside, fix complete new one and then see before going deep in the gearbox.

Aug 27, 2011 | Toyota Land Cruiser Cars & Trucks

1 Answer

I have an 80 series petrol Landcruiser which requires clutch replacement. When removing gearbox I cannot move gearbox back far enough (fouls on transmission tunnel) for input shaft to clear pressure plate....


Couple of options: You must have truck up at least 24" or higher and trans (according to Rover) has to be rolled to one side. The other option from local gent who works on Rovers suggests losening motor mounts so motor can tilt backwards. They are tight - Either case sounds like alot of work..

Jan 03, 2011 | 1993 Toyota Land Cruiser

1 Answer

Auto transmission will not shift gears


Get diagnostics done and if you will get code P0741 - This trouble code is about damper clutch, which improves fuel economy by matching power transmission effectiveness of automatic transmission Damper clutch consists of control valve and solenoid valve which converts electric signal to hydraulic signal by the TCU signal. Corresponding code will be displayed under following conditions when damper clutch is operated form TCU lock-up output time. -when the difference between engine revolution and input shaft revolution has been below 160 RPM. Torque converter solenoid (TCU) is the last thing you should look at to replace, the cause of its failure might be in a different area like worn seals. Nevertheless it is a serious malfunction of a gearbox as further usage may end in a complete gearbox failure and the only solution you will be left with is to rebuild the gearbox or get a new one. Before you start buying parts you should closlely inspect the inner cover seals for uneven wear or possible damage, short cicuit will be caused by fluid passed onto electric connection,

Apr 29, 2010 | 2000 Kia Sephia

1 Answer

Replacing the front transfer case oil seal


don't stress about your springs just undo the shocks and sway bar and keep lifting the car you will unload the spring no tools needed...

Dec 30, 2009 | 2004 Toyota Land Cruiser

1 Answer

Frontend rebuild


You may either look for aftermarket steering upgrade.

Oct 03, 2008 | 1985 Toyota Land Cruiser

1 Answer

Need to fit coil springs to Landcruiser 79 series ute (2004)


You need a coil spring compresser, and the proper skill level to use it.
If you try to change the coils without a compresser, you CAN & WILL GET HURT. Coil springs are not something to fool about with if you do not have the proper tools. These things are danagerous.

Jul 30, 2008 | 2004 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...