Question about 1998 Dodge Durango

1 Answer

How do you get the pulley off the water pump of a dodge1998 durrango eng 318

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Here is a complete run down on removing the water pump
It may help you if reviewing all details start to fininh
the pulley is mentioned there too

Posted on Mar 20, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

I have a 1984 Dodge Ram 1/2 ton with V8 318. It has dealer installed a/c also air pump. It looks like it takes at least three belts, maybe four. The truck has been stored for a while and I am not sure that...

You should have a belt routing decal in the engine bay somewhere or under the hood. If the belts are on now and lined up, adjust as needed. If they won't adjust anymore replace with 1 inch shorter belts. The power steering and the air pump usually take seperate belts. The air pump don't take much to power, they usually run off the third groove on the water pump. A/C, Alt. and PS will all run around the crank. Hope this helps some, if not you might could find a Haynes repair manual at the parts store.

Jul 03, 2011 | 1984 Dodge Pickup 4WD

1 Answer

I need to know how to change a water pump in a 2003 ford focus s/w it has a 4 cyl 16 val ztech eng

To change the water pump you need to remove the serpentine belt, remove the pulley from the water pump, rotate the water pump within the housing and replace it. Reinstall, check for leaks.

Mar 26, 2011 | 2003 Ford Focus

2 Answers

Where is the cam sensor located on a 3,8 eng

it's on the front of the engine, abive the crankshaft pulley

Dec 22, 2010 | 2002 Chevrolet Impala

1 Answer

How to remove a water pump on a 1995 bmw 318is

remove the belt and u can see the water pump pully.
take out the pulley and loose out the surrounding screw of the water pump. clean for the gasket and replace the new one

Dec 30, 2009 | 1996 BMW 318

3 Answers

How to remove water pump from bmw 318 1995. I have all the bolts off and it still won't come off

Tap it lightly with a soft faced mallet to break the seal that it shares with the engine. If this doesn't work, use and inspection mirror to see if you've missed a bolt along the bottom that you could not see.

Jul 06, 2009 | 1995 BMW 3 Series

1 Answer

Removal of water pump

Removing alternator drive belt, refer to Engine.
Release the belt pulley from the water pump.


Drain coolant.
Release water pump.


Insert two M6 screws in water-pump thread and press out water pump evenly from gear case.


Replace sealing ring.

May 25, 2009 | 1996 BMW 318

3 Answers

Bmw 316i overheating

check if the water is circulating as you might have a blockage in the header tank. this can be checked by opening the radiator cap and check if the water is circulating on top.

Apr 22, 2009 | 1996 BMW 318

3 Answers

Water pump

The belt and the water pump pulley, eng must be lifted to get water pump pulley off, after that the R&R is easy.

Oct 29, 2008 | 1997 Lincoln Continental

1 Answer

Water pump

These numbers are in foot pounds water pump attaching bolts=30  water pump pulley attaching bolts=20 fan clutch to fan blade bolts=17 fan assembly to drive hub nut=42 thermostat housing bolts=17

Jul 18, 2008 | 1995 Dodge Ram

Not finding what you are looking for?
1998 Dodge Durango Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides