Question about Chevrolet Chevy

1 Answer

Starter wirring - Chevy Chevrolet Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 22 Answers

The wire from the battery go to the biggest bolt

Posted on Mar 20, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 gmc denali no start. vehicle will not turn over. have checked starter and all fuses and relays


Are you getting power to the starter terminal from the key switch when you turn the key to start ?
Have you tried cranking it in neutral instead of park ?
If the security light goes off it should be working correctly.
You could try a spare key to see if the chip in the key is the problem.

Jan 23, 2013 | Cars & Trucks

1 Answer

Car wont turn over


check and see if you have 12 volt at the purple wir at the starter when the key is turn to start if you dont see why not

Dec 12, 2011 | 1992 Buick LeSabre

1 Answer

What is the VATS system and what is the RED wire for on the fuel pump relay harness? does it need to be plugged in?why is there no current from the ecm on the green wire to the fuel pump relay harness wit...


The Vats system is the cars anti theft security. If the ignition does not read that chip in the key, the starter will not turn over and the injectors might not work. I dont think the Vats is effecting your problem, but here is a link about the security. http://vatspasslockpasskeysecurityhelp.yolasite.com/

May 30, 2011 | 1994 Oldsmobile Cutlass Ciera

2 Answers

1996 jeep cherokee, wont crank in neutral or park. It did it on saturday, then rectified itself. Now its done it again and wont start. All the lights etc work and the fluid levels are fine. Any ideas?


remove switch wir the small one from starter motor when it won't crank and test with a test light to see if it has power when key in crank position if has power starter motor or starter solenoid is bfaulty. if no power could be ignition switch or possably immobilizer fault.

Mar 09, 2011 | 1996 Jeep Cherokee

1 Answer

Comand start remote car starter runs for only 7 minutes,need to program for longer vrun time


Remote starters are a bad thing to have because they can short out your wirring and ruin your starter as well.

Dec 21, 2010 | GMC C1500 Cars & Trucks

1 Answer

How do u get to the bolt behind the wires on the starter


use a 3/8 drice socket set with plenty of long extensions and a wirly thingy (universal) then its quite easy to do

May 27, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

How do you remove the engine starter???


1. Disconnect the cable from negative battery terminal.
2. Raisew vehicle and support it securely on jackstands.
3. If the starter has a heat shield, remove it. Remove the protective plastic cap and disconnect the wirring from terminals on the starter solenoid.
4. Remove the starter motor mounting bolts and detach the starter from the engine.
5. Installation is the reverse of removal.
Tourque teh starter bolts to 18ft-lbs

Feb 20, 2010 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

1987 MUSTANG WIRRING DIAGRAM


I have a manual that has all different wiring diagrams in it for the 87. If you want I can try to find the one that you need and email it to you. If you still need it, just email me at brendanryan51095@hotmail.com and ill send it to you.

Jan 04, 2009 | 1987 Ford Mustang

1 Answer

Starting car


loose ground wir, bad wiring, bad starter cullinoid, a number of things

Sep 22, 2008 | 2001 Dodge Neon

1 Answer

1986 Toyota 4Runner Wire Problem for Starter


Yes the the wirring all mounts on the starter post. you will also have a small gage wire that will connect to the starter silinoide

Sep 10, 2008 | 1986 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...