Question about 2007 Dodge Caliber SXT Sport Hatchback

Open Question

Rear wiper dodge caliber doesn't work motor ok and fuse # 16 ok any other suggestions

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 718 Answers

SOURCE: Rear wiper Ford Explorer 1998 won't work.

Look for the fuse for the rear wiper motor is a 15 amp mini-fuse , in location # 8 of your POWER DISTRIBUTION BOX in the engine compartment. Check in the PD BOX for; - relay # 8 is the rear wiper down relay , and - relay # 10 is the rear wiper up relay .

Posted on May 18, 2009

  • 203 Answers

SOURCE: rear wiper not functioning

it sounds like the motor or the connection to it get somebody to flick the switch while you wiggle the wiper arm dont use too much force if that dosent work its probably the connection block. if this helps please rate my answer. joe

Posted on Nov 21, 2008

  • 840 Answers

SOURCE: Rear Windshield Wiper Problems

Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much

Posted on Jan 31, 2009

  • 75 Answers

SOURCE: rear wiper motor broke

Well you going to have to open the tailgate up and remove the inside cover that is attached to it. You will need a small flat head and a No. 2 star head screw driver and some gloves so that you don't cut your hands....

First where the handle is remove the caps on the handle and then remove the handle there may be a small pocket around the handle to remove it also with the screw driver....And then remove the garnish from around the tailgate by using the small flat head and your fingers to pry it off with....Remember just to take your time when doing this and wear some safety glasses so that nothing goes in your eyes.

Once you have removed the garnish you should see the wiper motor there should be three bolts that hold it in place and wire wire coupler that it hooked up to it. And before you undo the motor you will need to go on the outside of the tail gate you will need to remove the wiper arm off of the motor and then take the rest off after that.

Posted on May 24, 2009

  • 12 Answers

SOURCE: windshield wipers 2008 dodge caliber

Go take it to the dealer you should still have a full warranty. If you want to try and do it your self you could void that warranty.

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My front windshield wipers will only work on high. Any suggestions?


Search Results

    My windshield wipers only work on high speed...? ' Yahoo Answers

    https://answers.yahoo.com/question/index?qid...
    Nov 11, 2006 - My windshield wipers only work on high speed. ... If it's the compound switch on the lever on the steering wheel, it can be a bit complicated to ...

    Windshield wipers - CarGurus

    www.cargurus.com > Questions > Mercury > Grand Marquis

    CarGurusMay 19, 2015 - Windshield wipers - My wipers stopped last week and the next day they ... slow or intermitt and only work on high speed and the washer wiper doesn;twork ... The LCM does not effect the operation of the motor or switch it just ...

    Windshield Wipers only working at highest setting - Ford Flex Forum

    www.fordflex.net > ... > General Ford Flex Discussions
    Feb 16, 2011 - Windshield Wipers only working at highest setting ... rear wiper worksjust fine, just the front wipers only work at highest setting. ... the wipers sometimes grinds out the gears thus only working at high sppeds. If it is the motor or Transmission for the wipers, can I fix this myself and how much would it cost me.

    Common GM Wiper Problem - YouTube

    ? 3:23
    https://www.youtube.com/watch?v=kc6e2Tmar68
    Oct 25, 2010 - Uploaded by roadragecustoms
    The windshield wipers only worked occasionally. ... My 1998 dodge ram wipers only work on high will this help me? thanks.... Express van. you have to take out the motor and the transmission from under the front of the van..

Feb 09, 2016 | Cars & Trucks

1 Answer

Wipers are stuck on the drivers side. When I turn them on they try to move slightly but can't, and won't force down. I'm reading a lot about the motor and fuse box. Any suggestions on where to start?


Doubtful a motor/fuse issue if the wipers try to work. Suspect a seized wiper pivot causing the linkage not to operate. The pivot is what the wiper arm/s attach to. To verify, you need to disconnect the wiper transmission asssembly from the wiper motor and try to manualy move the linkage by hand. In some cases the pivots can be lubricated making them free up and turn again. In most cases the entire linkage will need to be replaced

Jan 04, 2016 | 2007 Dodge Caliber 2.0

1 Answer

Rear wiper doesn't work


check rear wiper fuse and relay.if wiper motor getting power but do not work.rear wiper motor bad.if fuse and relay okay but no power going to rear wiper rear wiper switch could be bad.

May 14, 2013 | 2000 Seat Ibiza

1 Answer

Dodge caliber flooding inside


lol ok where your wiper motor sits water can collect there that whole pan underneath wiper motor could be full of water there is a drain hose for the water could be clogged you will have to take wiper arms off and the plastic screen after that look see if there is debrees look around for drain hole take hose off to drain hole check to see if clogged

Dec 05, 2012 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Rear wiper motor does not work fuse is ok honda crv 2003


About rear wiper, if the fuse is OK, I suggest test the switch, the wires and voltage at/from motor; finally, test motor, possible go to bad.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day

Aug 22, 2012 | 2003 Honda CR-V

1 Answer

1993 vw golf rear wiper doesn t work replaced wiper motor tested motor all ok when on car no good


check the fuse for the rear wiper maybe blew when replacing it if not you have a short also check the rear wiper switch make sure working correctly

Sep 24, 2010 | 1997 Volkswagen Golf

1 Answer

My rear window wiper on my 2007 dodge caliber sxt doesn't work


if you pop the fuse in the cigarette lighter outlet, it also kills power to the computer that controls the rear windsheild wiper.. check that first

Jan 23, 2010 | 2007 Dodge Caliber SXT Sport Hatchback

1 Answer

Dodge Caravan 1990 front Windshield Wipers Don't Turn on.


If the Fuses are good and the Rear Works the Cause will be the Wiper Motor for the Windshield Wipers. Please Rate My Response! Thanks!

Feb 04, 2009 | 1990 Dodge Grand Caravan

Not finding what you are looking for?
2007 Dodge Caliber SXT Sport Hatchback Logo

Related Topics:

1,710 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...