Question about Geo Tracker

1 Answer

Where is the fuel pump relay switch or the fuse to shut off the fuel so I can change the fuel filter?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Geo Master
  • 4,336 Answers

Why not just disconnect the battery negative terminal, and then you can do what you need?

Posted on Mar 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Replaced fuel pump,strainer,fuel filter,battery,computer,car will only start when you pour gas down air intake.


Sorry this vehicle does not have a fuel shut off switch or inertia switch > that's ford ! If you pour fuel in the throttle body an it runs It's something with the fuel system , an if you replaced the pump an filter an regulator , It has to be electrical ! did you check voltage at the fuel pump relay ? What engine does yours have , 2.5 , 3.3 L ? There is a in line fuse for the fuel pump near the relay ! There are four relays front right of engine compartment mounted on radiator support cross member . The one for fuel pump is the one on the inside . Fuse is near there an there is a connector not connected to anything ,this is for fuel pump prime . Jump battery voltage to it a see if it runs then ! or replace relay !

Apr 25, 2015 | 1990 Buick Century

1 Answer

Why does the fuel pump on 1993 ranger not shut off when switch is in on position


The Fuel Pump Relay is located: Under hood, driver side, front side of shock tower, rear of battery, mounted in fuse/relay box

Nov 07, 2014 | Cars & Trucks

1 Answer

1989 f-250 inertia fuel shut-off switch switch location


This should be in the owner's manual. I found the below on autozone.com, their repair help location:
An inertia switch is used as a safety device in the fuel system. The inertia switch is located in the cab, generally under the dashboard on the right side. It is designed to open the fuel pump power circuit in the event of a collision. The switch is reset by pushing each of 2 buttons on the switch simultaneously (some models use switches with only one reset button). The inertia switch should not be reset until the fuel system has been inspected for damage or leaks.
When the ignition switch is ON , it turns the EEC power relay ON . The EEC power relay provides power to the powertrain control module (PCM) and the control side of the fuel pump relay. Power for the fuel pump(s) is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse, current flows through the fuel pump relay and inertia switch to the fuel pump(s). The fuel pump relay is controlled by the PCM.
When the ignition switch is turned ON , the fuel pump(s) will operate. If the ignition switch is not turned to the START position the PCM will shut the fuel pump(s) OFF after 1 second. The PCM will operate the fuel pump(s) operate the fuel pump(s) when the ignition switch is turn to START position to provide fuel while cranking.
After the engine starts, the PCM will continue to operate the fuel pump(s) unless the engine stops, drops below 120 rpm or the inertia switch is tripped.

Dec 28, 2013 | 1989 Ford F 250

2 Answers

2001 ford f-150 no power to fuel pump or safety shut off relays good


You say the fuses and relays are good.
I'm showing three wires for the relay.
One lite blue and orange is battery voltage from the fuse.
The other lite blue and orange is ground from the computer. When the computer grounds the relay voltage should be sent to the inertia switch on the dark green yellow wire.
You should be able to jumper the power and dark green yellow to make the pump run.

Feb 12, 2013 | Cars & Trucks

1 Answer

My 2001 v6 camero aint geting any gas it cranks up i changed the filter im praying its not the pump is there any thing i can check before i try a new pump


First, check for blown fuses. Find the fuel pump relay and swap it with another relay to see if that helps. If it does, replace the bad relay. Most late model cars have a fuel shutoff, or inertia switch that shuts down the fuel pump in an accident. They can be triggered for no reason at all. Check your owners manual to see if it has reset instructions for the fuel shut off. In the meantime I will do some research and see what I Can find and get back to you.

Jan 05, 2011 | 2001 Chevrolet Camaro

2 Answers

My car wont get fuel to the throttle body


Questions for you. Is the fuel pump working? When you turn the key(just not enough to turn the starter), do you hear the fuel pump? Should be like a buzzing noise for about 10 to 15 seconds. When was the last time you changed the fuel filter? They do get clogged and will halt the flow of fuel. That's all I can say with what you typed.

Dec 29, 2010 | 1986 Ford Tempo

1 Answer

Hi , i have a 02 yukon and was driving it and the motor shut down. i can start it right away, but when i press on the gas it shuts off. is this a fuel pump problem or a relay problem?


I WOULD CHECK FUEL PUMP RELAY IF FUEL PUMP KICKS ON AND OFF.BUT IF FUEL FILTER HAS NOT BEEN CHANGED.CHANGE THE FUEL FILTER THE FUSE/RELAY IF ALL IS GOOD I WOULD SCAN VECHICLE FIRST BEFORE BUYING FUEL PUMP.

Nov 26, 2010 | 1993 Mercedes-Benz 190

3 Answers

1986 BMW 318i;Turns over but engine wont run.I'm


Fuel pump may be getting weak. If pressure is not high enough the injectors wont open.

Jun 27, 2009 | 1986 BMW 3 Series

1 Answer

No fuel


You may have put the filter on backwards. If you did I might have ruined the fuel pump. Whether or not you did, test the wires that run to the pump. If they are getting power, you need to replace the pump. If not, start checking fuses and relays.

Dec 14, 2008 | 1992 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...