Question about 1986 Ford EXP

1 Answer

Trying too find 1986 ford exp fuel pump relay

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 335 Answers

Check under the front seats, should be under the drivers seat or passenger seat.

Posted on Mar 21, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why is My 1986 ford f150 starts great in the morning but after hot it's like it's not getting fuel

What have you checked so far ?
Fuel pressure ? Fuel pump relay ? Good spark to plugs ?

Sep 05, 2014 | 1986 Ford F150 SuperCab

1 Answer

Diagram fuel pump and gauges don't work

Try crankshaft positioner. It needs to accurately report rpm to the ecm to kick up fuel pressure. Check Inertia switch for fuel cutoff and reset.

Sep 14, 2013 | 1986 Ford Ranger 2WD

1 Answer

1986 ford f150 tested fuel pump with cables,pump runs no power when hooked to wires going to tank, is it relay

If you have one you should install an inline fuel pressure gauge to verify that you are indeed not getting fuel pressure first. Assuming you have no fuel pressure, it could be one of a few things.
check all of you fuses
if ok, check fuel pump relay for activation during engine cranking. I believe in that vintage Ford, the oil pressure switch is responsible for activating the relay. So with a test light backprobe the activation wire at the relay. if you get activation power at the relay, and no relay activation, then yes it is the relay, but if you get nothing, then it will be the oil pressure switch. If you get activation to relay and still no pump activation then you might have a break in the wiring OR the fuel pump has short brushes.

I know thats alot to take in but hey thats what a diy forum is for right? Good luck!!!

Dec 28, 2012 | 1986 Ford F150 SuperCab

1 Answer

Need to know the wiring color for gas pump for 1986 ford ranger

Hello! Orange/Light Blue wire from Fuel Pump Relay to the Inertia Switch...Other side of Inertia Switch is Pink/Black wire that connects to the Pump...Other side of Pump is Black to chassis ground...



I’m happy to help further over the phone at

Nov 20, 2010 | 1986 Ford Ranger 2WD

1 Answer

My 1986 ranger turns over but won't start, I replaced the main fuel relay and the fuel pump relay, what else could it be?

I would take off the gas cap and listen when you turn the key on. You should hear the pump run for about 5 seconds. If you don't hear it then I am sure that the fuel pump is bad. Very common. But if you hear it. Then you can take some starting fluid and spray a small amount in the air filter. Then try to start it. If it starts, then it is for sure a fuel problem. If it doesn't start then, it is something electrical.

Good Luck! I hope this helps! If so PLEASE vote! Thanks!

Aug 31, 2010 | 1986 Ford Ranger 2WD

1 Answer

Where is the mechanical fuel pump, im not getting any fuel to the carb and have already hit the fuel pump relay under the heater core inside the cab

if the truck has a fuel pump relay, then it's not a mechanical pump it's eletrical. If you're SURE it has a relay, then the ELETRICAL pump is in the fuel tank. If it's mechanical, it will be on the motor, near the belts. Not sure which side on a ford.

Jul 17, 2010 | 1986 Ford F 250

1 Answer

1986 ford 460 fuel relay not allowing pump to run when key is turned on. But you can jumper it and the pump will run?

Either the relay is bad, or you are not getting power to the relay, to energize the relay. Also check the ground.

Mar 16, 2010 | 1986 Ford F 250

2 Answers

1986 f-150 not getting gas

is the fuel pump switch inside the cab tripped or has burned connector?

Sep 02, 2009 | 1986 Ford F150 SuperCab

1 Answer

Cant get power to fuel pump on a 1986 ford van 300 six cylinder

The Fuel Pump Relay Is Mounted Under Hood On Driverside Firewall Right Under The Hood Hinge In A Black Case

Jul 09, 2009 | 1986 Ford F150 SuperCab

3 Answers

1986 BMW 318i;Turns over but engine wont run.I'm

Fuel pump may be getting weak. If pressure is not high enough the injectors wont open.

Jun 27, 2009 | 1986 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides