Question about 2008 Buick Lacrosse

Open Question

How to replace thermostat on a 2008 buick lacrosse cx 3.8L

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 110 Answers

SOURCE: replace thermostat on 2005 buick lacrosse

hello there:
to replace the thermostat you will need to fallow the upper radiator hose back to the intake you should find two bolts holding the thermostat housing remove the bolts and you should find the thermostat under the housing you will need to remove the hose this will help you out and before in stalling clean gasket surface on both sides..... please leave a review thanks sincerely D.Jones

Posted on Jun 05, 2010

olwork
  • 237 Answers

SOURCE: The air conditioning in my 2008 Buick LaCrosse

Need clarification...
Does the compressor run steady, cycle on and off continually or even come on at all? If cycles on-off then attach charge manifold/gauge set and bring freon up to proper level. If does not come on at all, then start engine, turn a/c on, remove two-wire plug from low pressure cut-out switch mounted on accumulator. Jumper the wires at plug and see if compressor comes on. If so, bring freon up to proper level.

If charge level was low then check for system leak after system charge with an electronic leak detector if available.

If compressor runs but doesn't cool vehicle then with engine running and a/c on feel (carefully) the lines. High side line should be hot (be careful) and low side line should be cold. If these are both true then it's possible non-cooling condition is due to air temp diverter door not operating or heater valve not shutting off (if so equipped). If low side not cold it could be a plugged orifice tube. If high side not hot it could be bad rings on compressor. Both conditions can be diagnosed with a/c manifold gauge set by noting the pressures.

For safety... if not familiar with differences between hi and low side components or with charge equipment then please take vehicle to qualified person for service.

Posted on Jun 22, 2009

  • 2 Answers

SOURCE: My 2008 Buick Lacrosse will not start. The

you might try disconecting the battery for 30 seconds and reconnect and try again.sometimes that works if the battery dosent have a shorted cell.

Posted on Sep 15, 2010

Keith100881
  • 74 Answers

SOURCE: remote for buick Lacross doesn't work, battery new. Can't figure how to reset it.

have to be reset by dealer usually 20 to 35 dollars to do so

Posted on May 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08 Buick LaCrosse CX, 3.8L, V6, with 130,000 plus miles. I park in front of my son's residence. when I pit it in gear, it makes a loud thump. Should I fill or change trans fluid/screen?


No that may be a worn axle CV joint or joints doing this, the worn joint allow slack in the system and makes the clunk. Other issues can be delayed transmission engagement due to worn parts in the transmission and also idle speeds that are to high. The last is very unlikely in this year of car.

Apr 07, 2017 | 2008 Buick LaCrosse CX

1 Answer

Need transmission pan bolt pattern for 2008 Buick lacrosse cx v6 3.8 litre


I just snug a couple up on two sides of the pan and go around it until tight. This is not a critical sequence tighening, like doing heads.

Aug 26, 2016 | 2008 Buick LaCrosse CX

3 Answers

One high beam not working 2006 Buick lacrosse


Sampson, sounds like a bunt out bulb, which will need changed.
If you feel comfortable doing it yourself. Basically three screws, and you have to pull one plastic fastener from the fascia (bumper) and pull the bumper back a bit, and pull the assembly out. I believe it is in the manual, not bad to do. I will post a link to tell or show you how to do it. Press the helpful button

Headlight Change 2005 2009 Buick LaCrosse 2006 Buick LaCrosse CX 3 8L V6

2008 Buick LaCrosse Headlight Replacement

Thread how do replace the headlight bulb in 2005 buick lacrosse

Headlight Bulbs

Feb 13, 2016 | Buick Cars & Trucks

2 Answers

My 2008 Buick Lacross is overheating and the engine check light is not on,


First you must check the cooling system out partially clogged radiator,collasped hose (inner) ,cooling fan not coming on ,head gasket leak, thermostat and if all those check out possible a/c causing overheat

May 27, 2014 | 2006 Buick LaCrosse

1 Answer

How do I remove the battey from a Buick LaCrosse?


follow this link as has video of the procedure which is simple but easier to send video than to type the procedure
Battery Replacement 2010 2013 Buick LaCrosse 2011 Buick LaCrosse CX 2...

May 02, 2014 | 2010 Buick LaCrosse CXS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,581 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...