Question about 1987 Ford Crown Victoria

Open Question

1987 ford crown vic. 5.0 where is the fuel pump relay located.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
BPALepine
  • 61 Answers

SOURCE: locate fuel filter on 91 crown vic

The fuel filter is located under the vehicle on the inner side of the left (driver side) frame rail.

Should look like the image below:
a31eb6c.jpg

Posted on Apr 24, 2009

Ad
  • 94 Answers

SOURCE: NO POWER TO FUEL PUMP

then replace relay if there is power to it but none out

Posted on May 25, 2009

  • 1 Answer

SOURCE: Location of fuel pump relay on a 2001 Ford Crown Vic

where is the fuel pump relay on a 2001 crown vic p71

Posted on Apr 14, 2010

  • 5 Answers

SOURCE: 1988 Ford Crown Vic Horn Relay Location

The horn relay IS NOT located in a box toward the front of the engine. It is located just behind the radiator overflow reservoir and attached to the inner fender next to two other relays. It is the only one without a plastic cover over the top of it. FYI, our Crown Vic horn didn't blow, and the cruise didn't work. I changed the relay and still no horn. I decided to check the horns themselves. Found wires disconnected from terminals. Touched wire to horn terminal and horn blew incessantly. (previous owner had disconnected horn rather than diagnose why) Pulled the horn "button" from steering wheel and disconnected the wire leads and horn quit. Disassembled the "button" assembly. Foam had degraded over time between the contacts. (Ford has discontinued this part). Cleaned and replaced foam with Scotch foam mounting squares with holes punched out over contacts (2 layers thick). Re-assembled and viola! Horn and cruise control both work! Relay was bad as was horn button.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel pump relay location


Yes In the trunk of some of the Crown Vics there is a switch next to the air ride control. It is called an Inertia switch and has a reset button. If you do not find this switch in the trunk, you will find it behind one of the kick panels above the front seat floorboard. It will sometimes activate by mistake with an impact.

The fuel pump relay should be in a Relay trio that is piggy-back to the Powerbox under the hood on the driver's side. There are plastic clips on one end which when pressed will allow the Relay trio to slide out of the case and towards the engine.

Oct 22, 2013 | Ford Crown Victoria Cars & Trucks

1 Answer

LOCATION OF THE STARTER MOTOR RELAY AND THE LOCATION OF THE FUEL PUMP RELAY SWITCH ON A 1984 CROWN VIC. IT HAS'NT BEEN STARTED IN A FEW YEARS AND WE ARE TRYING TO TRACE THE PROBLEM


the starter relay is by the battery , follow the positive cable to it. that car should have a FUEL PUMP INERTIA switch. in the trunk, it should be well marked

Sep 01, 2011 | Ford Crown Victoria Cars & Trucks

1 Answer

2004 crown vic two fuel pumps in thirty days


ouch, have power supply tested for proper voltage to pump,also have ground checked. i believe pump is overheating causing failure, Possible causes, 1) insufficiant voltage 2) bad ground causing power surges 3) Inproper ventalation of fuel tank 4) dry run pump (no fuel) 5) faulty pump relays
I hope this gives some insight but we just don't know untill tests have been made

Jan 14, 2011 | 2004 Ford Crown Victoria

1 Answer

1992 ford crown vic working fine, next day no power to fuel pump or cut off switch


  1. Hi Domino, The fuel shut off is powered by the fuel pump relay (which is in the engine compartment fuse block) the fuel pump relay is powered by the EEC power relay(PCM relay) you will have to check for distribution and voltage. I hope this helps!

Aug 31, 2010 | 1992 Ford Crown Victoria

2 Answers

Where is the fuel pump relay located on a 87 crown victoria


It's located in the trunk on the drivers side behind the trunk carpet.

Aug 17, 2010 | 1987 Ford Crown Victoria

3 Answers

1987 crwn vic 5.0 l, 302, Engine runs for 5-10 minutes and shut down. Cranks but will not restart. After 12-24 hrs car will start again and run for 5-10 minutes and process repeats. When the car shuts off...


this is tough, two things I can think of, the first is the coil, if it is not ground good there wont be a good spark or a defective coil,,,, but i am leaning more to it being the timing chain jumped a cog,,, the computer would start the engine advansed but as the engine warmed it would ****** the spark ,,, after 5-10 min. it would quit,, this I would if it si a higher milage car. Tony

Oct 17, 2009 | 1987 Ford Crown Victoria

2 Answers

NO POWER TO FUEL PUMP


relay has power to it from the battery?

May 25, 2009 | 1987 Ford Crown Victoria

3 Answers

2001 crown vic keeps burning 30A PCM relay fuse


have fuel pump checked i have known a bad fuel pump shorting out causing pcm fuse to blow.

May 10, 2009 | 2001 Ford Crown Victoria

2 Answers

Location of fuel pump relay on a 2001 Ford Crown Vic


where is the fuel pump relay on a 2001 crown vic p71

Jan 10, 2009 | 2001 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

168 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...